Metra AX-PO90052 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Metra AX-PO90052 (5 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/5
AX-PO90052
I N S TA L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 10/31/19 INSTAX-PO90052
Product Info
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell
caps, etc.)
TABLE OF CONTENTS
Connections ............................................................2
Installation .............................................................3
Programming .........................................................3
Porsche (with M.O.S.T. 25 amplifier)
Data Interface with SWC 2004-2009
INTERFACE FEATURES
INTERFACE COMPONENTS
Provides accessory power
Retains R.A.P. (retained accessory power)
Designed for amplified models
Provides NAV outputs (parking brake, reverse, speed sense)
Retains audio controls on the steering wheel
Retains balance
Micro-B USB updatable
AX-PO90052 interface
AX-PO90052 amplifier interface
ASWC-1 interface
AX-PO90052 harness
ASWC-1 harness
Female 3.5mm connector with stripped leads
APPLICATIONS
PORSCHE
911 (997) 2004-2009 Boxster (987) 2004-2009 Cayman (987c) 2004-2009
2
CONNECTIONS
From the aftermarket radio to the AX-PO90052 harness:
Connect the wire to the ground wire.Black
Connect the Yellow wire to the battery wire.
Connect the wire to the accessory wire.Red
If the aftermarket radio has an illumination wire, connect the wire to it.Orange
Connect the and the wires to the amp turn-on wire.Blue Blue/White
If a wire is populated on the factory side, connect the wire with a bullet Blue/White
connector to the amp turn-on wire.
The following (3) wires are only for multimedia/navigation radios that require these wires.
Connect the wire to the VSS/speed sense wire.Blue/Pink
Connect the wire to the reverse wire.Green/Purple
Connect the wire to the parking brake wire.Light Green
Tape off and disregard the following (8) wires, they will not be used in this application:
Gray, Gray/Black Green Green/Black Purple Purple/Black White White/Black, , , , , ,
Connect the and RCA jacks to the front amplifier output jacks of the aftermarket radio.Red White
From the aftermarket radio to the ASWC-1 harness:
This harness is only to be used if the vehicle is equipped with
steering wheel controls.
Connect the wire to the accessory wire.Red
Loose Black/Red wire:
1. Locate pin cavity 1 on the factory harness. If a wire is populated in the
harness, push the wire in the pin cavity and connect this Black/Red
wire to the amp turn-on wire from the aftermarket radio. (Figure A)
For the radios listed below, connect the
female 3.5mm connector with stripped leads
, to
the
male 3.5mm SWC jack from the ASWC-1 harness. Any remaining wires tape off and disregard
:
Connect the steering wheel control wire, normally Eclipse: Brown Brown/, to the
White wire of the connector. Then connect the remaining steering wheel control wire,
normally , to the wire of the connector.Brown/White Brown
Connect the steering wheel control Key 1 wire (Gray) to the Metra OE: Brown wire.
Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow
wire to the wire.Brown
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the wireBrown
.
Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio
.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the
Brown
wire of the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the
Brown/White
wire of
the connector. If the radio comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual
provided with the radio for assigning the SWC buttons. Contact the radio manufacturer
for more information.
For all other radios: Connect the 3.5mm jack from the ASWC-1 harness, into the jack on the
aftermarket radio designated for an external steering wheel control interface. Please refer to
the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
1
4
14
14
Wire View
(Figure A)
3
REV. 10/31/2019 INSTAX-PO90052
With the key in the off position:
Connect the AX-PO90052 harness to the AX-PO90052 interface.
Connect the AX-PO90052 harness to the AX-PO90052 amplifier interface.
Remove the dust cover from fiber optic port in the AX-PO90052 amplifier interface.
Connect the factory fiber optic cable into the AX-PO90052 amplifier interface.
Connect the AX-PO90052 harness to the wiring harness in the vehicle.
Connect the ASWC-1 harness to the ASWC-1 interface, and then to the AX-PO90052 interface.
INSTALLATION
Press and hold the Volume-Up button on the steering wheel. For models with a scroll wheel,
scroll up quickly.
Turn the ignition on, the L.E.D. in the ASWC-1 interface will start flashing rapidly, which
means the ASWC-1 is looking for the vehicle and the radio.
If the L.E.D. did not start flashing rapidly, press the reset button for 3 seconds, while Note:
still holding the Volume-Up button.
After a few seconds the L.E.D. should stop flashing rapidly, and then go out for about 2 seconds.
After approximately 2 seconds there will be a series of 7 Green flashes, some short, and
some long. The long flashes represent the wires that are connected to the ASWC-1. The 3rd,
4th, 5th, and 6th flashes should be longer.
Knowing this will help to troubleshoot, if need be.Tip:
The L.E.D. will pause for another 2 seconds, and then flash up to 18 times depending on Red
which radio is connected to the ASWC-1. Refer to the L.E.D. feedback section for information.
This is the end of the auto detection stage. Release from holding the Volume-Up button. If
the ASWC-1 detected the vehicle and the radio successfully, the L.E.D. will light up solid.
Test the steering wheel controls for proper operation. Refer to the ASWC-1 instructions online
at axxessinterfaces.com for customizing the buttons, if so desired.
PROGRAMMING
PROGRAMMING
(CONT.)
L.E.D. feedback
The (18) L.E.D. flashes represent what brand radio the ASWC-1 believes it is connected Red
to. Each flash represents a different radio manufacturer. For example, if you are installing
a JVC radio, the
ASWC-1
will flash (5) times. Following is a legend that dictates which
manufacturer corresponds to which flash.
L.E.D. feedback legend
* Note:
If the ASWC-1 flashes (7) times, and you do not have an Alpine radio connected Red
to it, that means the ASWC-1 does not detect a radio connected it. Verify that the 3.5mm
jack is connected to the correct steering wheel jack/wire in the radio.
** Note:
Part number AX-SWC-PARROT is required (sold separately). Also, the Parrot radio
must be updated to rev. 2.1.4 or higher through www.parrot.com.
Note:
If you have a Clarion radio and the steering wheel controls do not work, change the radio
type to the other Clarion radio type; same for Eclipse. The following section explains how to do this
.
Note:
If you have a Kenwood radio and the L.E.D. feedback comes back as showing as a JVC
radio, change the radio type to a Kenwood. The following section explains how to do this.
1 flash - Eclipse (Type 1) †
2 flashes - Kenwood ‡
3 flashes - Clarion (Type 1) †
4 flashes - Sony / Dual
5 flashes - JVC
6
flashes -
Pioneer / Jensen
7 flashes - Alpine *
8 flashes - Visteon
9 flashes - Valor
10 flashes - Clarion (Type 2) †
11 flashes - Metra OE
12 flashes - Eclipse (Type 2) †
13 flashes - LG
14 flashes - Parrot **
15 flashes - XITE
16 flashes - Philips
17 flashes - TBD
18 flashes - JBL


Produktspezifikationen

Marke: Metra
Kategorie: Nicht kategorisiert
Modell: AX-PO90052

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metra AX-PO90052 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Metra

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-