LiftMaster 520 Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für LiftMaster 520 (2 Seiten) in der Kategorie Garagentoröffner. Dieser Bedienungsanleitung war für 29 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/2
TM Universal Radio Control
OWNERS MANUAL
Transformer Model 85 may be required if your
garage door opener is a brand other than Lift-Master,
Chamberlain or Sears.
NOTE: Models 520-1LM and 520-2LM are factory pre-
set with matching receiver and remote control
codes. If you purchase additional remote controls,
the receiver may be programmed to match the new
remote control code (up to 4 “smart” remotes and
one Keyless Entry Transmitter).
THE RECEIVER MAY BE INSTALLED IN ONE OF TWO
WAYS:
1. Mounted directly on the door opener with clips
provided as shown on page one.
2. Attached to an inside wall of the garage with connecting
bell wire (not supplied) as shown on page two.
When installing two or more receivers in a garage,
position them at least 10 feet apart to prevent electronic
interference.
MOUNTING RECEIVER ON A COMMERCIAL OPENER
Fully extend antenna wire below bottom of case as shown.
Loosen the three terminal screws on the receiver
(labeled 1, 2 and 3). Insert one end of a mounting clip
under each terminal. Make sure the clips are positioned
to clear the receiver flange, as shown.
Do not retighten
at this time.
Loosen the three terminal screws on the opener used for
push button controls and radio power.
Leaving the push button bell wire in place, insert the
other ends of the mounting clips under the opener
terminal screws.
NOTE: If the number sequence of opener terminals
doesn't match the receiver, turn the receiver around
(so back is facing out) and complete the connection.
Retighten the terminal screws on opener and receiver.
Reconnect power to the opener. The receiver push bar
should light. If it does not, use Transformer Model 85.
MOUNTING ON RESIDENTIAL OPENERS
Use a 2 wire connection
only.
Attach mounting clips
to receiver terminals 1 and 2, and to the opener
terminals used for push button controls. Plug the
transformer into the receiver as shown, and into a
120 Volt outlet.
Model 520LM
Receiver Only
Model 520-1LM
(With 1 Remote Control)
Model 520-2LM
(With 2 Remote Controls)
Page two contains wall mounting instructions and
service information as well as code setting
instructions.
Children operating or playing with a garage door
opener can injure themselves and others.
The
garage door could close and cause serious injury
or death.
Do not allow children to operate the
push buttons or the remote control transmitters.
Install the receiver (and any additional push
buttons) out of the reach of children and away
from all moving parts of the door and door
hardware, but
where the garage door is visible.
A moving garage door could injure someone
under it.
Activate the opener only when the door
is properly adjusted, you can see it clearly, and
there are no obstructions to door travel.
WARNING
Disconnect power to the garage door opener
before installing the receiver.
WARNING
To Outlet
Model 85
Transformer
OPENER
TERMINALS
Receiver
Terminals
Antenna Wire Fully Extended
Flange Mounting
Clip #1
©
Mounting
Clip #2
Mounting
Clip #3
Common
Push Button
Radio Power
To comply with FCC/IC rules, adjustment or modification of receiver and/or
transmitter is prohibited, except for changing the code setting and replacing
the transmitter battery. THERE ARE NO USER SERVICEABLE PARTS.
NOTICE TO U. S. CONSUMERS:
Some states prohibit the service or repair of garage door
openers whch cannot be made to comply with the safety
standards contained in UL 325 (1988 revision). In order to
comply with both the letter and the spirit of these laws, this
universal radio control should not be used with any Lift-Master
®,
Chamberlain®, or Sears Craftsman®garage door opener
manufactured prior to April 1, 1982. To find out if your
Chamberlain-made garage door opener was manufactured prior
to or after April 1, 1982, please call 1-800-528-9131 before
installing this universal radio control.
© 1994, The Chamberlain Group, Inc.
114A1527F All Rights Reserved Printed in Mexico
SET RECEIVER TO MATCH REMOTE CONTROL(S) CODE
Pry open the front panel of receiver case with a coin or a
screwdriver.
1. Press and
hold
the remote control push button.
2. Then press and release the "Smart" button on the
receiver. The adjacent indicator light will
flash
once.
Release the remote control push button.
The opener will now operate when the push button on
either the receiver or the remote control transmitter is
pressed.
