Elite Saker Plus SK200XVW2 Bedienungsanleitung
Elite
Projektionsfläche
Saker Plus SK200XVW2
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Elite Saker Plus SK200XVW2 (5 Seiten) in der Kategorie Projektionsfläche. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/5
Rev.082615 1 www.elitescreens.com
Electric Wall/Ceiling Projection Screen
Saker
Saker
Saker
SakerSaker Plus
Plus
Plus
Plus Plus Series
Series
Series
Series Series
User’s Guide
Important Safety & Warning Precautions
Make sure to read this user’s guide and follow the procedures below.
Caution: The screen’s Black Top Drop is already set to its maximum drop distance. There is NO extra
Black Top Drop in the roller. Please be aware of this as it will void your warranty with Elite Screens.
Unapproved changes or modications (except for cutting the power cord for hardwire installations) to this
unit are prohibited and will void your warranty. For more information, please contact our Technical Support
Department at (877) 511-1211 Ext. 604.
Please retain this user’s guide for future reference.
To avoid damaging the unit, do not use with any unauthorized accessories not recommended by the
manufacturer.
Handle the unit carefully during transportation to avoid any damages.
To ensure safe and reliable operation, direct connection to a properly grounded power source is
advised.
The power outlet supplying power to the unit should be close to the unit and easily accessible.
Do not install the unit on uneven or inclined surfaces.
Do not put heavy objects on the power cord and position it properly to avoid creating a trip
obstacle.
Never overload the power cord to prevent an electric shock or re due to a loose contact or a short
circuit.
There are not user serviceable parts in this unit. Do not attempt to disassemble this unit by yourself.
No one except authorized technicians can open and make repairs to this unit.
Make sure the power source this unit is connected to has a continuous power ow.
If there is need to use an extension cord, make sure the cord has an equal rating as the appliance to
avoid overheat.
Do not handle the power plug when your hands are wet or your feet are in contact with water.
Do not use this unit under the following circumstances.
Disconnect the power cord under the conditions of heavy rain, wind, thunder or lightning.
Avoid direct Sunshine, rain shower and moisture.
Keep away from re sources and high temperature to prevent this device from overheating.
Cut o the power supply rst before transportation or maintenance.
Fully disconnect from the power supply when the unit is not in use for a long period of time, as
should be done with any other electric household appliance.
To avoid possible injury and/or an electric shock, do not attempt to use the screen if there is
obvious damage or if there are any evident broken parts.
Rev.082615 2 www.elitescreens.com
WARNING
The Screen’s Top Black Drop is already set to its maximum drop distance. There is extra top black NO
drop in the roller. Please be aware of this as it will void the limitation of your warranty.
Individual modications to this product are prohibited and will void the warranty with the manufacturer.
Please contact Elite Screens Customer Service for any questions.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur on a particular installation. If this
equipment causes harmful interference to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures.
Reorient or relocate the receiving antenna of the device which may be causing the
interference.
Increase the separation between the screen and the device’s receiver.
Connect the equipment into a dierent power outlet other than the device.
Pre-Installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
3. In order to protect the screen from exposure to stains, keep the screen out of contact with foreign
particles such as dust, sawdust, and/or liquids.
NOTE
Regardless of the mounting method, the screen should be securely supported so that the vibration or
pulling on the viewing surface will not cause the casing to become loose or fall. The installer must insure
that the fasteners used are of adequate strength and suitable for the installation location.
Hardware Parts List
Please make sure all parts listed below are included before proceeding with the installation.
A.M10*Suspended Hook x 4 pcs
B. 20cm*Bubble leveler x1pc
Rev.082615 3 www.elitescreens.com
A
L
M
Clockwise
rotation
L
A
A
B
C.
D.
Installation Instructions
Recessed Installation
1. Select the installation location for your screen. Measure the distances between each eye bolt (Shown as
measurements and A in Fig.1). Mark the installation area on the ceiling based on the measurements L
taken. Using the marks as a guideline, drill a hole in the ceiling for each suspension bolt. The distance
between the installation hole (M) and the wall should be no longer than the measurement Insert one A.
eye bolt of the M10 Suspended hooks into the predrilled holes.
2. Connect the center component of the 0 Suspended hooks to the eye bolts installed above the ceiling. M1
Once properly secure, connect the third component of the M10 Suspended hooks. Attach the suspended
hooks(4xM10) individually to each of the 4 eye bolts located on the top of the screen (A/B/C/D . )
3. After the installation is complete, if the screen is not level , you can adjust the height of the suspended ed
hooks to level the screen. Below are the adjustment methods for the suspended hooks.The maximum
and minimum adjustable lengths are shown in Fig 3.
① ② ③ ④
Hole
（ ）Fig.3
（ ）Fig.1
Ceiling
Wall
Suspended hook
1
2
3
Counter-
clockwise
rotation
（ ）Fig.2
The Screen
Produktspezifikationen
| Marke: | Elite |
| Kategorie: | Projektionsfläche |
| Modell: | Saker Plus SK200XVW2 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Elite Saker Plus SK200XVW2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Projektionsfläche Elite
15 August 2024
Bedienungsanleitung Projektionsfläche
- Projektionsfläche Da-Lite
- Projektionsfläche Pyle
- Projektionsfläche Optoma
- Projektionsfläche Kodak
- Projektionsfläche NEC
- Projektionsfläche Celexon
- Projektionsfläche AV:link
- Projektionsfläche Draper
- Projektionsfläche Oregon Scientific
- Projektionsfläche Duronic
- Projektionsfläche GPX
- Projektionsfläche Luxburg
- Projektionsfläche EluneVision
- Projektionsfläche Stewart
- Projektionsfläche Elite Screens
- Projektionsfläche Lumene
- Projektionsfläche Avers
- Projektionsfläche Elite ProAV
- Projektionsfläche KHOMO GEAR
- Projektionsfläche EPV
Neueste Bedienungsanleitung für -Kategorien-
12 Oktober 2024
2 Oktober 2024
29 September 2024
27 September 2024
20 September 2024
11 September 2024
7 September 2024
6 September 2024
6 September 2024
5 September 2024