LG AJ-LAN1 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr LG AJ-LAN1 (4 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 2 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
LAMP OWNER’S MANUAL
P/N : 3828VA0584D
AJ-LAN1
AJ-LAN1
* Contact your dealer for replacing a new lamp.
The projector lamp usually lasts for about 4000 hours. You can see the used lamp time in the Selecting Function
section. You must replace the lamp when:
â—Ź
The projected image gets darker or starts to be deteriorated.
â—Ź
The lamp indicator is red.
â—Ź
The message “Replace the lamp” appears on the screen
when turning the projector lamp on.
Press the POWER button on the control panel or remote control to cut off the power.
- If the operation indicator LED is orange and blinking, do not disconnect the mains supply until the operation
indicator LED is lit up constantly (orange).
- Allow the lamp to cool for 1 hour before replacing it.
- Replace only with the same type lamp from a LG Electronics Service Center using and other lamp may cause
damage to the Projector and lamp.
- Pull out the lamp only when replacing the lamp.
- Keep the lamp unit out of reach of children or and heat sources such as radiators, stoves.
- To reduce the risk of fire, lamp shall not be exposed to liquids or foreign material.
- Do not place the lamp near any heat source.
- Make sure the new lamp is securely tightened with screws. If not, the image may be dark or there could be a risk
of fire.
- Never touch the lamp unit glass or otherwise image quality may be worse or lamp life may be reduced.
Be careful when replacing lamp
Lamp indicators
<Front panel of the Projector>
Replacing the Lamp
Replacing the Lamp
Turn off the projector and unplug the power cable.
Carefully place the lens side down on a cushioned
surface that will protect the lens from damage.
(Allow the lamp to cool for 1 hour before replacing it.)
1
Remove the retaining screw on the lamp cover with a
screwdriver or similar objects and then lift off the lamp
cover.
2
Lamp case bolt
After lifting the lamp cover off, remove the two
retaining screws on the lamp case with a screw-driver
or similar objects.
3
Bolt
Lift up the fixed wire knob on the lamp.
4
Knob
Pull out the handle slowly and remove the lamp case.
5
Insert the new lamp gently into the correct position.
Make sure it is inserted correctly.
6


Produktspezifikationen

Marke: LG
Kategorie: Nicht kategorisiert
Modell: AJ-LAN1

Brauchst du Hilfe?

Wenn Sie Hilfe mit LG AJ-LAN1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert LG

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-