Electro Harmonix Dirt Road Special Bedienungsanleitung
Electro Harmonix
Gitarrenverstärker
Dirt Road Special
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Electro Harmonix Dirt Road Special (4 Seiten) in der Kategorie Gitarrenverstärker. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/4
DIRT ROAD SPECIAL
Solid State Amplifier
Congratulations on your purchase of the Electro-Harmonix DIRT ROAD SPECIAL.
The EHX DIRT ROAD SPECIAL is a reissue of our vintage 1970s amp with
modern enhancements to both the electronics and mechanical design. We’ve also
added four reverbs from our Holy Grail Max reverb pedal: spring, plate, hall, and
reverse.
The DIRT ROAD SPECIAL offers the advantages of a solid state desig lighter n –
weight, smaller size and improved portability but its classic circuitry delivers a –
natural crunch and overdrive with beautiful grit and grind. And, with 4 watts 0
and one 12 inch speaker, you have the perfect amp for any occasion.
IMPORTANT SAFETY INSTRUCTIONS
 Read and keep these instructions.
 Heed all warnings.
 Follow all instructions.
 Clean only with a dry cloth.
 Connect the amplifier to a mains socket outlet with a protective earthing
connection.
 Do not defeat the safety purpose of the polarized or grounding type plug. If
the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
 Protect the power cord from being walked on or pinched.
 Unplug this amplifier during lightning storms or when unused for long periods
of time.
 Where the mains plug or appliance coupler is used as the disconnect device,
the disconnect device shall remain readily operable.
 Apparatus is not for use in tropical climates.
 Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.
 No naked flame sources, such as lighted candles, should be placed on the
apparatus.
 WARNING: To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture.
 Do not expose this apparatus to dripping or splashing and ensure that no
object filled with liquids is placed on the equipment Do not use this .
apparatus near water.
 Maintain at least six inches of unobstructed air space behind the unit to allow
for proper ventilation and cooling. Air must be capable of freely moving
around the amplifier.
 This amplifier is capable of producing very high sound pressure levels which
may cause temporary or permanent hearing damage. Use care when
adjusting volume levels during use.
 Do not turn the amplifier on without a loudspeaker.
IMPORTANT SAFETY INSTRUCTIONS (cont.)
 Refer all servicing and maintenance to qualified service personnel including
replacement of fuses and vacuum tubes. Changes and modifications not
expressly approved by EHX can void the warranty.
 Servicing is required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropp ed.
 DO NOT attempt to remove the amplifier chassis. There are no serviceable
parts.
The lightning flash with arrowhead symbol within an equilateral triangle, is intended to
alert the user to the presence of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operation and maintenance (servicing) instructions in the
literature accompanying the product.
GETTING STARTED
FRONT PANEL Controls:
INPUT Jack o input for the amplifier. The input – This ¼” jack is the audi
impedance is 1.5M Ω.
VOLUME Knob Controls the overall loudness and gain of the amplifier. We –
recommend turning down VOLUME prior to applying power. Turn up the
VOLUME knob after the amp has been powered up for at least five seconds.
TONE Knob Alters equency response. Turning this control – the amplifier’s fr
counter-clockwise increases bass and turning it clockwise increases treble.
BITE Knob – Alters the amplifier’s gain level and frequency response.
Turning this control clockwise increases the gain and treble content This .
control is also very interactive with the VOLUME control; changing one
affects the other.
REVERB Knob Controls the volume of the reverb When the reverb –.
footswitch is not connected to the back panel via a ¼” mono instrument
cable, the reverb is always on.
TIME Knob Adjusts the decay time, or reverb length/size, for the SPRING, –
HALL and PLATE reverbs. In REVERSE mode, the TIME knob sets the length
of time between striking a note and the reverb fade-in. While in PLATE
mode, when TIME is set to its maximum position, the reverb decay is over
30 seconds, creating a lush reverb wash with each new note.
Reverb Switch Knob Chooses the reverb mode. From left to right, the –
modes are SPRING, HALL, PLATE, and REVERSE.
