Fetco HWD-2102 Bedienungsanleitung
Fetco
Wasserspender
HWD-2102
Lesen Sie kostenlos die đ deutsche Bedienungsanleitung fĂźr Fetco HWD-2102 (12 Seiten) in der Kategorie Wasserspender. Dieser Bedienungsanleitung war fĂźr 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/12
FETCOŽ, and Driven To Innovation⢠are trademarks or trade names of Food Equipment Technologies Company.
Š 2012 Food Equipment Technologies Company May-2012
NOTICE TO INSTALLER: Please leave this book with the machine.
www.fetco.com
www.fetco.com
www.fetco.com
www.fetco.com www.fetco.com
Model:
Model:
Model:
Model: Model:
f Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102 Hot Water Dispenser HWD_2102
With
With
With
With With Portion
Portion
Portion
Portion Portion Control
Control
Control
Control Control
USERS GUIDE-Preliminar
y
Edition
ÂŽ
2
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102 FETCO Hot Water Dispenser HWD_2102
Contact Information
FETCO ÂŽ
Food Equipment Technologies Company
600 Rose Road
Lake Zurich ⢠IL USA ⢠⢠60047-0429
Internet: www.fetco.com
Phone: (800) 338-2699 (US & Canada)
(847) 719-3000
Fax: (847) 719-3001
Email: sales@fetco.com
techsupport@fetco.com
Description & Features
The following are the factory settingsâand range of variables that are adjustable:
Temperature Control: Water temperature is factory set at maximum 97°C/208°F
(Temperature selectable 50-97°C/122°-208°F)
Portion Control: Delivery volume factory set to deliver up to maximum 21fl.oz/630cc.
(Portion control selectable 5-53fl.oz/158-1575cc by timer adjustment)
Operating Instructions
Operating Instructions
Operating Instructions
Operating Instructions Operating Instructions
To Start:
Follow installation and set up procedures. If desired, set custom dispense temperature; dispense time/volume interval.
1) Open water valve
2) Power unit âONâ from rear power switch. Unit will fill and heat (up to 20 minutes for a new unit).
-After unit is filled and heated
3) Ready Lamp will glow green
-Unit may be operated when Ready Lamp is âoffâ (after initial fill).
4) White colored backlight intensity of control panel slowly pulsates during âREADYâ condition
Ă the HWD_2102 should be left âONâ. The hot water tank is well insulated to control energy loss.
-The HWD_2102 is ready to dispense-
Refer to control panel layout diagram for HWD_2102 hot water dispenser on Page 3
To dispense
1) Touch UNLOCK/DISPENSE pad for 1-3 seconds to unlock and activate dispensing system
-Border of UNLOCK/DISPENSE pad will change: briefly turn pink and blink signaling activation
2) Remove finger from pad
-Border of UNLOCK/DISPENSE pad will glow steady red: ready to dispense
3) Touch center of UNLOCK/DISPENSE pad to dispense. Keep finger on pad until dispense is complete.
-Dispense automatically stops when time out is complete, or if finger is removed.
Ă Dispense is unlocked and functioning only when Border of UNLOCK/DISPENSE pad is steady red.
Multiple dispenses are possible when the light bordering the UNLOCK/DISPENSE pad is steady and red colored
Lift finger and reactivate after portion by retouching pad for next dispense portion. Finger must be on pad to dispense.
The UNLOCK/DISPENSE pad rapidly flashes red if finger remains on it after dispensing and no water is dispensed.
If finger remains on the UNLOCK/DISPENSE pad more than 10 seconds while rapidly flashing red-the controls âlock outâ
and READY LIGHT & HEATING LIGHT will flash rapidly to show a fault state. All controls are disabled during fault state.
To clear Fault State:
Switch machine âOFFâ for about ten seconds, and then toggle back âONâ (Control Reset)
After controls initiate, hot water tank level and temperature are checked- then the âREADYâ light will activate .
