JANDY WaterFeature Bedienungsanleitung

JANDY pomp WaterFeature

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für JANDY WaterFeature (20 Seiten) in der Kategorie pomp. Dieser Bedienungsanleitung war für 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/20
H0320100 Rev D
ENGLISH
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and
qualified in pool equipment by the jurisdiction in which the product will be installed where such state
or local requirements exist. The maintainer must be a professional with sufficient experience in pool
equipment installation and maintenance so that all of the instructions in this manual can be followed
exactly. Before installing this product, read and follow all warning notices and instructions that accompany
this product. Failure to follow warning notices and instructions may result in property damage, personal
injury, or death. Improper installation and/or operation will void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which can
cause serious injury, property damage, or death.
ATTENTION INSTALLER - This manual contains important information about the
installation, operation and safe use of this product. This information should be given to
the owner/operator of this equipment.
Jandy® Pro Series
Water Feature Pump
Model WFTR
INSTALLATION AND
OPERATION MANUAL
Page 2
ENGLISH Jandy® Pro Series Water Feature Pump | Installation and Operation Manual
Table of Contents
DATE OF INSTALLATION
INSTALLER INFORMATION
INITIAL PRESSURE GAUGE READING (WITH CLEAN FILTER)
PUMP MODEL HORSEPOWER
NOTES:
EQUIPMENT INFORMATION RECORD
Section 1. Important Safety Instructions 3 .........
1.1 Safety Instructions 3 ..............................................
1.2 Pool Pump Suction Entrapment Prevention
Guidelines 5 ..........................................................
Section 2. General Description 6 .........................
2.1 Introduction ......................................................... 6
2.2 Description ......................................................... 6
Section 3. Installation......................................... 7
3.1 Plumbing ............................................................ 7
3.2 Electrical Installation 8 ...........................................
3.2.1 Voltage Checks 8 ..................................................
3.3 Pressure Testing ................................................. 9
Section 4. Operation 10 .......................................
4.1 Start-up ............................................................. 10
Section 5. Service and Maintenance 10 .............
5.1 Routine Maintenance 10 .......................................
5.2 Winterizing Pump ..............................................11
Section 6. Troubleshooting and Repair 12 ........
6.1 Troubleshooting ................................................ 12
6.2 Service Technician Maintenance ...................... 13
6.2.5 Motor Replacement 16 ..........................................
Section 7. Product Speciîš¿cations and
Technical Data 17 ..............................
7.1 Replacement Parts List 17 ....................................
7.2 Exploded View 18 ..................................................
7.3 WFTR Pump Curves 19 ........................................
7.4 PhysicalandOperationalSpecications .......... 19
Page 3
ENGLISH
Jandy® Pro Series Water Feature Pump | Installation and Operation Manual
Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
1.1 Safety Instructions
All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
To reduce the risk of injury, do not permit children to use this product.
WARNING
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide, or full
ow)valvepositionwiththepumprunning.
WARNING
Zodiac®pumpsarepoweredbyahighvoltageelectricmotorandmustbeinstalledbyalicensedorcertied
electricianoraqualiedswimmingpoolservicetechnician.
WARNING
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Connect only to a branch circuit that
isprotectedbyaground-faultcircuit-interrupter(GFCI).Contactaqualiedelectricianifyoucannotverifythat
the circuit is protected by a GFCI. A GFCI should be provided by the installer and should be tested on a routine
basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power
should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts
powertothepumpwithoutthetestbuttonbeingpushed,agroundcurrentisowing,indicatingthepossibility
ofelectricalshock.Donotusethepump.Disconnectthepumpandhavetheproblemcorrectedbyaqualied
service representative before using.
Duetothepotentialriskofre,electricshock,orinjuriestopersons,ZodiacPumpsmustbeinstalled
in accordance with the National Electrical Code® (NEC®),alllocalelectricalandsafetycodes,andthe
Occupational Safety and Health Act (OSHA®).CopiesoftheNECmaybeorderedfromtheNationalFire
Protection Association® (NFPA®)onlineatwww.nfpa.orgorcall617-770-3000,orcontactyourlocalgovernment
inspection agency.
WARNING
Incorrectly installed equipment may fail, causing severe injury or property damage.
WARNING
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY
OR DEATH. Do not block pump suction as this can cause severe injury or death. Do not use this pump for wading
pools, shallow pools or spas containing bottom drains, unless the pump is connected to at least two functioning
suctionoutlets.Suctionoutlet(drain)assemblies and covers must be certified to the latest published version of
ANSI®/ASME® A112.19.8, or its successor standard, ANSI/APSP-16.
WARNING
• Do not connect the system to an unregulated city water system or other external source of pressurized water
producing pressures greater than 35 PSI.
• Trappedairinsystemcancausethelterlidtobeblownoff,whichcanresultindeath,seriouspersonalinjury,
or property damage. Be sure all air is out of the system before operating.
WARNING


Produktspezifikationen

Marke: JANDY
Kategorie: pomp
Modell: WaterFeature

Brauchst du Hilfe?

Wenn Sie Hilfe mit JANDY WaterFeature benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung pomp JANDY

Bedienungsanleitung pomp

Neueste Bedienungsanleitung für -Kategorien-