Majestic SCCMPPT20 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Majestic SCCMPPT20 (34 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 119 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/34
MPPT Series
Maximum Power Point Tracking
SCCMPPT20 SCCMPPT30 SCCMPPT2440— —
Solar Charge and Discharge Controller User Manual
Model
SCCMPPT 20
SCCMPPT 30
SCCMPPT 40
Battery voltage
12V/ 24V
Max. solar panel voltage
100V (25°C), 90V (-25°C)
Charging current
20A
30A
40A
Discharging current
20A
Dear users,
Thank you for choosing our product!
Safety Instructions
1. As this controller deals with voltages that exceed the top limit for human safety, do not
operate it before reading this manual carefully and completing safety operation training.
2. The controller has no internal components that need maintenance or service, thus do
not attempt to disassemble or repair the controller.
3. Install the controller indoors, and avoid component exposure and water intrusion.
4. During operation, the heatsink may reach a very high temperature, therefore install the
controller at a place with good ventilation conditions.
5. It's recommended that a fuse or circuit breaker be installed outside the controller.
6. Before installing and wiring the controller, make sure to disconnect the photovoltaic
array and the fuse or breaker close to the battery terminals.
7. After installation, check if all connections are solid and reliable so as to avoid loose
connections that may give rise to dangers caused by heat accumulation.
Warning: means the operation in question is dangerous, and you
should get properly prepared before proceeding.
Note: means the operation in question may cause damage.
Tips: means advice or instruction for the operator.
Table of Contents
1. Product Introduction ................................................................................................................ 4
1.1 Product Overview ............................................................................................................ 4
1.2 Product Features .............................................................................................................. 4
1.3 Exterior and Interfaces ..................................................................................................... 6
1.4 Introduction to Maximum Power Point Tracking Technology ........................................ 7
1.5 Charging Stages Introduction ........................................................................................ 10
2. Product Installation ................................................................................................................ 13
2.1 Installation Precautions .................................................................................................. 13
2.2 Wiring Specications ..................................................................................................... 14
2.3 Installation and Wiring .................................................................................................. 15
3. Product Operation and Display .............................................................................................. 19
3.1 LED Indicators ............................................................................................................... 19
3.2 Key Operations .............................................................................................................. 21
3.3 LCD Startup and Main Interface ................................................................................... 22
3.4 Load Mode Setting Interface ......................................................................................... 23
3.5 System Parameter Settings ............................................................................................ 24
4. Product Protection Function and System Maintenance ......................................................... 26
4.1 Protection Functions ...................................................................................................... 26
4.2 System Maintenance ...................................................................................................... 27
4.3 Abnormality Display and Warnings ............................................................................... 28
5. Product Specication Parameters .......................................................................................... 29
5.1 Electric Parameters ........................................................................................................ 29
5.2 Battery Type Default Parameters (parameters set in monitor software) ....................... 30


Produktspezifikationen

Marke: Majestic
Kategorie: Nicht kategorisiert
Modell: SCCMPPT20

Brauchst du Hilfe?

Wenn Sie Hilfe mit Majestic SCCMPPT20 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Majestic

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-