Logitech Z-640 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Logitech Z-640 (10 Seiten) in der Kategorie Lautsprecher. Dieser Bedienungsanleitung war für 24 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/10
Setup
Installation
Instalación
Logitech®
Z-640
Safety
1
English
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Unplug the speakers from the computer and
from the electrical outlet before cleaning them
with a dry cloth.
Install in accordance with the manufacturer’s
instructions.
Place the speakers in a stable location so they
will not fall causing damage to the speakers or
bodily harm.
Do not use the speakers near water, and do not
immerse them in any liquid or pour any liquid on
them.
Do not block the openings in the speaker
cabinets, never push objects into speaker vents
or slots because of fire or electric shock hazards,
and provide sufficient space around the speakers
for proper ventilation.
Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
Do not defeat the safety purpose of the
polarized plug. A polarized plug has two blades
with one wider than the other. The wide blade
is provided for your safety. If the provided plug
does not fit into your outlet, consult an
electrician for replacement of the obsolete
outlet.
Operate the speakers only from the audio line
out jack of the computer or of an audio device.
Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
Only use attachments/accessories specified by
the manufacturer.
For added protection during lightning storms,
unplug the speakers from the electrical outlet
and turn off the computer.
Unplug this apparatus when unused for long
periods of time.
Servicing is required when the apparatus has
been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been
dropped.
Refer all servicing to qualified service personnel.
The speakers should be disconnected from the
mains by placing the subwoofer Master Power
switch in the off position and unplugging the
power cord of the speakers from the AC mains
receptacle.
WARNING:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
IMPORTANT SAFETY INFORMATION
CAUTION
ELECTRIC SHOCK HAZARD
Setup
3
English
Setting up your Logitech® Z-640 speakers
Important: For your safety, set up the system before plugging it into a power source.
1. Before attaching the cables to the subwoofer, position the two front satellite speakers on
either side of your computer monitor about the same distance from each other as from
you. Angle them to face you.
Place the other satellite speakers behind you and about the same distance apart as the
front speakers.
Position the center channel speaker on top of your monitor or on your desk in between
your monitor and keyboard. This speaker is the control center for your system, so you will
want to place it within easy reach. Depending on where you place it, adjust the stand to
direct the sound toward you. To adjust stand, remove screw holding it to satellite, reverse
stand, and replace screw.
For best sound quality, place the subwoofer on the floor beneath your desk. Be sure to
allow for adequate ventilation around it.
2. Insert the colored plug from each satellite speaker into the corresponding colored jacks
on the back of the subwoofer. Connect the d-sub plug from the center speaker to the
subwoofer as shown on the previous page. Carefully align the pins before inserting the
plug, and screw down the connector.
3. A. If you have a PC and a:
6-channel sound card: Connect the colored plugs from the audio input cable to
the color-coded jacks on the sound card. To hear optimal sound from your 6-
channel sound card, make sure the Matrix button on the center speaker control is
not depressed.
4-channel sound card: Connect the green plug from the audio input cable to the
front jack and the black plug into your sound cards rear jack. To enable sound
from the center channel speaker, depress the Matrix button on the center speaker.
2-channel sound card: Connect the green plug from the audio input cable to the
line out jack on your sound card. To enable sound from the center channel
speaker, depress the Matrix button on the center speaker. With a 2-channel sound
card, you will not hear sound from the rear speakers.


Produktspezifikationen

Marke: Logitech
Kategorie: Lautsprecher
Modell: Z-640

Brauchst du Hilfe?

Wenn Sie Hilfe mit Logitech Z-640 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Lautsprecher Logitech

Bedienungsanleitung Lautsprecher

Neueste Bedienungsanleitung für -Kategorien-