Da-Lite 39850CHV Bedienungsanleitung

Da-Lite Monitor 39850CHV

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Da-Lite 39850CHV (8 Seiten) in der Kategorie Monitor. Dieser Bedienungsanleitung war für 43 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/8

INSTRUCTION BOOK FOR

Da-Lift Projector Lift

10M, 15M, 15, 19, 19L

Important Safety Instructions Pre-Installation

When using your video equipment, basic safety precautions

should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or

contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating at

least equal to that of the appliance should be used. Cords rated

for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric shock

when the appliance is used subsequently.

5. The use of an accessory attachment not recommended

by the manufacturer may cause a risk of ire, electric shock,

or injury to persons.

Save These Instructions

This unit must be installed in accordance with the requirements

of the Local Building Codes, the Canadian Electrical Code (CEC),

CAN/CSA C22.1 and the National Electric Code (NEC) NFPA 70.

1. Carefully unpack Da-Lift projector lift.

2. Make sure to recheck measurements of projector lift location

before installation.

Suggested Methods Of Installation

1. Mounting Da-Lift Projector Lift between joists.

Install the joists at the proper height and width to it the Da-Lift

you are installing. See Figure 1.

NOTE: The Da-Lift must be installed on top of the joists.

Be sure to leave access from above for installation.

When the joists are properly installed, and secured in place, slide

the Da-Lift in position. Bolt the two brackets (11/2” x 19”) to the

frame. Lower the unit onto the joists and secure in place.

Additional bracing may be required, based on construction.

NOTE: Da-Lift projector lift must be installed level!

2. Mounting Da-Lift Projector Lift using 1/2” diameter threaded rods.

Secure four 1/2” diameter threaded rods to the ceiling at the

dimensions shown. See Figure 2, “E” and “F”. Install the mounting

bracket (11/2” x 19”) to each side of Da-Lift with 1/2” diameter bolts,

lat washers and nuts. Attach one nut on each rod and run the

nut up to the desired height.

Slide Da-Lift projector lift up with all (4) four threaded rods into

the mounting brackets. Install 1/2” nuts under the mounting

brackets. Adjust the frame to the proper height and level with

bottom nuts on the rod. Lock the mounting brackets in place

with the nuts on the top of each rod. Frame must be level and

solid. Additional bracing may be required, based on construction.

Model Lifting

Capacity

Width

Height

Depth

Height

DIm.

Dim.

Da-Lift 10M 40 lbs. 22⅝” 4½” 24⅛”15” 22” 14”

Da-Lift 15M 40 lbs. 22⅝” 9½” 24⅛”20” 22” 14”

Da-Lift 15 300 lbs. 30¾” 9½” 32¼” 16¼”20” 34”

Da-Lift 19 300 lbs. 32¾” 24” 38” 13½” 34¼” 16¼”

Da-Lift 19L 300 lbs. 42¾” 24” 48” 13½” 44¼” 16¼”

Figure 1 Figure 2

Produktspezifikationen

Marke:	Da-Lite
Kategorie:	Monitor
Modell:	39850CHV
Empfohlene Nutzung:	Flachbildschirm
Produktfarbe:	Holz
Höchstgewichtskapazität:	45.3 kg
Sperren:	Ja
Typ:	Multimedia-Wagen
Eingebautes Ladegerät:	Ja
Schloss Art:	Schlüssel