Da-Lite Designer Electrol Bedienungsanleitung

Da-Lite Projektionsleinwand Designer Electrol

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Da-Lite Designer Electrol (8 Seiten) in der Kategorie Projektionsleinwand. Dieser Bedienungsanleitung war für 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/8

3100 North Detroit Street

Post Office Box 137

Warsaw, Indiana 46581-0137

Phone: 574-267-8101

800-622-3737

Fax: 574-267-7804

Toll Free Fax: 877-325-4832

www.da-lite.com

e-mail: info@da-lite.com

Instruction Book for

DESIGNER ELECTROL®

The Da-Lite Difference.

IMPORTANT SAFETY INSTRUCTIONS

When using your video equipment, basic safety precautions

should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or

contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rat-

ing at least equal to that of the appliance should be used.

Cords rated for less amperage than the appliance may over-

heat.

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric

shock when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by

the manufacturer may cause a risk of fire, electric shock, or

injury to persons.

SAVE THESE INSTRUCTIONS

Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly!

Do not cut wrapping paper or tape with knife or any sharp tool. Pull orange string.CAUTION!

1. Carefully unpack the screen and remove the outer wrapping.

2. Always handle screen in upright position.

3. Remove the front cover of the screen from the back of the screen. Lift front cover up approximately 1/2" and pull

away from back of screen. See Figure 1.

4. There are two methods of mounting the screen: suspended from ceiling and wall mounted. See Figure 2.

NOTE: Allow 1/2" above screen (when mounted) for front cover of screen installation and removal.

5. Picture surface is centered in case. Case extends 5-1/2" beyond surface on either end. Do not attach anything to

screen slat on the bottom of the screen.

PRE-INSTALLATION

HANGER BRACKET

HANGER

FRONT

COVER

BACK OF

SCREEN

PICTURE

SURFACE

PICTURE

SURFACE

PICTURE SURFACE

SLAT

CEILING

WALL MOUNTING CEILING MOUNTING

PLACE “D”

RINGS OVER

HOOKS WELL

SECURED IN

CEILING.

FIGURE 1 FIGURE 2

“V” BAR mOUNTED

TO THE WALL

WALL

“V” BAR

mOUNTED TO

THE BACK OF

THE CASE AT

THE FACTORy

ALLOW A mINImUm OF

1-1/4" FROm CEILING

Produktspezifikationen

Marke:	Da-Lite
Kategorie:	Projektionsleinwand
Modell:	Designer Electrol
Gewicht:	- g
Produktfarbe:	Holz
Befestigungstyp:	Wand
Natives Seitenverhältnis:	4:3
Fernbedienung:	Ja
Diagonal:	81 "
Antriebstyp:	Motorisiert
Gesamte Bildschirmgröße (Höhe x Breite):	178 x 178 cm
Format:	Video
Leuchtdichtefaktor:	1.3
Sichtwinkel:	45 °