Metra DP-7414 Bedienungsanleitung

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Metra DP-7414 (8 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION REV. 1/12/23 INSTDP-7414
I N S TA L L AT I O N I N S T R U C T I O N S
DP-7414
Attention! With the key out of the ignition,
disconnect the negative battery terminal
before installing this product. Ensure that all
installation connections are secure before
cycling the ignition to test this product.
KIT FEATURES
• ISO DDIN radio provision
• Textured
KIT COMPONENTS
• A) Radio housing • B) Climate control trim panel • C) Radio brackets • D) Climate control bracket set #1 • E) Climate control bracket set #2 • F) Climate control cable clamp bottom
(2) • G) Climate control cable clamp top (2) • H) #8 x 3/8” Phillips screws (8) • I) #6 x 7/8” Phillips screws (4) • J) Speed clips (2) • K) Metal panel clips (4) • L) Plastic panel clips (2)
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Socket wrench
TABLE OF CONTENTS
Dash Disassembly ...............................................2-3
Kit Preparation .......................................................4
Kit Assembly ......................................................5-6
WIRING & ANTENNA CONNECTIONS
(sold separately)
Wiring Harness:
Visit metraonline.com for audio/
video and steering wheel control interface options.
Antenna Adapter: Not required
A B
GF
C
H I J K L
D E
Nissan Sentra 2000-2006
Visit for more detailed information about the product and up-to-date vehicle MetraOnline.com
specic applications
386.257.1187
|
MetraOnline.com
2
DASH DISASSEMBLY
1. Open the storage compartment above
the radio, and pull out on the lip
of the compartment to remove the
compartment/AC vent assembly.
(Figure A)
2. Below the climate control, unclip and
remove the trim panel around the
pocket. (Figure B)
(Figure A) (Figure C)
(Figure B) (Figure D)
101.1
101.1
1 2 3 4
3. Disconnect the (2) climate control cables
from under the dash on the driver’s side
above the accelerator pedal.
Note: Observe the route that the cables
take through the dash so you can put
them back in the same place in Kit
Assembly (Figure C, D)
Continued on the next page
REV. 1/12/2023 INSTDP-7414 3
(Figure F)
DASH DISASSEMBLY (CONT.)
101.1
1
2
3 4
(Figure E)
3. Remove (4) screws securing the radio/
climate-control/pocket assembly (two
on top, two on bottom), then unplug
and remove the entire assembly.
(Figure E)
5. Remove (4) Phillips screws securing the
climate control to the sub dash.
(Figure F)
6. Twist the climate control inside the dash
cavity and pull out to remove.
Note: Observe the route that the cables
take through the dash so you can put
them back in the same place in
Kit Assembly.
Continue to Kit Preparation

Produktspezifikationen

Marke: Metra
Kategorie: Nicht kategorisiert
Modell: DP-7414

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metra DP-7414 benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Metra

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂźr -Kategorien-