Hotpoint WDD 750P UK Bedienungsanleitung
Hotpoint
Wasch-Trockner-Kombinationen
WDD 750P UK
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hotpoint WDD 750P UK (16 Seiten) in der Kategorie Wasch-Trockner-Kombinationen. Dieser Bedienungsanleitung war für 2 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/16
GB
1
English,1
Contents
Installation, 2-3-4-5
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Care and maintenance, 6
Cutting off the water or electricity supply
Cleaning the washer dryer
Cleaning the detergent dispenser drawer
Caring for the door and drum of your appliance
Cleaning the pump
Checking the water inlet hose
Precautions and tips, 7
General safety
Disposal
Description of the washer dryer, 8-9
Control panel
Display
How to run a wash cycle or a drying cycle, 10
Wash cycles and functions, 11
Table of wash cycles
Wash functions
Detergents and laundry, 12
Detergent dispenser drawer
Preparing the laundry
Garments requiring special care
Load balancing system
Troubleshooting, 13-14
Product Guarantee and Repair Information,
15
GB
WDD 750
Instructions for use
WASHER DRYER
! This symbol reminds you to read this
instruction manual.
2
GB
2. If the floor is not perfectly level, com-
pensate for any unevenness by tightening
or loosening the adjustable front feet (see
figure); the angle of inclination, measured
according to the worktop, must not exceed
2°.
Levelling your appliance correctly will provi-
de it with stability and avoid any vibrations,
noise and shifting during operation. If it is
placed on a fitted or loose carpet, adjust
the feet in such a way as to allow enough
room for ventilation beneath the washing
machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it
to a cold water tap
using a
3/4 gas threaded
connection (see fi-
gure).
Before performing
the connection, allow
the water to run fre-
ely until it is perfectly clear.
2. Connect the other
end of the water inlet
hose to the washing
machine,
screwing it onto the
appliance’s cold water
inlet, situated on the
top right-hand side
on the rear of the
appliance (see figure).
3. Make sure there are no kinks or bends in
the hose.
! The water pressure at the tap must be
within the values indicated in the Technical
details table
(on the page 5).
! If the water inlet hose is not long enough,
contact a specialist store or an authorised
serviceman.
! Ensure that the supply taps are allowing
water through. Old taps may seize in the
closed position and thus prevent water
reaching the machine.
Installation
! Keep this instruction manual in a safe place for
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to inform
the new owner as to its operation and features.
! Read these instructions carefully: they contain
vital information on installation, use and safety.
Unpacking and levelling
Unpacking
! This is a separate
part of the polysty-
rene base and should
be removed with the
base.
! IMPORTANT check
when unpacking your
machine.
1. Unpack the washing
machine.
2. Check whether the
washing machine has
been damaged du-
ring transport. If this
is the case, do not
install it and contact
your retailer.
3. Remove the 4 pro-
tective screws and the rubber bush with the
respective spacer, situated on the rear of
the appliance (see also the installation lea-
flet).
4. Seal the gaps using the plastic plugs pro-
vided.
5. Keep all the parts: you will need them
again if the washing machine needs to be
moved to another location.
! Packaging materials are not children’s toys.
Levelling
Your machine may make a considerable amount
of noise if the two front feet have not been
adjusted correctly. 1. Install the washing
machine on a flat
sturdy floor, without
resting it up against
walls, furniture cabi-
nets or other.
GB
3
Connecting the drain hose
Connect the drain
hose, without ben-
ding it, to a draining
duct or a wall drain
situated between
65 and 100 cm from
the floor;
The drain hose may
be connected to
an under-sink trap.
Before connecting
the drain hose from
the machine ensu-
re that any blanks
or removable ends
have been taken off
the spigot.
If it is placed over
the edge of a ba-
sin or sink be sure
the free end of the
hose should not be
underwater.
! We advise against the use of hose exten-
sions; in case of absolute need, the exten-
sion must have the same diameter as the
original hose and must not exceed 150 cm
in length.
Ensure that if the drain hose is pushed into
a standpipe, that the end does not go down
more than 15cms (6 inches). If the hose is
pushed down too far, this may cause the
machine to self -syphon ie. continuously
empty as it is filling.
Electric connection
Before plugging the appliance into the
mains socket, make sure that:
• the socket is earthed and in compliance
with the applicable law;
• the socket is able to sustain the applian-
ce’s maximum power load indicated in the
Technical details table (see page 5);
65 - 100 cm
Where it connects to
the waste water pipe
cut end off spigot or
remove the blanking cap
• the supply voltage is included within the
values indicated on the Technical Data Plate
fixed on the machine.