REAR PANEL:
AC INLET Plug the power cable into this jack –
FUSE Within the AC inlet jack is the fuse holder To access the fuse, use a –.
small flathead screwdriver to carefully slide the fuse holder out.
100VAC (Japan) ............... 1A / 250V slo-blo 5x20mm fuse
1 VAC (US/Canada) 20 ....... / slo-blo 5x20mm fuse 1A 250V
230VAC (EU/Australia) ...... 50 / slo-blo 5x20mm fuse 0mA 250V
WARNING: The AC voltage rating is marked on the amplifier’s chassis.
Failure to use the appropriate fuse could damage the amplifier.
REVERB FOOTSWITCH This jack is to connect the includ reverb –ed
footswitch via a standard ¼” mono instrument cable, which is also included.
The reverb footswitch allows you to turn the reverb on and off When the .
cable is disconnected from the REVERB FOOTSWITCH jack, the reverb is
always on.
SPEAKER s output jack is for loudspeaker connections only –Thi 8 Ωor 16Ω.
WARNING: Connecting your amp to a speaker cabinet that does not have
the appropriate impedance, or to no cabinet at all, could severely damage
the DIRT ROAD SPECIAL and void your warranty. If you choose to connect
the amplifier to a separate speaker cabinet, be sure to select a cabinet that
can handle the full rated power of 40WRMS.
WARRANTY INFORMATION
Please register online at http://www.ehx.com/product-registration or complete
and return the enclosed warranty card within 10 days of purchase. Electro-
Harmonix will repair or replace, at its discretion, a product that fails to operate
due to defects in materials or workmanship for a period of one year from date of
purchase. This applies only to original purchasers who have bought their product
from an authorized Electro-Harmonix retailer. Repaired or replaced units will then
be warranted for the unexpired portion of the original warranty term.
Produktspezifikationen
| Marke: | Electro Harmonix |
| Kategorie: | Gitarrenverstärker |
| Modell: | Dirt Road Special |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Electro Harmonix Dirt Road Special benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Gitarrenverstärker Electro Harmonix
8 August 2024
19 Dezember 2023
Bedienungsanleitung Gitarrenverstärker
- Gitarrenverstärker Valeton
- Gitarrenverstärker Roland
- Gitarrenverstärker Vox
- Gitarrenverstärker Yamaha
- Gitarrenverstärker Marshall
- Gitarrenverstärker Peavey
- Gitarrenverstärker Fender
- Gitarrenverstärker Behringer
- Gitarrenverstärker Boss
- Gitarrenverstärker Line 6
- Gitarrenverstärker Radial Engineering
- Gitarrenverstärker Hartke
- Gitarrenverstärker ART
- Gitarrenverstärker Orange
- Gitarrenverstärker Harley Benton
- Gitarrenverstärker Blackstar
- Gitarrenverstärker Bugera
- Gitarrenverstärker TC Electronic
- Gitarrenverstärker Palmer
- Gitarrenverstärker Ampeg
- Gitarrenverstärker Laney
- Gitarrenverstärker SPL
- Gitarrenverstärker Ashdown Engineering
- Gitarrenverstärker Suhr
- Gitarrenverstärker AER
- Gitarrenverstärker Markbass
- Gitarrenverstärker EBS
- Gitarrenverstärker Fishman
- Gitarrenverstärker Voodoo Lab
- Gitarrenverstärker GR Bass
- Gitarrenverstärker Two Notes
- Gitarrenverstärker Hughes & Kettner
- Gitarrenverstärker Dimavery
- Gitarrenverstärker AMT
- Gitarrenverstärker Budda
- Gitarrenverstärker Empress Effects
- Gitarrenverstärker DACS Audio
- Gitarrenverstärker Rivera
- Gitarrenverstärker DV Mark
Neueste Bedienungsanleitung fĂĽr -Kategorien-
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
3 Oktober 2024
23 September 2024
19 September 2024
16 September 2024
6 September 2024
5 September 2024