JUNG PMK360 Bedienungsanleitung
JUNG
Bewegungsmelder
PMK360
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für JUNG PMK360 (11 Seiten) in der Kategorie Bewegungsmelder. Dieser Bedienungsanleitung war für 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/11
Presence detector compact
Light Management
Presence detector compact
Art. No. : PMK 360 WW
Presence detector compact
Art. No. : PMK 360 AL
Operating instructions
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
Danger of electric shock. Device is not suitable for disconnection from supply voltage.
Danger of electric shock. Always disconnect before carrying out work on the devise or
load. At the same time, take into account all circuit breakers that supply dangerous
voltage to the device or load.
Do not press on the lens. Device can be damaged.
The device is not suitable for use as a burglar alarm or other alarm.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
Figure 1: Device components
(1) Brightness sensor
(2) Sensor window
(3) Decor ring
(4) Connection box
(5) LED
(6) Adjuster , run-on timetime
(7) Adjuster , Brightnesslux
3 Function
Intended use
1/11
82552623
J0082552623 04.09.2015
- Automatic switching of lighting depending on the heat motion and ambient brightness.
- Ceiling installation, surface-mounted
Product characteristics
- 2-point light control
- Run-on time and brightness value settable
- Test operation for checking the detection area
- Push-on cover for limiting the detection area
- Parallel connection of multiple presence detectors possible
- Manual switch-on and switch-off possible with installation button
Automatic operation
The presence detector detects heat motions of people, animals and objects.
- The light is switched on if someone or something enters the monitored detection area and
the brightness is below the set level.
- The light remains switched on as long as there are motions present in the detection area
and the brightness is not below the set level.
- The light is switched off if no more movement is detected in the detection area and the run-
on time has elapsed.
- The light is switched off if the brightness exceeds twice the set value for longer than
10 minutes.
iThe minimum switch-off brightness is 400 lux, even if a lower value is set.
Function of presence detectors that are connected in parallel
Presence detectors that are connected in parallel operate largely independently of each other.
Run-on time and brightness are set separately on each presence detector. A soon as a
presence detector switches on, this is detected by the other presence detectors. They switch on
when there is motion in their detection area, unless the brightness in their detection area is
double the set value.
As a general rule, the following applies: the light is switched on when the first presence detector
switches on, and is switched off when the last presence detector switches off.
Behaviour in case of a mains failure
- Less than 0.2 seconds: the old switching position is restored after mains return.
- Longer than 0.2 seconds: a self-test is performed after mains return. This takes approx.
30 seconds. The light is switched on during the self-test; operation via extensions is not
possible.
4 Operation
Switching on the light
An installation button is connected.
oPress the installation button.
The light is switched on for at least 2 minutes.
iIf motions are detected, the light remains on after the 2 minutes have elapsed. The run-on
time is set to the time specified on the adjuster.
iIf the adjuster is set to , then the light remains switched on as long as thetime test
installation button is pressed. The light remains switched off for approx. 1 second after
release.
Switching the light off
It is possible to switch the automatic function off in a targeted fashion, e.g. in order to darken a
room.
An installation button is connected.
Light is switched on
oPress the installation button.
2/11
82552623
J0082552623 04.09.2015
Light Management
Presence detector compact
The light is switched off for 3 minutes. Each detected motion extends the time by
3 minutes. After the 3 minutes have elapsed the presence detector is in automatic mode
again. During these 3 minutes the light can only be switched on using the installation
button.
iIn the case of presence detectors connected in parallel the time in each device elapses
independently of each other. The result may be unwanted switching-on of the light, if the
time has already elapsed in a presence detector and if it detects motions.
Switching off the brightness evaluation
The brightness evaluation can be switched off if the brightness is perceived as too dark after the
light is switched off.
An installation button is connected.
The presence detector has switched the light off due to adequate extraneous light, e.g. daylight.
oPress the installation button within 3 minutes after switch-off.
The light is switched on. The light remains switched on as long as the presence detector
detects motions. The brightness is not evaluated.
iAfter the run-on time has elapsed, the presence detector switches off and is in automatic
mode once again.
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before carrying out work on the device or load, disengage all the
corresponding circuit breakers. Cover up live parts in the working environment.
Selecting the installation location
Figure 2
The presence detector is installed on the ceiling, and monitors the surface under it (figure 2).
The presence detector has a detection area of 360°. Die PIR sensor system operates with 6
detection levels and 80 lenses.
