Indesit I3B L626 UK Bedienungsanleitung

Indesit SpĆ¼lmaschine I3B L626 UK

Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r Indesit I3B L626 UK (8 Seiten) in der Kategorie SpĆ¼lmaschine. Dieser Bedienungsanleitung war fĆ¼r 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
EN
1
APPLIANCE
PRODUCT DESCRIPTION
1. Upper rack
2. Foldable ī˜Ÿaps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
1 2 43 5 6 7
8
9
10
1. On-Oī˜ž/Reset button with indicator light
2. Program selection button with indicator light
3. Half Load button with indicator light
4. Rinse Aid reī˜ll indicator light
5. Salt reī˜ll indicator light
6. Program indicator lights
7. Delay indicator light
8. Delay button with indicator light
9. Push&GO button with indicator light
10. Start/Pause button with indicator light / Drain out
DAILY REFERENCE
GUIDE
CONTROL PANEL
Before using the appliance carefully read Safety Instructions.
0000 000 00000
Service:
1
2
3
4
5
6
10
12
7
11
9
8
THANK YOU FOR BUYING AN INDESIT PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.indesit.com/register
You can download the Safety Instructions and the
User
Manual, by visiting our website docs.indesit.eu
and
following the Instructions on the back of this booklet.
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machineā€™s functional components.
ā€¢ It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
ā€¢ It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be ī˜lled when the SALT REFILL
indicator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the ī˜Ÿrst time you do this: ī˜Ÿll the salt
reservoir with water.
3. Position the funnel (see ī˜Ÿgure) and ī˜ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory sets the default value for the water hardness.
ā€¢ Switch on the appliance by pressing the button.ON/OFF
ā€¢ Switch oī˜ž the appliance by pressing the button.ON/OFF
ā€¢ Hold down button START/Pause for 5 seconds, until you hear a beep.
ā€¢ Switch on the appliance by pressing the button.ON/OFF
ā€¢ The program indicator light of the current set level ī˜Ÿashes.
ā€¢ Press button to select the desired hardness level (Psee WATER
HARDNESS TABLE).
ā€¢ Switch oī˜ž the appliance by pressing the button.ON/OFF
Water Hardness Table
Level Ā°dH
German degrees
Ā°fH
French degrees
Ā°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5Very
hard 35 - 50 61 - 90 43 - 62
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been speciī˜Ÿcally designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches oī˜ž.
If the salt container is not ī˜Ÿlled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser shouldA
be ī˜lled when the indicator light in the controlRINSE AID REFILL
panel is lit.
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Pour in the rinse aid (max.110 ml), making sure it does not overī˜Ÿow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisī˜ed with the drying results, you can ad-
just the quantity of rinse aid used.
ā€¢ Switch the dishwasher on using the button.ON/OFF
ā€¢ Switch it oī˜ž using the button.ON/OFF
ā€¢ Press button START/Pause three times - a beep will be heard.
ā€¢ Switch it on using the button.ON/OFF
ā€¢ The program indicator light of the current set level ī˜Ÿashes.
ā€¢ Press button P to select the level of rinse aid quantity to be supplied.
ā€¢ Switch it oī˜ž using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is speciī˜c to the model, please follow instruction
above to check this for your machine.
ā€¢ If you see bluish streaks on the dishes, set a low number (2-3).
ā€¢ If there are drops of water or limescale marks on the dishes, set a
mid-range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are indiD-
cations to help the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
Usage of detergent not designed for dishwashers may cause mal-
function or damage to the appliance.
A
B
C
D
EN
3
Program
Drying
phase
Available
options *)
Duration
of wash
program
(h:min)**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
1 Eco 50Ā° 3:35 9.5 0.95
2 Intensive 65Ā° 2:40 18.0 1.60
3 Mixed 55Ā° 2:15 16.0 1.40
4 Fast&Clean 28ā€™ 45Ā° - 0:28 9.0 0.50
5 Pre-Wash - - 0:12 4.7 0.01
6 Push&GO 50Ā° 1:30 11.5 1.30
PROGRAMS TABLE
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
1 ECO
Eco programme is suitable to clean normally soiled tableware, that for
this use, it is the most eī˜œcient programme in terms of its combined
energy and water consumption, and that it is used to assess complian-
ce with the EU Ecodesign legislation.
2 INTENSIVE
Program recommended for heavily soiled crockery, especially suitable
for pans and saucepans (not to be used for delicate items).
3 MIXED
Mixed soil. For normally soiled dishes with dried food residues.
4 FAST&CLEAN 28ā€™
Program to be used for half load of lightly-soiled dishes with no dried
food residues. Does not include drying phase.
5 PRE-WASH
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
6 PUSH&GO
Everyday wash and dry cycle that ensures great cleaning performance
in a short time without the need to pre-treat dishes.
Notes:
Please note that cycle Fast&Clean 28ā€™ is dedicated for lightly soiled dishes.
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address:
dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature
and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and
sensor calibration. The sensor calibration can increase program duration up to 20 min..


Produktspezifikationen

Marke: Indesit
Kategorie: SpĆ¼lmaschine
Modell: I3B L626 UK

Brauchst du Hilfe?

Wenn Sie Hilfe mit Indesit I3B L626 UK benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung SpĆ¼lmaschine Indesit

Bedienungsanleitung SpĆ¼lmaschine

Neueste Bedienungsanleitung fĆ¼r -Kategorien-