Enlight EN-8970 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Enlight EN-8970 (17 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 22 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/17
1
Version 3.0
11/07/2001
Limited Warranty
Enlight Corporation warrants this EN-8970 1U Rackmount Chassis and its associ-
ated components, in accordance with the terms defined below. Enlight
Corporation will either repair or replace this EN-8970 if it is proved that it is
defective in its design, material and/or workmanship in the course of its normal use
within one year from the Buyer’s date of purchase from an authorized dealer.
The terms of this Limited Warranty are defined as follows:
The normal and intended use of EN-8970 should be in accordance with the func-
tional, environmental, and operational standards either published by Enlight
Corporation or generally accepted in the industry.
Enlight Corporation will not be liable for any EN-8970 that has been altered or
modified, either intentionally or unintentionally, during its normal use.
Enlight Corporation will not be liable for data loss or any data contained within
the EN-8970 during its normal use.
Enlight Corporation shall have no obligation for the malfunctions of any EN-
8970 unless it is proved to be defective in its design, material and/or workman-
ship in the course of its normal use within the warranty period.
!Warning! Please read manual carefully before installation. Failure to
do so could result in damage to this product.
Static electricity can damage the electrical components, so you need
to be properly grounded when servicing or during installation.
2
F
F
F
F
FC
C
C
C
CC
C
C
C
C &
&
&
&
& D
D
D
D
DO
O
O
O
OC
C
C
C
C C
C
C
C
CO
O
O
O
OM
M
M
M
MP
P
P
P
PL
L
L
L
LI
I
I
I
IA
A
A
A
AN
N
N
N
NC
C
C
C
CE
E
E
E
E
Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject to the follow-
ing two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with manufacturer’s instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING! Any changes or modifications to this product not expressly
approved by the manufacturer could void any assurances of safety or performance
and could result in violation of Part 15 of the FCC Rules.
Reprinted from the Code of Federal Regulations #47, part 15.193,1993.
Washington DC: Office of the Federal Register, National Archives and Records
Administration, U.S. Government Printing Office.
3
T
T
T
T
Ta
a
a
a
ab
b
b
b
bl
l
l
l
le
e
e
e
e o
o
o
o
of
f
f
f
f C
C
C
C
Co
o
o
o
on
n
n
n
nt
t
t
t
te
e
e
e
en
n
n
n
nt
t
t
t
t
1. Introduction 4
1.1 Chassis Introduction 4
1.2 Specifications 5
1.3 Over view 7
1.3.1 Front panel view 7
1.3.2 Inside view 8
1.3.3 Rear view 9
2. Hardware Setup 10
2.1 Opening Chassis 10
2.2 Installing CD-ROM & FDD 11
2.3 Installing HDD 13
2.4 Installing I/O shields 15
2.5 Installing Motherboard and Heatsink 16
2.6 Installing 1U into the Cabinet 17


Produktspezifikationen

Marke: Enlight
Kategorie: Nicht kategorisiert
Modell: EN-8970
Breite: 430 mm
Tiefe: 600 mm
Produktfarbe: Schwarz
Höhe: 44 mm
Typ: Server
Stromversorgung: 350 W
Rack-Einbau: Ja
Rack-Kapazität: 1U
Laufwerkseinschübe: 1 x slim 3.5" FDD 1 x slim CD-ROM
Unterstützte Motherboards Formfaktoren: ATX
Ventilator: 40x40 mm

Brauchst du Hilfe?

Wenn Sie Hilfe mit Enlight EN-8970 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Enlight

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-