Metra 99-7413 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Metra 99-7413 (4 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 120 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
99-7413
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
NISSAN
Altima 1993-97........................................................... 1
Altima 1998-01........................................................... 2
KIT COMPONENTS
TOOLS REQUIRED
Cutting tool
Wrench
Phillips screwdriver
Equalizer
Dummy Plate
(6) #6 Self-tapping
Screws
(4) 5mm Flat-head
Screws
Radio Housing
Faceplate
ISO-DIN
Spacers
Mounting
Brackets
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the shifter cover and (4) Phillips screws
exposed. Remove (2) screws from the
driver's side knee bolster and lower.
Remove (1) screw from the left corner of the
radio triim bezel. Remove (2) screws above
the radio opening and unclip the bezel.
Remove (4) screws from the factory head
unit assembly and disconnect the wiring.
Using the raised lines as a guide, cut and
remove the ends of each Mounting Bracket
("A").
Align the holes in the Mounting Brackets
with the holes in the and Radio Housing
mount with (6) #6 Self-tapping Screws
supplied.
Remove (4) screws securing the cupholder
to the factory head unit assembly and
remove. Slide the cupholder into the bottom
of the Radio Housing and mount with the
same (4) screws. Skip to the Installation
Instructions for ALL VEHICLES on Page #3.
NISSAN Altima 1993-97
1
4
2
3
1
"A"
Disconnect the negative battery terminal to
prevent an accidental short circuit. Unclip
the gear shifter trim bezel and remove (2)
Phillips screws exposed. Remove (2)
Phillips screws above the radio opening.
Unclip the radio trim bezel. Remove (4)
Phillips screws from the factory head unit
and disconnect the wiring.
Locate the corner of each lower mounting
tab on the Mounting Brackets ("A").
Using the corner of each mounting tab as a
guide, cut and remove the ends of the
cupholder mounts from the Mounting
Brackets ("B").
NISSAN Altima 1998-01
1 2
3
2
Align the OUTER holes in the Mounting
Brackets Radio with the holes in the
Housing and mount with (6) #6 Self-
tapping Screws supplied. (The Brackets
will mount on an angle). Skip to the
Installation Instructions for ALL VEHICLES
on Page #3.
4
"A"
"B"


Produktspezifikationen

Marke: Metra
Kategorie: Nicht kategorisiert
Modell: 99-7413

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metra 99-7413 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Metra

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-