Eaton ETN-TPK608B Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Eaton ETN-TPK608B (11 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/11
1
Installation guide
RE SERIES ENCLOSURE
2
Installation guide
TABLE OF CONTENTS
SAFETY WARNINGS ........................................................................................................ 3
600 WIDE EXPLODED VIEW............................................................................................ 4
800 WIDE EXPLODED VIEW............................................................................................ 5
SWITCHING DOOR HANDING ......................................................................................... 6
STABILIZING ..................................................................................................................... 7
BAYING THE ENCLOSURE.............................................................................................. 8
SIDE PANEL ..................................................................................................................... 9
RACK MOUNT ADJUSTMENT ....................................................................................... 10
3
Installation guide
1. SAFETY WARNINGS
This manual contains important instructions that you should follow during installation and
maintenance of the RE Series Enclosure. Please read all instructions before operating
the equipment and save this manual for future reference.
1. WARNING! RE Series enclosure components can be very heavy. It is recommended
that several people take part in the unpacking process. When lifting heavy
components or electronic equipment, ensure that all safety regulations are observed.
2. WARNING! The enclosure must be stabilized before installing any roll-out type
accessory, component or electronic device. Failure to stabilize prior to installing
equipment may cause the enclosure to tip over.
3. WARNING! First, load the heaviest electronic devices and accessories into the bottom
of the enclosure to prevent the enclosure from becoming top-heavy.
4. WARNING! Never extend more than one roll-out type electronic device or accessory
from a stabilized enclosure at a time. Do not sit, stand, or climb on any extended roll-
out type electronic device or accessory. Never extend a roll-out type electronic device
or accessory component from an enclosure rack that is supported by casters. Doing
so may cause a stabilized enclosure rack to tip over.
5. WARNING! It is the customer’s responsibility to ensure that the floor has a structural
load capacity that will safety bear the weight of the RE series Enclosure and installed
components.
6. WARNING! There must be an uninterruptable safety earth ground from the main
power source to the Power Distribution Unit’s (PDU) power cord set. Whenever it is
likely that ground has been impaired, disconnect the PDU’s power cord until the
ground has been restored.
7. WARNING! High leakage current may be present. Grounding connection essential
before connecting supply.
8. WARNING! Rack is intended to be used with equipment complying with IEC 60950.
Use with non-compliant equipment may result in electrical hazard.
9. WARNING! A grounding kit is pre-installed on RE Series enclosures. The installer is
responsible for grounding the enclosure to the building electrical system. Additional
equipment can be electronically bonded to the rack's frame using additional grounding
points.


Produktspezifikationen

Marke: Eaton
Kategorie: Nicht kategorisiert
Modell: ETN-TPK608B

Brauchst du Hilfe?

Wenn Sie Hilfe mit Eaton ETN-TPK608B benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Eaton

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-