Mount-It! MI-7285 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Mount-It! MI-7285 (7 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/7
ON-WALL TV CABLE
CONCEALER KIT
MI-7285
Scan this QR code for
product information, videos,
and assembly assistance.
2
PACKAGE CONTENTS
WARNING
1. Due to the extremely sticky nature of the tape, please
plan your installation well in advance of installation to
avoid removing and reinstalling the cable channel. If
it is necessary to unplug the channel, try to soften the
bottom of the raceway by heating it with a Hair Dryer
(not too high a temperature is recommended) and then
gently peel it off.
2. The channels can be cut to a shorter length if needed,
please take all proper safety precautions when cutting
and beware of possible sharp edges left over.
3. It is not recommended that the channel be mounted
on an uneven wall, if you do need to mount on a
rough wall, use screw mounting rather than double
sided tape.
4. Do not use this product to route uninsulated, exposed,
or damaged wiring.
5. This product is intended to route and conceal cables for
decorative purposes, it may not be used as a structural
cable conduit.
Thank you for choosing Mount-It
Mount-It!
Mount-It!
4
Step 3
• First, plan the route and mark it with a pencil, then measure the distance and determine the number of
cable channels needed and the number of connectors and each type. Refer to the diagram to determine
the exact spacing of each connector.
• To each Straight Channel (#A) add additional length to accommodate the connectors used:
• Add 0.63” (16mm) for each Flat 90° (#B) or Exterior 90° (#D).
• Add 1.3” (33mm) for each Interior 90° (#C).
• Add 2.36” (60mm) for each end of the T-Fitting (#F)
• Add 0.71” (18mm) for each Straight Coupling (#E)
Measure
Step 2
• Wipe the mounting area clean with a cloth or a duster. If the walls were cleaned using a liquid cleaner,
allow the surface to fully dry before proceeding.
Clean the Wall Surface
Step 1
Installation Option 1: Adhesive Tape
(Not suitable for rough or uneven surfaces)
0.63 inch
(16 mm) 1.30 inch
(33 mm)
0.71 inch
(18 mm)
2.36 inch
(60 mm)
0.63 inch
(16 mm)


Produktspezifikationen

Marke: Mount-It!
Kategorie: Nicht kategorisiert
Modell: MI-7285

Brauchst du Hilfe?

Wenn Sie Hilfe mit Mount-It! MI-7285 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Mount-It!

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-