• the socket is compatible with the washing
machine’s plug. If this is not the case, replace
the socket or the plug.
Your appliance is now supplied with a 13 amp
fused plug it can be plugged into a 13 amp
socket for immediate use. Before using the
appliance please read the instructions below.
WARNING - THIS APPLIANCE MUST BE EAR-
THED.
THE FOLLOWING OPERATIONS SHOULD BE
CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Replacing the fuse:
When replacing a faulty fuse, a 13 amp ASTA
approved fuse to BS 1362 should always be
used, and the fuse cover re-fitted. If the
fuse cover is lost, the plug must not be used
until a replacement is obtained.
Replacement fuse covers:
If a replacement fuse cover is fitted, it must
be of the correct colour as indicated by
the coloured marking or the colour that is
embossed in words on the base of the plug.
Replacements can be obtained directly from
your nearest Service Depot.
Removing the plug:
If your appliance has a non-rewireable moul-
ded plug and you should wish to re-route the
mains cable through partitions, units etc.,
please ensure that either:
the plug is replaced by a fused 13 ampe-
re rewireable plug bearing the BSI mark of
approval.
or:
the mains cable is wired directly into a 13
amp cable outlet, controlled by a switch, (in
compliance with BS 5733) which is accessible
without moving the appliance.
Disposing of the plug:
Ensure that before disposing of the plug
itself, you make the pins unusable so that it
cannot be accidentally inserted into a so-
cket.
Instructions for connecting cable to an alter-
native plug:
Important: the wires in the mains lead are
coloured in accordance with the following
code:
Green & Yellow Earth
Blue Neutral
Brown Live
Produktspezifikationen
Marke: | Hotpoint |
Kategorie: | Wasch-Trockner-Kombinationen |
Modell: | WDD 750P UK |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Hotpoint WDD 750P UK benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Wasch-Trockner-Kombinationen Hotpoint
13 Juli 2024
8 Juli 2024
8 Juli 2024
7 Juli 2024
6 Juli 2024
Bedienungsanleitung Wasch-Trockner-Kombinationen
- Wasch-Trockner-Kombinationen Samsung
- Wasch-Trockner-Kombinationen Infiniton
- Wasch-Trockner-Kombinationen Sanyo
- Wasch-Trockner-Kombinationen LG
- Wasch-Trockner-Kombinationen Bosch
- Wasch-Trockner-Kombinationen Siemens
- Wasch-Trockner-Kombinationen Electrolux
- Wasch-Trockner-Kombinationen Miele
- Wasch-Trockner-Kombinationen Whirlpool
- Wasch-Trockner-Kombinationen BEKO
- Wasch-Trockner-Kombinationen Blomberg
- Wasch-Trockner-Kombinationen Brandt
- Wasch-Trockner-Kombinationen Candy
- Wasch-Trockner-Kombinationen Haier
- Wasch-Trockner-Kombinationen Hoover
- Wasch-Trockner-Kombinationen Hotpoint-Ariston
- Wasch-Trockner-Kombinationen Indesit
- Wasch-Trockner-Kombinationen Zanussi
- Wasch-Trockner-Kombinationen Zanussi-Electrolux
- Wasch-Trockner-Kombinationen Philco
- Wasch-Trockner-Kombinationen Rosières
- Wasch-Trockner-Kombinationen Frilec
- Wasch-Trockner-Kombinationen Elba
- Wasch-Trockner-Kombinationen Euromaid
- Wasch-Trockner-Kombinationen Lamona
- Wasch-Trockner-Kombinationen Tricity Bendix
- Wasch-Trockner-Kombinationen Nordland
- Wasch-Trockner-Kombinationen Creda
- Wasch-Trockner-Kombinationen Belling
- Wasch-Trockner-Kombinationen Summit
- Wasch-Trockner-Kombinationen Servis
- Wasch-Trockner-Kombinationen Voltas BEKO
Neueste Bedienungsanleitung für -Kategorien-
14 Oktober 2024
13 Oktober 2024
13 Oktober 2024
13 Oktober 2024
12 Oktober 2024
12 Oktober 2024
12 Oktober 2024
11 Oktober 2024
11 Oktober 2024
10 Oktober 2024