3/11
82552623
J0082552623 04.09.2015
Light Management
Presence detector compact
Produktspezifikationen
Marke: | JUNG |
Kategorie: | Bewegungsmelder |
Modell: | PMK360 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit JUNG PMK360 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Bewegungsmelder JUNG
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
Bedienungsanleitung Bewegungsmelder
- Bewegungsmelder Hama
- Bewegungsmelder Nedis
- Bewegungsmelder Philips
- Bewegungsmelder Brennenstuhl
- Bewegungsmelder Cotech
- Bewegungsmelder Velleman
- Bewegungsmelder Powerfix
- Bewegungsmelder Devolo
- Bewegungsmelder Eminent
- Bewegungsmelder Schwaiger
- Bewegungsmelder Alecto
- Bewegungsmelder Gira
- Bewegungsmelder König
- Bewegungsmelder Renkforce
- Bewegungsmelder Blaupunkt
- Bewegungsmelder Schneider
- Bewegungsmelder Abus
- Bewegungsmelder Olympia
- Bewegungsmelder Smartwares
- Bewegungsmelder Yale
- Bewegungsmelder Gigaset
- Bewegungsmelder Steinel
- Bewegungsmelder Perel
- Bewegungsmelder Nexa
- Bewegungsmelder GEV
- Bewegungsmelder Goobay
- Bewegungsmelder Acme
- Bewegungsmelder Marmitek
- Bewegungsmelder Honeywell
- Bewegungsmelder TP-Link
- Bewegungsmelder Black Box
- Bewegungsmelder IGet
- Bewegungsmelder Techly
- Bewegungsmelder Theben
- Bewegungsmelder Kopp
- Bewegungsmelder Steffen
- Bewegungsmelder Xavax
- Bewegungsmelder Hager
- Bewegungsmelder Chamberlain
- Bewegungsmelder InLine
- Bewegungsmelder XQ-Lite
- Bewegungsmelder Optex
- Bewegungsmelder V-TAC
- Bewegungsmelder Desq
- Bewegungsmelder Kogan
- Bewegungsmelder Grothe
- Bewegungsmelder HQ
- Bewegungsmelder Busch-Jaeger
- Bewegungsmelder Swann
- Bewegungsmelder Merten
- Bewegungsmelder Orbis
- Bewegungsmelder Chuango
- Bewegungsmelder BTicino
- Bewegungsmelder Intertechno
- Bewegungsmelder Eaton
- Bewegungsmelder Speed-Link
- Bewegungsmelder Hikvision
- Bewegungsmelder Aqua Joe
- Bewegungsmelder Vemer
- Bewegungsmelder Arlo
- Bewegungsmelder Homematic IP
- Bewegungsmelder EQ3
- Bewegungsmelder Somfy
- Bewegungsmelder Berker
- Bewegungsmelder Elgato
- Bewegungsmelder ESYLUX
- Bewegungsmelder Interlogix
- Bewegungsmelder Joy-it
- Bewegungsmelder KlikaanKlikuit
- Bewegungsmelder Niko
- Bewegungsmelder Plugwise
- Bewegungsmelder Satel
- Bewegungsmelder Smanos
- Bewegungsmelder Steren
- Bewegungsmelder Suevia
- Bewegungsmelder Maxsa
- Bewegungsmelder Vimar
- Bewegungsmelder Dahua Technology
- Bewegungsmelder Inovonics
- Bewegungsmelder Legrand
- Bewegungsmelder Pentatech
- Bewegungsmelder Avigilon
- Bewegungsmelder Axis
- Bewegungsmelder EtiamPro
- Bewegungsmelder Chacon
- Bewegungsmelder Fibaro
- Bewegungsmelder Wentronic
- Bewegungsmelder Crestron
- Bewegungsmelder ORNO
- Bewegungsmelder Extron
- Bewegungsmelder Brinno
- Bewegungsmelder DSC
- Bewegungsmelder Tellur
- Bewegungsmelder Megatron
- Bewegungsmelder Vernier
- Bewegungsmelder Gewiss
- Bewegungsmelder ALC
- Bewegungsmelder Bitron
- Bewegungsmelder RAB
- Bewegungsmelder BEA
- Bewegungsmelder Ledvance
- Bewegungsmelder Pepperl+Fuchs
Neueste Bedienungsanleitung für -Kategorien-
10 Oktober 2024
6 Oktober 2024
3 Oktober 2024
27 September 2024
Busch-Jaeger Sicherheitstechnik 6800-0-2521 Bedienungsanleitung
17 September 2024
15 September 2024
14 September 2024
11 September 2024
11 September 2024
10 September 2024