GBC Velobind V800 Pro Bedienungsanleitung

GBC niet gecategoriseerd Velobind V800 Pro

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für GBC Velobind V800 Pro (6 Seiten) in der Kategorie niet gecategoriseerd. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/6
1.0 INTRODUCTION
1.1 OPERATIONAL COMPONENTS LAYOUT
Figure 1-1
1-2
Pressure Bar
Handle
Housing
Base
Waste Tray
Punch Guide
Light
Bind Guide
Locating Pin
Backstop
Strip Recess
2.0 SPECIFICATIONS
DESCRIPTION: Punch/Binder
PUNCH CAPACITY:* 1/8 in. (3.2 mm) X 14 in. (355.6 mm)
25 sheets of 20 lb. bond paper
*Note: No more than 4 composition covers, or
3 plastic covers should be punched at one time.
Punching stacks of these materials may result
in damage to the punch mechanism.
BIND CAPACITY: 1 in. (25 mm) X 14 in. (355.6 mm)
250 pages of 20 lb. bond paper
ELECTRICAL REQUIREMENTS: 120 VAC 230 VAC 100 VAC
60 Hertz 50 Hertz 50 Hertz
3 Amps 1.5 Amps 1.5 Amps
409.56 B.T.U.'s per hour
3-wire grounded outlet
CYCLE SPEED: 2 second punch cycle
8-10 second bind cycle
DIMENSIONS: 20 in. (50.8 cm) wide
7 in. (17.8 cm) high
15 in. (38.1 cm) deep
WEIGHT: 28 lbs. (12.7 kg)
2-1
3.0 INSTALLATION PROCEDURE
3.1 Unpacking Instructions
To unpack the machine, carefully remove the staples and open the carton. Remove
the packing material from the top and around the machine, and lift the machine
straight up out of the carton. Place the machine on a table near a 120 VAC or 220-
240 VAC grounded outlet, and remove the plastic bag.
3.2 Power Cord Configuration
This machine is supplied with a power cord terminating in a conventional three
prong electrical plug. Under no circumstances should the grounding prong of the
power cord be removed to facilitate connection to a non-approved outlet.
3.3 Checking Machine Operation
The handle should operate with relative ease. Leave it in the "up" or starting
position after testing several times.
With the handle in the starting position, check the pressure bar to ensure it can
be easily lowered and raised by the operator. Leave it in the "up" position after
testing several times.
The machine is now ready to operate. Instruct operator in proper punching and
binding procedures. Point out the operating instructions found in the waste tray,
and leave the owner's guide for the customer. Be sure to stress the importance of
the document being properly placed on the locating pin for binding.
3-1

Produktspezifikationen

Marke: GBC
Kategorie: niet gecategoriseerd
Modell: Velobind V800 Pro

Brauchst du Hilfe?

Wenn Sie Hilfe mit GBC Velobind V800 Pro benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung niet gecategoriseerd GBC

Bedienungsanleitung niet gecategoriseerd

Neueste Bedienungsanleitung für -Kategorien-