Ignis adl 833 2 Bedienungsanleitung


Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r Ignis adl 833 2 (8 Seiten) in der Kategorie SpĆ¼lmaschine. Dieser Bedienungsanleitung war fĆ¼r 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
3
SUMMARY GB
BEFORE USING THE DISHWASHER PAGE 4
PROTECTING THE ENVIRONMENT PAGE 4
PRECAUTIONS AND GENERAL RECOMMENDATIONS PAGE 4
ENERGY AND WATER SAVING TIPS PAGE 4
HOW TO FILL THE SALT CONTAINER PAGE 5
HOW TO FILL THE RINSE AID DISPENSER PAGE 6
HOW TO FILL THE DETERGENT DISPENSER PAGE 6
CONNECTIONS PAGE 7
MAINTENANCE AND CLEANING PAGE 9
TROUBLESHOOTING GUIDE PAGE 10
AFTER-SALES SERVICE PAGE 10
For maximum satisfaction from your dishwasher, carefully read these user
instructions, consult the wash programme chart and the loading guide.
4
ā€¢After unpacking, make sure the appliance is
undamaged and that the door closes
correctly. Do not use the appliance if it is
damaged. If in doubt, consult your local
retailer.
ā€¢Keep potentially hazardous packaging
(plastic bags etc.) out of the reach of children.
ā€¢This appliance is designed for use in the
home in compliance with its intended
purpose.
ā€¢All water and electrical connections must be
carried out by a qualified technician in
compliance with the manufacturerā€™s
instructions (refer to the enclosed installation
booklet) and current local safety regulations.
1. Packing
The packing box may be fully recycled as
confirmed by the recycling symbol .
2. Appliance
The appliance is built from reusable
materials.
If you decide to scrap the dishwasher, it
must be disposed of in compliance with local
waste disposal laws. Before scrapping, cut
off the power cable so that the appliance
cannot be connected to the mains.
Child safety
ā€¢Do not allow children to play with the
dishwasher.
ā€¢Store the detergent, rinse aid and salt in a dry
place out of the reach of children.
General recommendations
ā€¢Only use detergents, rinse aids and
regeneration salts (not applicable for
Australia) specially recommended for use in
domestic dishwashers.
ā€¢On completion of the wash programme
switch off the dishwasher and turn off the
water tap.
ā€¢Before cleaning or carrying out maintenance,
switch off the appliance, disconnect the
mains plug and turn off the water tap.
ā€¢If a fault occurs, switch off the appliance and
turn off the water tap.
ā€¢The open dishwasher door can only support
the weight of the loaded rack when pulled
out. Do not rest objects on the open door or
sit or stand on it since the appliance may
topple over.
ā€¢If necessary, the power cable may be
replaced with one the same obtained from
our After-Sales Service. The power cable
must only be replaced by a qualified
technician.
ā€¢ For appliances with water-stop system:
The water inlet hose and plastic casing
contain electrical components. Do not
therefore cut the hose or immerse the plastic
casing in water. If the hose is damaged
switch off the appliance immediately.
ā€¢Do not use solvents inside the dishwasher:
risk of explosion!
ā€¢Load capacity: -12 place settings
EC Declaration of Conformity
This appliance has been designed,
constructed and distributed in compliance
with the safety requirements of
EC Directives:
ā€¢73/23/EC
ā€¢89/336/EC
ā€¢93/68/EC.
ā€¢Do not rinse crockery under running water.
ā€¢Always fully load the dishwasher before
switching on.
ā€¢If ecological energy sources are available
such as solar panel heating, heat pumps or
centralised heating systems, the appliance
may be connected to the hot water mains up
to a maximum temperature of 60Ā° C.
Make sure the water inlet hose is of the
correct type. Refer to the ā€œConnectionsā€
chapter in these user instructions.
BEFORE USING THE DISHWASHER
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
ENERGY AND WATER SAVING TIPS
5
(Not applicable for Australia).
Check the water hardness level in your
area. Consult your local Water Board or
check your last water bill.
ā€¢If the water hardness level exceeds
category 1, before using the dishwasher
for the first time, fill the salt container and
run a wash cycle so that any excess
saline solution discharged is immediately
removed by the water to prevent
corrosion. The pre-rinse cycle is not
sufficient for this purpose.
ā€¢Check the salt level regularly.
ā€¢Important: Only use regeneration salts
recommended for use in domestic
dishwashers.
Do not fill the salt container with
detergent as this will cause irreparable
damage to the water softener system.
To fill the salt container:
1. Remove the lower rack.
2. Unscrew the cap by turning it counter-clockwise.
3. If the dishwasher is new, fill the salt container
to the rim with water.
4. Fill the container to the rim with salt
(max. 2 kg) and stir with a spoon handle.
5. Screw the cap back on by turning it
clockwise.
Salt level indicator
The green float is clearly visible in the cap
window when the salt container is full. The green
float lowers and is no longer visible when the salt
container is empty.
HOW TO FILL THE SALT CONTAINER


Produktspezifikationen

Marke: Ignis
Kategorie: SpĆ¼lmaschine
Modell: adl 833 2

Brauchst du Hilfe?

Wenn Sie Hilfe mit Ignis adl 833 2 benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung SpĆ¼lmaschine Ignis

Bedienungsanleitung SpĆ¼lmaschine

Neueste Bedienungsanleitung fĆ¼r -Kategorien-