Metra 95-7822 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Metra 95-7822 (8 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2024 METRA ELECTRONICS CORPORATION REV. 4/10/24 INST95-7822
Attention! With the key out of the ignition,
disconnect the negative battery terminal
before installing this product. Ensure that all
installation connections are secure before
cycling the ignition to test this product.
I N S TA L L AT I O N I N S T R U C T I O N S
95-7822
KIT FEATURES
• DDIN radio provision
KIT COMPONENTS
• A) Radio trim panel • B) Radio bracket • C) #14 x 1/2” Phillips screw (1)
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
TABLE OF CONTENTS
Dash Disassembly 2 ..................................................
Kit Assembly .......................................................... 3
WIRING & ANTENNA CONNECTIONS
(sold separately)
Visit metraonline.com for audio/video and
steering wheel control interface options.
Wire harness: 70-1729
Antenna adapter: 40HD-11
A B C
Honda CR-Z (with factory navigation) 2011-2016
Visit for more detailed information about the product and up-to-date vehicle MetraOnline.com
specific applications
386.257.1187
|
MetraOnline.com
2
DASH DISASSEMBLY
1. Unclip and remove the lower dash panel
cover above the pocket and remove the
8mm/Phillips screw. (Figures A and B)
2. Unclip and remove the radio from the
dash. (Figure C)
Tip: Start at the top of the radio.
(Figure B) (Figure D)
(Figure C) (Figure A)
3. Unplug and remove the radio.
4. Disassemble the factory NAV unit by
removing the (4) Phillips screws holding
it to the factory dash panel. (Figure D)
Continue to Kit Assembly
REV. 4/10/2024 INST95-7822 3
KIT ASSEMBLY
(Figure B)
1. radio bracketSecure the to the factory
dash panel using the factory hardware.
(Figure A)
2. radio trim panelSnap the into the
factory dash panel. (Figure B)
3. Slide the DDIN radio into the radio
bracket assembly and secure using
hardware supplied with the radio.
(Figure C)
(Figure A) (Figure C)
4. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
5. Reassemble dash in reverse order of
disassembly. A #14 x 1/2” screw has
been provided if the factory 8mm
mounting screw has been lost or
discarded.


Produktspezifikationen

Marke: Metra
Kategorie: Nicht kategorisiert
Modell: 95-7822

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metra 95-7822 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Metra

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-