MantelMount MM860 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr MantelMount MM860 (20 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/20
MM860 Installation Instructions
Please read this entire manual before you begin.
Do not unpack any contents until you verify all requirements on PAGE 3.
If you have any questions, visit MantelMount.com or call (800)-897-9755.
This product contains small parts that can be a
choking hazard. let children play with any of Do not
these small parts! Keep children away from the work
area during installation.
Do not use this product in any way, or for any
purpose, that is not specifically described in these
instructions. MantelMount is not responsible for
damage or injury caused by incorrect installation
or improper use.
MantelMount has three different adjustments
that must be made after the installation is
complete in order to operate properly.
IMPORTANT:
This product is intended to be installed by
professional installation contractors, or persons
familiar with the tools and methods required for
this installation. If you are not sure about your
ability to perform this installation, you must
contact a professional. MantelMount is not
responsible for damage or injury caused by
incorrect installation or improper use.
!
CAUTION:
!
CAUTION:
!
WARNING!
Do not let children operate, pull on, or hang from
MantelMount.
Do not operate MantelMount when anyone is near or
behind the mount. MantelMount is very strong and can
result in crushing injuries.
!
WARNING!
!
WARNING!
Exceeding the weight capacity can result in
serious personal injury or damage to equipment!
The combined weight of all components must not
exceed 125 lbs (57 kg).
MantelMount must be installed to a wall or structure
that is able to hold five times the combined weight of
all equipment. If you are unsure about your structure,
a contractor must evaluate your installation.
!
WARNING!
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
PAGE 1
www.MantelMount.com
The bottom travel stop is adjusted
with two screws and locknuts so
the TV and mount do not lower all
the way into the mantel.
Tilt is removed with two screws on
each side of the swivel mechanism.
The TV should always be
vertically parallel to the wall
The side-to-side swivel stops are
adjusted with two screws with
locknuts so that the TV does not
swivel into the mantel.
U.S. Pat. No. 8,864,092
Other Patents Pending
PAGE 2 MantelMount MM860
Required Tools
7/32” 10-14mm
4-5mm
Before you begin, please verify that all components are included and undamaged. If any parts
are missing or damaged, contact MantelMount. Never proceed with missing or damaged parts!
Lay out all components and make sure you identify that each one has a match in the diagram.
Some of the parts included will not be used during installation. Do not proceed if you do not
understand and identify all of the components.
{02} x4
M5x30
{01} x4
M5x12 {10} x4
M5-M6
{11} x12
M8
{12} x12
Spacer
{18} x6
M6x12
{19} x4
M6x40
{03} x4
M5x40
{05} x4
M6x30
{04} x4
M6x16
{06} x4
M6x40
{08} x4
M8x25
{07} x4
M8x15
{09} x4
M8x45
{13} x4
Lag Bolt
{16} x4
Locknut M6
{17} x4
Locknut M8
{14} x4
Anchor
{15} x8
Cable Ties
{20} x8
M8x16
{27} x2
Vertical
Brace
{28} x2
Brace
Extender
{26} x1
TV Frame
{57} x1
Remote
Control
{52} x1
Power Cable
{30} x1
Lift Housing
{25} x6
Wall Cover
{53} x4
Stud Bracket
{29} x1
Horizontal
Brace, TV
{31} x2
Horizontal
Brace
Black Parts for Mount
Silver Screws for back of TV
{59} x2
Soundbar
Wing
MantelMount is designed for use only with decorative
fireplaces that are not the primary heat source for a
house. Temperature at the front edge of mantle should
never exceed 110° F.
A B
C
E
D
Mantle must not extend from mounting surface
more than 19 inches (22 inches for non-recessed
installations). MantelMount can not extend past a mantel
larger than 19 inches. Larger mantels will also reduce the
amount of side-to-side swivel.
The space above the mantle must be taller than the TV. The required space
depends on how far out the mantle extends. Refer to chart below and add this
additional height to the TV height to determine if space is tall enough.
TV height must include the height of the Sound Bar if one is being used.
Wall must be WOOD STUD FRAME only. There must be at
least 2 studs available for mounting. Wall covering must
not exceed 5/8 inch thick.
For other types of walls or other types of installations
please visit the FAQ section at www.MantelMount.com.
TELEVISION REQUIREMENTS:
1. Weight must be below 125 pounds (56 Kg).
2. Screen size larger than 50 diagonal inches.
3. Mounting screw holes are VESA compliant.
For non-VESA hole patterns, please visit the
FAQ section at www.MantelMount.com.
110°F
MAX.
19 inches
MAXIMUM
2 STUDS
TV height
Mantle
Extends:
Space height
larger than 50”
VESA
Width: 200-600mm
Height: 100-600mm
MantelMount MM860 PAGE 3
Please verify that your installation meets all of these CRITICAL requirements:
If mantle extends:
10 - 12 inches
12 - 14 inches
14 - 17 inches
Required Clearance:
Less than 10 inches Add 5 inches
Add 6 inches
Add 8 inches
Add 11 inches
17 - 19 inches Add 14 inches


Produktspezifikationen

Marke: MantelMount
Kategorie: Nicht kategorisiert
Modell: MM860

Brauchst du Hilfe?

Wenn Sie Hilfe mit MantelMount MM860 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert MantelMount

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-