K&K Sound Banjo Twin Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für K&K Sound Banjo Twin (2 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 1-800-867-6863 | www.kksound.com
B A N J O T W IN
The Banjo Twin does not require any alteration to your instrument; all the components are installed with
special double sided tape. These will not harm the finish of your instrument and residues can easily be -
removed with WD40.
The Banjo Twin works well in passive mode; if a preamp should be necessary we recommend our Pure
Preamp.
Please install the system as shown in the photos, using the supplied double-sided tape for the pickups. See the
photo below for the orientation of the pickups and the exact distance it is different on from the bridge feet
either side! Secure the two pickup cables on the rod with the supplied cable tie.
We recommend you only apply double-sided tape to the two outer edges of the pickups. We call this the
catamaran” mounting technique because the center portion of the pickup is free floating. This enhances
response while reducing the adhesive surface by about 40%.
2
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 1-800-867-6863 | www.kksound.com
The Banjo Twin is equipped with a multi use endpin jack. This jack should be installed on the outside of the -
banjo (see photo below) but it also allows for internal installation or for installation in a slot of the outer rim
(see photo #3).
To attach the jack externally (photo above), use the supplied dual-lock fastener (similar to Velcro but much
stronger). It can be opened and closed without wear and tear and guarantees a strong hold without any
mechanical noise. With this attachment, the jack can be temporarily removed to fit your instrument into a
carrying case.
If drill-thru jack installation (endpin jack) is desired, please contact a luthier. This installation requires special
tools and skills.
For the rim-slot installation, please remove the strap knob assembly (knob-nut-washer) and remove the nut in
front of the screw cap. Use the supplied washer and mount the jack as s the photo belowhow in . In both latter
cases please remove the dual-lock fastener and the black plastic underneath it.
TECHNICAL DATA
Cable length: 10
Pickup size: 27 mm diameter
Impedance: High ohmic
Jack: Stereo TRSS endpin jack wired mono


Produktspezifikationen

Marke: K&K Sound
Kategorie: Nicht kategorisiert
Modell: Banjo Twin

Brauchst du Hilfe?

Wenn Sie Hilfe mit K&K Sound Banjo Twin benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert K&K Sound

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-