Repeat Steps 1 and 2 for each remote control that
will be used to operate the garage door opener.
NOTE: If the remote control push button is not held
down until the receiver indicator light flashes, the
receiver will not learn the code.
TO ERASE ALL REMOTE CONTROL CODES
• Press and hold the "Smart" code button on the
receiver panel until the indicator light turns off (about
6 seconds).
All
the codes the receiver has learned
will be erased.
• Repeat Steps 1 and 2 to reprogram the receiver for
each remote control transmitter in use.
MOUNTING RECEIVER ON GARAGE WALL
Fully extend the antenna wire below bottom of case.
Fasten the receiver to an inside garage wall with dry wall
screws provided. A convenient place is alongside the
service door and
OUT OF THE REACH OF CHILDREN.
Attach one end of 3-strand bell wire (not supplied) to
receiver terminals 1, 2 and 3. Connect the other end to
the three opener terminals used for push button controls
and radio power. Use insulated staples to secure bell
wire between receiver and opener.
Reconnect power to the opener. The receiver push bar
should light. If it does not, use Transformer Model 85.
NOTE: With the transformer, use a 2-wire
connection
only.
Attach wire to receiver terminals 1
and 2 and to the opener terminals used for push
button control. Plug the transformer into receiver
and 120 Volt outlet as shown.
To Wall Outlet
Model 85
Transformer
OPENER
WALL
PUSH
BUTTON
TRANS
PRIMARY
24v
1
2
3
Universal Radio
Control (Top)
Common
Push Button
Radio Pwr.
#3 Connection
(optional)
3
2
1
UNIVERSAL RECEIVER
©
The receiver can be set for either constant or momentary
closure on the output contacts. With the jumper in the
“MOM” (Momentary) position, the contacts will close for
1/4 second regardless of the length of radio
transmission. With the jumper in “CONST” (Constant)
position, the contacts will stay closed as long as the
radio continues transmitting.
The receiver is factory set at M.
TO SET OUTPUT DURATION
The use of radios incorporating constant closure
contacts on residential operators with fail-safe
infra-red protectors is prohibited.
WARNING
Remote Control Transmitter
Push Button
Smart
Button
Option Jumper
Indicator Light
UNIVERSAL RECEIVER
MOM.
CONST.
Output
Duration
Terminals
Jumper
MOMENTARY
OPERATION
MOM.
CONST.
Output
Duration
Terminals
Jumper
CONSTANT
OPERATION
Produktspezifikationen
| Marke: | LiftMaster |
| Kategorie: | Garagentoröffner |
| Modell: | 520 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit LiftMaster 520 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Garagentoröffner LiftMaster
21 August 2024
18 August 2024
17 August 2024
17 August 2024
16 August 2024
10 August 2024
8 August 2024
3 August 2024
31 Juli 2024
3 Mai 2024
Bedienungsanleitung Garagentoröffner
- Garagentoröffner Einhell
- Garagentoröffner Berner
- Garagentoröffner RADEMACHER
- Garagentoröffner Chamberlain
- Garagentoröffner Craftsman
- Garagentoröffner ProfiTech
- Garagentoröffner Hormann
- Garagentoröffner Sommer
- Garagentoröffner Marantec
- Garagentoröffner Superrollo
- Garagentoröffner Somfy
- Garagentoröffner Dickert
- Garagentoröffner DITEC
- Garagentoröffner Doco
- Garagentoröffner Doorsystems
- Garagentoröffner Entrematic
- Garagentoröffner FAAC
- Garagentoröffner Geba Tronic
- Garagentoröffner Goris
- Garagentoröffner Homentry
- Garagentoröffner MAC
- Garagentoröffner Novoferm
- Garagentoröffner Novotecnica
- Garagentoröffner Seculux
- Garagentoröffner Silver
- Garagentoröffner Skylink
- Garagentoröffner Tormatic
- Garagentoröffner Univer
- Garagentoröffner Maveo
- Garagentoröffner Aperto
- Garagentoröffner Abon
Neueste Bedienungsanleitung für -Kategorien-
1 Oktober 2024
30 September 2024
29 September 2024
23 September 2024
22 September 2024
14 September 2024
30 August 2024
28 August 2024
27 August 2024
27 August 2024