Da-Lite Fast-Fold Bedienungsanleitung
Da-Lite
Projektionsleinwand
Fast-Fold
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Da-Lite Fast-Fold (4 Seiten) in der Kategorie Projektionsleinwand. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/4
INSTRUCTION BOOK FOR
Fast-Fold® Truss Frame
2
Instructions
1. Unfold the 4 sections of truss frame, lock all latches and lay
face up on the loor.
2. Attach top and bottom sections to side sections using speedy
cranks. Observe color tapes so they match.
3. Unfold truss feet located in top and bottom truss sections
to raise frame of the loor.
NOTE 1: Frames have rivnuts at the hinge points on the top
and bottom sections. Insert a speedy crank through the
unthreaded rivnut and tighten into the threaded rivnut.
This will lock hinge joint securely.
NOTE 2: On screens 25' and over, another section of 6" truss
is provided. This section will mount on the top of the TOP
frame section and will appear to make an inverted “L”. “L”
section extends toward back of screen. Fasten top ”L” section
to TOP truss with speedy cranks. Observe color tapes so they
match. Flat steel diagonal braces are provided. These are
attached between the “L” section and the TOP truss frame
section. Tighten all speedy cranks securely.
Attach back braces to the BOTTOM section of the truss frame
section with speedy cranks. Observe color tapes so they
match. Tighten all speedy cranks securely.
4. Attach truss legs to side frame members at desired height,
using speedy cranks. Note color tape on legs and frame.
When matched, the screen height will be 44" of the loor.
If legs are too high, top section or sections may be folded
over. Do not tighten speedy cranks until all are started,
then tighten.
5. Lay the frame on the loor.
6. Match top of screen surface (labeled TOP) with top of frame.
7. Snap all four corners.
8. Starting at the bottom section, snap the center button.
Continue snapping the remaining buttons.
9. Attach Leg to each side of frame using at least 2 Speedy
Cranks per leg. NOTE: Speedy Crank at bottom of leg should
be on side of leg away from screen. Do not tighten Speedy
Cranks until all are started.
10. Height Adjustment. Fast-Fold® Truss screen height is
adjustable in 6" increments either up or down. Normal
screen height is 44" from bottom of frame to loor and
is the standard height for use with presentation
drapery accessories.
NOTE: Do not extend frame so that more than half of the
frame height is above the top of the legs.
11. Raise front foot of each leg and lock corner brace.
12. With one person at each leg, raise to standing position.
NOTE: With very large screens, more than 2 people may be
required.
13. Lower back foot, lock corner brace and attach”A” brace from
rear foot to back member of truss leg.
14. Attach anti-sway braces to legs.
15. To pack, reverse procedure. Use caution to prevent
surface damage.
3
Fast-Fold® Truss Frame Construction
Side Truss
Bottom Truss
Front Foot
Back Foot
Truss Leg
Truss Leg
Screen
Surface
ABrace
Detail Of Corner
Assy. Fasten Trusses
With Speedy Cranks
Make Sure Speedy
Crank Is Inserted
Through All Threaded
Hinge Joints
Anti-Sway Brace
(Mounted Insde When
Used Without Drapes)
Anti-Sway Brace
(Mounted Outside When Used
With Drapes)
Under 25' Wide
Side Truss
Bottom Truss
Front Foot
Back Foot
Screen
Surface
ABrace
Detail Of Corner
Assy. Fasten Trusses
With Speedy Cranks
Make Sure Speedy Crank
Is Inserted Through All
Threaded Hinge Joints
Anti-Sway Brace
(Mounted Insde
When Used
Without Drapes)
Anti-Sway Brace
(Mounted Outside When
Used With Drapes)
25' And Wider
Truss “L” Section
Back Brace
Mounted To Bottom Of
Frame From Behind At
Hinge Locations With
(8) Speedy Cranks Each
Short Speedy Crank
Diagonal Brace
Short Speedy Crank
Assembled End View Of
Frame And "L" Section
Left Side Of Truss
Frame Is Removed For
Better Viewing Of
Truss Leg
Left Side Of Truss
Frame Is Removed
For Better Viewing Of
Truss Leg
Truss Leg
Produktspezifikationen
| Marke: | Da-Lite |
| Kategorie: | Projektionsleinwand |
| Modell: | Fast-Fold |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Da-Lite Fast-Fold benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Projektionsleinwand Da-Lite
7 April 2024
24 Februar 2024
6 Februar 2024
20 Januar 2024
5 Januar 2024
Bedienungsanleitung Projektionsleinwand
- Projektionsleinwand Sony
- Projektionsleinwand Pyle
- Projektionsleinwand Optoma
- Projektionsleinwand Celexon
- Projektionsleinwand Projecta
- Projektionsleinwand AV:link
- Projektionsleinwand Draper
- Projektionsleinwand Oregon Scientific
- Projektionsleinwand Duronic
- Projektionsleinwand Luxburg
- Projektionsleinwand EluneVision
- Projektionsleinwand Stewart
- Projektionsleinwand Elite Screens
- Projektionsleinwand Instaal
Neueste Bedienungsanleitung für -Kategorien-
2 Juni 2024
2 Juni 2024
25 Mai 2024
22 Mai 2024
21 Mai 2024
16 Mai 2024
14 Mai 2024