Frigidaire CFPWD15B Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Frigidaire CFPWD15B (12 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/12
PIEZAS DEL KIT BLANCO:
D 1 soporte delantero izquierdo.
E 1 soporte delantero derecho.
F 2 soportes traseros.
COMPOSANTS DU NÉCESS. BLANC :
D 1 support avant gauche.
E 1 support avant droit.
F 2 supports arrière.
WHITE KIT COMPONENTS:
D 1 Left Front bracket.
E 1 Right Front bracket.
F 2 Rear brackets.
D
E
F
Use these instructions to mount pedestal
under washer and dryer style to the right
with mechanical style timers.
Utilisez ces instructions pour xer un so-
cle sous une laveuse et une sécheuse à la
droite munies d’une minuteriecanique.
Utilice estas instrucciones para instalar
el pedestal por debajo de la lavadora y
secadora de instalación a la derecha con
temporizadores mecánicos. Washer and dryer consoles with mechanical
style timers.
La consola de la lavadora y la secadora tiene
un temporizador de tipo mecánico.
La console de la laveuse et la sécheuse est
munie d’une minuterie mécanique.
El no desconectar el suministro ectrico an-
tes de la instalacn apilada puede ocasio-
nar lesiones personales o incluso la muerte.
La instalación inadecuada de la ventilación
de la secadora puede ocasionar lesiones
personales o daños a la propiedad.
Para evitar lesiones en la espalda u otro
tipo de lesiones, procure levantar o mover
la lavadora o secadora con la ayuda de
más de una persona.
No apile la secadora sobre la lavadora si
ya está instalada sobre un pedestal.
Failure to disconnect from power source
before stacking could result in personal
injury or even death.
Improper installation of dryer venting
could result in personal injury or damage
to property.
To avoid back or other injury, have more
than one person move or lift the washer
or dryer.
Do not stack a dryer on top of washer
already installed on pedestal.
Ne pas débrancher l’appareil de sa source
d’alimentation en électricité avant de le super-
poser peut causer des blessures, voire la mort.
Une installation inappropriée du système
de ventilation de lacheuse peut causer
des blessures ou des dommages matériels.
Pour éviter les blessures au dos ou
d’autres types de blessure, demandez
l’aide d’autres personnes pour déplacer
ou soulever la laveuse ou lacheuse.
Ne superposez pas une sécheuse sur
une laveuse installée sur un socle.
English continued on page 2. Pour la suite de la version française,
reportez-vous à la page 5.
La versión en español continúa en lagina 8.
WARNING AVERTISSEMENT ADVERTENCIA
Adjustable wrench
Clé à molette
Llave ajustable
Carpenter’s level
Niveau de charpentier
Nivel de carpintero
Optional universal
wrench available
from dealer
Clé universelle
optionnelle (en vente
chez le détaillant)
Llave universal opcional
(disponible a través
de su distribuidor local)
Phillips screwdriver
Tournevis Phillips
Destornillador Phillips
OR
OU
O
OR
OU
O
AND
ET
Y
AND
ET
Y
9/16” or 14 mm box wrench
Clé polygonale de
9/16 po ou de 14 mm
Llave de cubo de
9/16 po o 14 mm
Tools needed: / Outils nécessaires: / Herramientas necesarias:
SCREW KIT COMPONENTS:
14 #10 (16 x .500) screws.C
COMPOSANTS DU NÉCESSAIRE DE VIS:
14 vis n° 10 (16 x .500).C
PIEZAS DEL KIT (TORNILLOS):
14 tornillos n.º 10 (16 x .500).C
C
1137338900 A (1002)
2
Allow for approximately 5 in. (12.5 cm) behind the
pedestal for clearance of back of washer or dryer to the wall.
Allow additional space if venting dryer upward or downward.
If locking nuts are not removed on units with metal
feet, mounting holes in appliance will not align to mounting
holes in brackets.
Due to higher center of gravity of appliance on ped-
estals, some side-to-side rocking is normal during operation.
Vibration can be minimized by assuring appliance is installed
properly, including being level and solid on all four (4) legs by
following these directions.
PREPARATION INSTRUCTIONS
If washer or dryer is new and has not been installed yet, skip to 1.
step 4.
If dryer is already installed, disconnect dryer from electrical and 2.
gas connections and exhaust venting.
If washer is already installed, disconnect washer from electrical 3.
connection. Turn off hot and cold water supply and disconnect
hot and cold water supply hoses from water supply outlets.
Disconnect drain hose from drain pipe.
If appliance has plastic feet, screw each foot fl ush to the base.4.
If appliance has metal feet, unscrew them, remove the locking 5.
nut and reinstall the feet fl ush to the base.
A) Preparing washer or dryer for mount-
ing on pedestal
B) Preparing pedestal before mounting
washer or dryer
Locate pedestal to within a few inches of its fi nal location.1.
Level the pedestal front-to-back and side-to-side by adjusting 2.
each leveling leg. Keep leg extension to a minimum.
Rock the pedestal from corner-to-corner to check for stability. 3.
Repeat leveling and rocking until all four (4) feet are sturdy on the
oor and pedestal is level.
Without turning the rubber foot, lock each pedestal leg in place 4.
by tightening its lock nut tight against the pedestal base.
DO NOT remove foam!
lock nut
raise
lower
Optional universal
wrench (or adjustable
pliers).
3
- EXCESSIVE WEIGHT HAZARD - To avoid
back or other injury, have more than one person move or lift
the washer.
C ) 1
Attaching washer mounting hardware
3.1 cu ft WASHER INSTRUCTIONS
D ) Mounting washer1
E1) Installing or re-installing washer
Use the following instructions for mounting this type of washer 1.
to the pedestal:
Using two or more persons, slightly tip the washer back and lift it 1.
onto the pedestal. Still tipped, slide the washer back against the
rear brackets and gently set down the front so the appliance is
between the front and rear brackets.
Remove lower service access panel.2.
Remove 2 lower screws from backsheet of washer. Save screws to 3.
reinstall later.
Attach each front clip to outer-most set of holes with 2 screws.4.
Adjust the appliance side-to-side to align its mounting holes with 2.
the pedestals bracket holes.
Reinstall backsheet screws removed earlier through each rear 3.
bracket into the base of the washer.
Reinstall the lower service access panel.4.
Reinstall the 2 screws removed earlier 5.
through the outer hole of
each front bracket into the base of the
washer.
Slide appliance/pedestal into place.1.
Check for levelness and rock all four (4) legs again. Repeat until 2.
level and solid.
Refer to 3. for complete details Washer Installation Instructions
on installing water, drain, or electrical.
SLIDE BACK TIP DOWN
middle
slot
outward
Insert “A” tab of each rear bracket into the middle slots on rear 5.
of pedestal. Orient bracket outward for washer mounting.
“A”
tab
Remove 2 screws
from service access
below front panel.
Remove 2 screws from
washer backsheet.
Install 2 screws through each rear bracket into aligning pedestal 6.
holes.


Produktspezifikationen

Marke: Frigidaire
Kategorie: Nicht kategorisiert
Modell: CFPWD15B

Brauchst du Hilfe?

Wenn Sie Hilfe mit Frigidaire CFPWD15B benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Frigidaire

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-