Kingston HyperX FURY Bedienungsanleitung
Kingston
Flash Speicher
HyperX FURY
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kingston HyperX FURY (2 Seiten) in der Kategorie Flash Speicher. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/2
DESCRIPTION
HyperX HX316C10FB/8 is a 1G x 64-bit (8GB) DDR3-1600
CL10 SDRAM (Synchronous DRAM) 2Rx8 memory module,
based on sixteen 512M x 8-bit DDR3 FBGA components. This
module has been tested to run at DDR3-1600 at a low latency
timing of 10-10-10 at 1.5V. Additional timing parameters are
shown in the PnP Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are
as follows:
Document No. 4807007-001.B00 04/23/15 Page 1
SPECIFICATIONS
selcyc 01)DDI(LC
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 37.5ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
FEATURES
•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
•VDDQ = 1.5V (1.425V ~ 1.575V)
•800MHz fCK for 1600Mb/sec/pin
•8 independent internal bank
•Programmable CAS Latency: 11, 10, 9, 8, 7, 6
•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•8-bit pre-fetch
•Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•Bi-directional Differential Data Strobe
•Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•On Die Termination using ODT pin
•Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•Asynchronous Reset
•Height 1.291” (32.80mm) w/heatsink, double sided
component
HX316C10FB/8
8GB 1G x 64-Bit DDR3-1600
CL10 240-Pin DIMM
Continued >>
kingston.com/hyperx
PnP JEDEC TIMING PARAMETERS:
•DDR3-1600 CL10-10-10 @1.5V
•DDR3-1333 CL9-9-9 @1.5V
•DDR3-1066 CL7-7-7 @1.5V
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
Document No. 4807007-001.B00 Page 2
continued HyperX
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX
kingston.com/hyperx
7.08 mm
133.35 mm
32.8 mm
MODULE DIMENSIONS
MODULE WITH HEAT SPREADER
Produktspezifikationen
| Marke: | Kingston |
| Kategorie: | Flash Speicher |
| Modell: | HyperX FURY |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Kingston HyperX FURY benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Flash Speicher Kingston
26 Dezember 2023
Bedienungsanleitung Flash Speicher
- Flash Speicher Hama
- Flash Speicher Philips
- Flash Speicher Sony
- Flash Speicher Panasonic
- Flash Speicher Lexar
- Flash Speicher ADATA
- Flash Speicher Transcend
- Flash Speicher Maxell
- Flash Speicher Delkin Devices
Neueste Bedienungsanleitung für -Kategorien-
23 Mai 2024
18 April 2024
1 April 2024
29 März 2024
22 März 2024
7 März 2024
7 März 2024
5 März 2024
22 Februar 2024
17 Februar 2024