Havis C-TSM-CHGR-P-1 Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Havis C-TSM-CHGR-P-1 (3 Seiten) in der Kategorie Carkit. Dieser Bedienungsanleitung war für 2 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/3
INSTALL INSTRUCTIONS C-TSM-CHGR-X-1
TRUNK SIDE MOUNT FOR 2011-2013 DODGE CHARGER
X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE
TOOLS REQUIRED:
Phillips Screwdriver
Jig Saw
Powered drill with 5/32” drill bit
HARDWARE:
QTY DESCRIPTION PART #
5 #10 x ¾” Sheet metal screws GSM33195
Always!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
C-TSM-CHGR-P-1 shown
Trunk Side Mount
(Passenger Side)
NOTE:
This instruction
shows the passenger side
installation. The Drivers side
will install the same way.
C-TSM-CHGR-X-1_INST_8-11
Make sure door has clearance at
rear trunk trim panel.
With Trunk Side Mount in
position, drill three 5/32”” holes
into floor.
Remove fender liner.
Run wiring as needed for
emergency equipment.
Unclip and move wiring at side floor
area. Make sure it is repositioned so
it will not get damaged.
Replace fender liner.
View of passenger side trunk
area prior to installation. Remove side cargo hook.
Mount screw to be reused later
(Phillips screwdriver)
Remove rear loop trim panel
fastener
Place Trunk Side Mount frame
assembly into position and attach to
inner fender with previously
removed Cargo hook screw into
original hole.
Attach lower frame to floor with
# 10 x 3/4” sheet metal screws.
C-TSM-CHGR-X-1_INST_8-11
Drill 5/32”holes at upper bracket
(next to OEM screw) and attach with
# 10 x 3/4” Sheet metal screws
Mount and wire equipment on
inside door panel.
Finished Passenger-Side Mount
shown with full width trunk tray
Finished C-TSM-CHGR-P-1 (Passenger Side Trunk Side Mount)
Shown with Full Size Spare Tire.
NOTE: If your vehicle has the small donut spare tire, the flip up trunk
liner should just clear the Trunk Side Mount.
Produktspezifikationen
Marke: | Havis |
Kategorie: | Carkit |
Modell: | C-TSM-CHGR-P-1 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Havis C-TSM-CHGR-P-1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Carkit Havis
3 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
Bedienungsanleitung Carkit
- Carkit BeeWi
- Carkit Belkin
- Carkit Gembird
- Carkit Hama
- Carkit Medion
- Carkit Nedis
- Carkit SilverCrest
- Carkit T'nB
- Carkit Siemens
- Carkit Thule
- Carkit Dymond
- Carkit Technaxx
- Carkit Renkforce
- Carkit Kenwood
- Carkit Pyle
- Carkit Caliber
- Carkit Pioneer
- Carkit Motorola
- Carkit MT Logic
- Carkit Livoo
- Carkit Sony Ericsson
- Carkit Scosche
- Carkit SuperTooth
- Carkit Parrot
- Carkit EnVivo
- Carkit Alpine
- Carkit Kogan
- Carkit Ergotron
- Carkit I-Tec
- Carkit BURY
- Carkit Mr Handsfree
- Carkit Cellular Line
- Carkit BlueAnt
- Carkit Iluv
- Carkit Veho
- Carkit Metra
- Carkit PAC
- Carkit KRAM
- Carkit Hamron
- Carkit Novus
- Carkit Alpin
- Carkit Foliatec
- Carkit Arkon
- Carkit Brodit
Neueste Bedienungsanleitung für -Kategorien-
18 September 2024
18 September 2024
17 September 2024
14 September 2024
14 September 2024
9 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024