Ă This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
3
CONTROL PANEL LAYOUT DIAGRAM FOR HWD_2102 HOT WATER DISPENSER
Power Lamp
(Unit is energized)
Ready Lamp
-Dispense will operate when lit,
-Temperature is low when not lit
Heating Lamp
For hot water tank
(is âONâ when heater is activated)
Touch Function Selector
selects and activates selected option
Border of UNLOCK/DISPENSE pad will:
glow white when ready to unlock
-after unlocking by tap of finger-
glow steady red when ready to dispense
flash rapidly to show a fault state
Silicone Tap for hot water dispenser
tâŤf Touch Function Selector Technology
Operating Principles
The HWD_2102 delivers precision temperature water at selected temperatures. The green âREADYâ lamp must
be lit. Unit will dispense water if green âREADYâ lamp ins not lit.
Unit is factory calibrated at the optimum dispense portion of 21.3fl.oz/630cc (16 sec).
Hot water is drawn from the faucet, the fill valve cycles on and off to replenish the hot water tank.
The dispense valve faucet e bumper over the tap. is protected by a silicon
When dispensing water at a rate that exceeds the unitâs capacity to heat, the ready light will go off to show that
the selected preset temperature is not available. Always observe the âREADYâ lamp
When the âREADYâ lamp is lit â proper dispense temperature is enabled.
When heating or reheating, the green âREADYâ light will turn off and the âHEATINGâ light will display
Ă After exceeding the maximum optimum dispense portion of 21.3fl.oz/630cc the water supply in the hot
water tank begins do become depleted. The âREADYâ lamp will turn off. Dispenser faucet does not âlockoutâ.
This may allow less heated water to dispense. For the highest selected dispense when âREADYâ lamp is lit.
Ă When the HWD_2102 is powered on (or controller reset)- the controls check and adjust tank level and temperature.
This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
Produktspezifikationen
| Marke: | Fetco |
| Kategorie: | Wasserspender |
| Modell: | HWD-2102 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Fetco HWD-2102 benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Wasserspender Fetco
16 August 2024
13 August 2024
13 August 2024
12 August 2024
10 August 2024
8 August 2024
7 August 2024
17 November 2023
25 September 2023
Bedienungsanleitung Wasserspender
- Wasserspender Emerio
- Wasserspender Ernesto
- Wasserspender Nedis
- Wasserspender Philips
- Wasserspender Panasonic
- Wasserspender Camry
- Wasserspender Princess
- Wasserspender Buffalo
- Wasserspender Caso
- Wasserspender Electrolux
- Wasserspender Proficook
- Wasserspender Korona
- Wasserspender Tefal
- Wasserspender Primo
- Wasserspender Waring Commercial
- Wasserspender Haier
- Wasserspender Hoover
- Wasserspender Bartscher
- Wasserspender Midea
- Wasserspender Arçelik
- Wasserspender Hitachi
- Wasserspender Franke
- Wasserspender Honeywell
- Wasserspender Elba
- Wasserspender Westinghouse
- Wasserspender Brita
- Wasserspender Aarke
- Wasserspender Tiger
- Wasserspender Omega
- Wasserspender Breville
- Wasserspender Royal Sovereign
- Wasserspender Sogo
- Wasserspender Orbegozo
- Wasserspender SodaStream
- Wasserspender Igloo
- Wasserspender SPT
- Wasserspender Hatco
- Wasserspender Avanti
- Wasserspender Elkay
- Wasserspender Bunn
- Wasserspender Avalon
- Wasserspender NewAir
- Wasserspender Nutrichef
- Wasserspender Waterdrop
- Wasserspender Hiberg
- Wasserspender Bloomfield
- Wasserspender Petkit
- Wasserspender Perlick
- Wasserspender Brentwood
- Wasserspender Crathco
- Wasserspender Primo Water
- Wasserspender Healthy Choice
- Wasserspender BIBO
- Wasserspender SodaKING
- Wasserspender Ramtons
- Wasserspender Oasis
- Wasserspender Dornbracht
- Wasserspender InSinkErator
- Wasserspender Cal-Mil
- Wasserspender Imarflex
Neueste Bedienungsanleitung fĂźr -Kategorien-
1 Oktober 2024
18 September 2024
13 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024