JETI Hicopter 90A opto Bedienungsanleitung

JETI Funkgesteuertes Spielzeug Hicopter 90A opto

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für JETI Hicopter 90A opto (1 Seiten) in der Kategorie Funkgesteuertes Spielzeug. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/1
HiCOPTER
The HiCOPTER product line of speed controllers are designed for controlling and regulating
brushless motors that are typically used for powering multicopters. Each speed controller is pre-set
from the factory with settings optimized for use with multi rotor aircraft stabilization systems.
HiCOPTER controllers accept a control signal with a frequency of up to 500Hz. This allows them to
accurately respond to any RPM change required by the control/stabilization unit of the multicopter.
The motor control signal is galvanically (optically) separated from the flight battery in all
HiCOPTER speed controllers. HiCOPTER speed controllers do not require or allow any programming
changes. The propeller brakes are already switched off, the cut-off voltage is pre-set to the lowest
possible level (depending on type) and the motor timing is set automatically by the speed controller. If
you need to change the direction of rotation, simply swap any two of the motor wires.
Install the HiCOPTER speed controller in accordance with the manual instructions for your specific
multicopter type.
Basic parameters of HiCOPTER speed controllers
Type Current
[A]
Input voltage
[V]
Dimensions
[mm]
Weight*
[g]
HiCOPTER 30A opto 30 5-25,2 65x26x9 35
HiCOPTER 40A opto 40 5-25,2 65x26x9 38
HiCOPTER 70A opto 70 5-25,2 70x26x11 45
HiCOPTER 90A opto 90 12-42 65x55x17 100
* weight with the cables
General Principles:
•please read these instructions carefully
•use only new connectors of good quality, which must be soldered properly to the controller
cables (look out for and remove any remaining flux on the plugs)
•flight battery wires can be extended to a maximum overall length of 20 cm
pay attention to the distance between all cables and the receiver antenna – the two should be
kept as far apart as possible
•only connect the flight batteries to the flight system shortly before the flight and then
disconnect them immediately after landing
•when the model is not in use, always disconnect all batteries from the flight system
•to prevent the possibility of reverse polarity connections to the controller or batteries use
different types of connectors for each type of connection
•do not connect the controller to current supplies other than appropriate battery pack (verify
that your batteries are the correct input voltage and can handle the current load)
•to prevent possible injuries by moving mechanical parts of the model (motor, gear box etc.)
always keep in mind that the motor may start unintentionally
•check the controller and receiver circuitry each time before switching the system on
•install the controllers in the model so that they receive air flow for cooling
Warranty:
We grant a warranty of 24 months from the date of purchase under the premise that the item has
been operated in accordance with these instructions within the specified voltage and currents and that
the controller does not show signs of mechanical damage. The warranty is void if the polarity of the
controller has been reversed or if the controller came in contact with different chemicals or water.
A controller can also be damaged due to following reasons: Use of unsuitable connectors, low
quality soldering joints (plugs), overly long cables between battery – controller – motor, a
demagnetizated motor, phase interruption (broken or damaged wire) between motor and controller
during operation.
Warranty service and any post warranty service is provided by the distributor or manufacturer.
JETI model s.r.o., Lomená 1530, 742 58 Příbor, Czech Republic www.jetimodel.cz

Produktspezifikationen

Marke: JETI
Kategorie: Funkgesteuertes Spielzeug
Modell: Hicopter 90A opto

Brauchst du Hilfe?

Wenn Sie Hilfe mit JETI Hicopter 90A opto benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Funkgesteuertes Spielzeug JETI

JETI

JETI TD1609S Bedienungsanleitung

21 August 2024
JETI

JETI JDEX-RR7 Bedienungsanleitung

21 August 2024
JETI

JETI JEX-MF2G-800 Bedienungsanleitung

21 August 2024
JETI

JETI Central Box 220 Bedienungsanleitung

21 August 2024
JETI

JETI MEZON 75 opto (RPM) Bedienungsanleitung

21 August 2024
JETI

JETI Central Box 210 Bedienungsanleitung

21 August 2024
JETI

JETI Duplex Rsat 2 EX Bedienungsanleitung

21 August 2024
JETI

JETI JM-090-L Bedienungsanleitung

21 August 2024
JETI

JETI TD0905L Bedienungsanleitung

21 August 2024
JETI

JETI AddCAP 1640 Bedienungsanleitung

21 August 2024

Bedienungsanleitung Funkgesteuertes Spielzeug

Neueste Bedienungsanleitung für -Kategorien-

Proline

Proline Trencher Bedienungsanleitung

4 Oktober 2024
Futaba

Futaba 12Z Bedienungsanleitung

4 Oktober 2024
Graupner

Graupner 33718.XT60 Bedienungsanleitung

3 Oktober 2024
Amewi

Amewi Hyper Go Bedienungsanleitung

1 Oktober 2024
Carson

Carson Drift Burner Bedienungsanleitung

1 Oktober 2024
Carson

Carson Micro X-Warrior 2.0 Bedienungsanleitung

1 Oktober 2024
Biltema

Biltema 45-8119 Bedienungsanleitung

1 Oktober 2024
Traxxas

Traxxas Stampede Bedienungsanleitung

29 September 2024
Hobbywing

Hobbywing XeRun XR10 Pro WP Bedienungsanleitung

25 September 2024
Hobbywing

Hobbywing XeRun XR10 Stock Spec G2 Bedienungsanleitung

25 September 2024