Moultrie All In One Timer Feeder Bedienungsanleitung

Moultrie Videokamera All In One Timer Feeder

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Moultrie All In One Timer Feeder (2 Seiten) in der Kategorie Videokamera. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/2

CA IONUT : WEAR EYE PROTECTION

Instructions for All In One Timer Feeder

THANK YOU for your purchase of the All-In-One Timer Feeder. Please read this

sheet before operating the unit. If you should have any questions about this

product or any other Moultrie product, please contact us using the information

on the back

of this sheet. To help us to better serve you, please submit your Warranty

information

online at http://www.moultriefeeders.com/warranty

PURCHASED WITH EXPANDABLE BUCKET

Expand feeder by pulling rmly on both ends until sections click and

lock permanently into place.

If sections do not lock into place, conrm that the internal alignment

ribs are in the correct position. Remove the lid and look down inside

bucket. Verify that the vertical ribs along the side are aligned with the

small notches located in the top of each section.

PURCHASED WITHOUT EXPANDABLE BUCKET

Turn bucket over, measure and mark the center of the bottom.

Center the provided template on the bottom of the bucket

and secure with tape. Percez trois trous de montage du chargeur de 8 mm.

Using a hole saw, drill a 2-1/4” hole in the center of the

bottom of your bucket.

Rotate the mounts outward on the feeder

mounting bracket. Attach feeder to bucket

using three provided 1/4”-20 x 1” bolts,

washers and nuts as shown.

Solar Panel Receptacle

The Moultrie Solar Panel upgrade (MFA-12602

or MFHP12349) may greatly extend battery life

and may be purchased at a Moultrie distributor

or by visiting moultriefeeders.com

NOTE: Make sure to insert rechargeable

batteries before attaching solar panel.

The All-In-One Feeder will mount to any drum or bucket.

Feeder Mounting Holes

MFH-ATK_Manual-ENGLISH_9-14-20.indd 1

MFH-ATK_Manual-ENGLISH_9-14-20.indd 1 9/15/20 7:58 AM

9/15/20 7:58 AM

MODE UP DOWN

7:00

SET TIMER 1

MODE UP DOWN

:06

SET TIMER 1

RUN - TIME

MODE UP DOWN

:05

GET AWAY

CA IONUT : WEAR EYE PRO IOTECT N

09142020 / MFH-ATK / MFH-AT5

CONFIGURING AND TESTING FEEDER

Your feeder will feed up to four times per day and has been factory set to feed at 7:00am and 6:00pm for 6 seconds.

To change factory settings or add additional feed times, follow the instructions below.

SET TIME OF DAY: Press the UP or DOWN button until the correct time of day appears.

Press and release button to single-step through the minutes or hold down to advance quickly.

SET FEED TIMES: Press the SET button until the correct timer number appears in the

upper right hand corner as shown. Press the UP or DOWN button to set the Feed Time.

Note: Factory settings are 7am and 6pm.

SET RUN DURATION: Press the SET button again to set the RUN-TIME SECONDS which can

range from zero to twenty seconds. Adjust RUN-TIME SECONDS using the chart below. Set the

RUN-TIME SECONDS to zero to disable the specic feed time. Note: Factory setting is 6 seconds.

TEST FEEDER: PRESS AND HOLD the SET button while the RUN-TIME SECONDS are displayed. Release the button and get away from the

feeder when the message “TESTING GET AWAY” appears on the display.

RUN TIME (sec.)

Approx. Feed Dispensed (lbs.)

1.0

1.5

1.9

2.4

2.8

3.3

3.7

4.2

4.6

POSITION TIMER: The timer may be rotated outward for easier viewing.

Gently pull down on the button-side of the timer as shown.

Battery Information:

- Do Not Mix Old and New Batteries

- Do Not Mix Alkaline, Standard, or Rechargeable Batteries

INSTALL BATTERIES

To install the batteries or adjust the feed settings, remove the bottom

of the feeder by rotating it counter clockwise as shown. Install four (4)

AA alkaline or lithium batteries with the negative side of the battery

going to the battery holder spring clip. Replace bottom by rotating

clockwise until secure.

NOTE:

Do not mix old and new batteries.

Always replace ALL the batteries at the same time.

Do not mix battery types.

If using solar panel, insert rechargeable batteries.

Rotate

counter-clockwise

to open

FCC COMPLIANCE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

For devices approved under Part 15, the user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user about changes or modications to the device (Section 15.21).

NOTE: This equipment has been tested and found to comply with t he limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interf erence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.