FERM Zubehör Werkzeug Bedienungsanleitung
FERM
compressor
Zubehör Werkzeug
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für FERM Zubehör Werkzeug (8 Seiten) in der Kategorie compressor. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/8
WWW.FERM.COM
EN
DE
NL
FR
ES
LT
LV
Original instructions 02
Übersetzung der Originalbetriebsanleitung 02
Vertaling van de oorspronkelijke gebruiksaanwijzing 03
Traduction de la notice originale 03
Traducción del manual original 04
Originalios instrukcijos vertimas 04
Instrukciju tulkojums no oriģinālvalodas 05
2
EN-DE
HOSE REEL
1. INSTRUCTIONS
Mounting the hose reel.
The most appropriate position is to mount it on a
wall horizontally, no more than 1 meter above the
ground. Mounting can be done by hanging it on
the hook and by using the bracket.
• Screw 2 holes in the wall. The distance
between the 2 holes should be 130mm.
• Use the 2 M8 screws with a washer to mount
the bracket to the wall.
Extracting the hose.
• Pull the hose and stop when it reaches the
desired length. The maximum length is 9
meters.
Retracting the hose.
• Extract the hose about 3-5 cm. The hose will
retract automatically.
• Hold the nozzle when the hose is retracting
and follow the retraction until it finishes.
• If the hose gets twisted, extract it fully and
retract it slowly to smoothen out the hose.
Connect the DIN coupling to a compressor. The
universal coupling can be used to connect to any
desired accessory (not included).
SCHLAUCHROLLE
1. ANWEISUNGEN
Montage der Schlauchrolle.
Die beste Montageposition ist horizontal an der
Wand, höchstens 1 Meter über dem Boden. Die
Montage kann durch Aufhängen an dem Haken
und durch Verwendung der Halterung erfolgen.
• Bohren Sie 2 Löcher in die Wand. Der Abstand
zwischen den 2 Löchern muss 130mm
betragen.
• Befestigen Sie die Halterung mit den 2 M8-
Schrauben und einer Unterlegscheibe an der
Wand.
Abrollen des Schlauchs.
• Ziehen Sie den Schlauch bis zur gewünschten
Länge. Die maximale Länge beträgt 9 Meter.
Aufrollen des Schlauchs.
• Rollen Sie den Schlauch etwa 3-5 cm ab. Er
wird dann automatisch aufgerollt.
• Halten Sie die Düse fest, bis der Aufrollvorgang
abgeschlossen ist.
• Wenn sich der Schlauch verdreht, rollen Sie ihn
vollständig ab und dann langsam wieder auf,
damit er korrekt aufgerollt wird.
Verbinden Sie die DIN-Kupplung mit einem
Kompressor. Mit der Universalkupplung kann
beliebiges Zubehör angeschlossen werden (nicht
im Lieferumfang enthalten).
3
NL-FR
SLANGHASPEL
1. INSTRUCTIES
Monteren van de slanghaspel
De beste positie om de slanghaspel op te hangen
is aan een muur en niet hoger dan 1 meter boven
de grond. Het monteren kan gedaan worden met
de beugel of door het ophangen aan de haak.
• Boor 2 gaten in de muur. De afstand tussen de
2 gaten moet 130mm zijn.
• Gebruik M8 schroeven, met ringen, om de
beugel aan de muur te monteren.
Afrollen van de slang
• Trek de slang uit de haspel tot de gewenste
lengte bereikt is. De maximale lengte is 9
meter.
Oprollen van de slang
• Trek de slang ongeveer 3 -5cm uit de haspel
om de slang te ontgrendelen. De slang rolt zich
nu zelf op.
• Geleid de slang tijdens het oprollen.
• Mocht de slang gedraaid zijn, trek de slang
dan weer volledig uit en laat de slang dan weer
langzaam oprollen.
Verbind de DIN aansluiting met een compressor.
De universele aansluiting kan gebruikt worden om
accessoires (niet bijgesloten) op aan te sluiten.
DÉVIDOIR
1. INSTRUCTIONS
Montage du dévidoir.
La position la plus appropriée est le montage
horizontal au mur à une hauteur maximum de 1
mètre au-dessus du sol. Le montage peut être
effectué en accrochant le dévidoir au crochet et
en utilisant un support.
• Percez 2 trous dans le mur à un intervalle entre
les trous de 130 mm.
• Utilisez les 2 vis M8 avec une rondelle pour
monter le support au mur.
Déroulement du tuyau.
• Tirez le tuyau et interrompez le déroulement
lorsqu’il atteint la longueur désirée. La
longueur maximum est de 9 mètres.
Enroulement du tuyau.
• Déroulez le tuyau de 3 à 5 cm environ. Le
tuyau s’enroulera automatiquement.
• Maintenez la buse lorsque le tuyau s’enroule et
jusqu’à ce qu’il ait terminé.
• Si le tuyau se tord, déroulez-le complètement
et enroulez-le lentement pour le redresser.
Branchez le raccord DIN à un compresseur. Le
raccord universel peut être utilisé pour connecter
n’importe quel accessoire (non fourni).
Produktspezifikationen
Marke: | FERM |
Kategorie: | compressor |
Modell: | Zubehör Werkzeug |
Brauchst du Hilfe?
Wenn Sie Hilfe mit FERM Zubehör Werkzeug benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung compressor FERM
31 Juli 2024
26 Juli 2024
25 Juli 2024
19 Juli 2024
Bedienungsanleitung compressor
- compressor Makita
- compressor Parkside
- compressor Vonroc
- compressor AEG
- compressor Technaxx
- compressor Black And Decker
- compressor Cocraft
- compressor Senco
- compressor Topcraft
- compressor Trotec
- compressor DeWalt
- compressor Einhell
- compressor Festool
- compressor Ultimate Speed
- compressor Hikoki
- compressor Hitachi
- compressor Hyundai
- compressor Metabo
- compressor Stanley
- compressor Güde
- compressor Power Craft
- compressor Scheppach
- compressor Workzone
- compressor Meec Tools
- compressor Fieldmann
- compressor Westfalia
- compressor Samson
- compressor Nilfisk
- compressor Silverline
- compressor Herkules
- compressor Airpress
- compressor Robust
- compressor Wiltec
- compressor Zipper
- compressor Pansam
- compressor Omnitronic
- compressor Bavaria
- compressor Toolcraft
- compressor Osram
- compressor CMI
- compressor Craftsman
- compressor Powerplus
- compressor Alphacool
- compressor Auto Joe
- compressor Ozito
- compressor Sun Joe
- compressor DBX
- compressor Draper
- compressor Duro Pro
- compressor Emax
- compressor Avantco
- compressor Eventide
- compressor Abac
- compressor SPL
- compressor Truper
- compressor Unimac
- compressor Hamron
- compressor Full Boar
- compressor Prowork
- compressor Anova
- compressor POWERNAIL
- compressor TOOLMATE
- compressor Cartrend
- compressor Outbac
- compressor Numax
- compressor TJM
- compressor TAURUS Titanium
Neueste Bedienungsanleitung für -Kategorien-
14 September 2024
14 September 2024
9 September 2024
9 September 2024
7 September 2024
7 September 2024
6 September 2024
6 September 2024
6 September 2024
6 September 2024