CyberPower CPS200SI Bedienungsanleitung
CyberPower
Akku
CPS200SI
Lesen Sie kostenlos die đ deutsche Bedienungsanleitung fĂŒr CyberPower CPS200SI (1 Seiten) in der Kategorie Akku. Dieser Bedienungsanleitung war fĂŒr 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/1
Spring
Decorative Ring
Contact Pin
Contact Retainer
15 ampFuse
12V DC Adapter
200 Watt AC Mobile Power Inverter
User Guide
CPS200SI
This guide contains important information regarding the safety, operation, maintenance, and
storage of this product. Failure to read this guide and follow the directions could result in
injury and/or property damage.
Table of Contents
Operating and Storage Tips
Speciîcations
Troubleshooting
DC Fuse Replacement (For Cigar Plug)
Product Limited Warranty
Important Safety Information
Introduction
Package Contents
Product Features (Model CPS200SI)
Product Features (Model CPS200SI) - continued
Operation
Important Safety Information.............................................................. 03
Introduction................................................................................................ 04
Package Contents..................................................................................... 04
Product Features....................................................................................... 05
Operation..................................................................................................... 06
Operating and Storage Tips.................................................................. 07
Speciîcations.............................................................................................. 08
Troubleshooting........................................................................................ 08
DC Fuse Replacement............................................................................. 10
Product Limited Warranty...................................................................... 11
Before installing and using the CyberPower CPS200SI Mobile Power Inverter
please read and follow these safety instructions.
Thank you for choosing the CyberPower CPS200SI AC Mobile Power Inverter. To
enjoy all the features and beneîts of CPS200SI, please read and follow all
instructions completely.
The CyberPower CPS200SI AC Mobile Power Inverter is a plug-and-play, cordless,
portable source of 110/120 volt AC power. The AC Mobile Power converts DC
battery power from your vehicle into standard 110/120 volt AC power, allowing
you to power most notebook computers, cell phone chargers, camcorders, and
other electronic products drawing 200 watts or less of AC power.
Operating Tips
The CPS200SI inverter should only be operated under the following conditions:
Dry - Do not allow water or other liquids to come into contact with the
inverter.
Temperature - Ambient air temperature should be between 32
oF - 86oF
(0 oC - 30oC). Keep the inverter out of direct sunlight.
Air Circulation - Keep the inverter's ventilation slots clear to ensure
free air îow to the unit. Do not place any items on or over the inverter
during operation. The unit will shut down if it overheats.
The CPS200SI contains a fuse inside in the lighter adapter (see Figure 2) to
protect the unit against overloading. If the inverter draws more than 150 watts,
the internal fuse may open to protect the inverter, vehicle battery, and the
connected equipment. To replace the fuse, please follow the instructions below:
1. Unplug the inverter from the power source.
2. Remove the contact retainer from the 12V DC adapter.
3. Replace the 15 amp fuse.
4. Reassemble the fuse, contact pin, and contact screw carefully.
5. Ensure all pieces shown in Figure 2 are installed in the correct sequence.
* Note: For in-warranty units, the replacement fuse can be obtained from CyberPower Technical Support.
CyberPower warrants the CPS200SI ("Inverter") to be free from defect in material or manufacture for
two years. If a defect results in product failure during its normal use, CyberPower's sole
responsibility is to repair or replace (as its sole option) the Inverter.
The foregoing Limited Warranty is the consumer's sole and exclusive remedy and excludes any
incidental or consequential damages. Some States do not allow the exclusion or limitation of
incidental and consequential damages, so certain of the above limitations or exclusions may not
apply to you (the Consumer). This limited warranty gives the Consumer speciîc legal rights and the
Consumer may have other rights, which vary from State to State.
To make a Limited Warranty claim:
1. Pack and ship the Inverter to CyberPower at 5555 12th Ave. E., Suite 110, Shakopee, MN 55379.
2. Clearly indicate on the outside of the packaging that this is a "WARRANTY RETURN"
3. Clearly include your name and address (a) on the outside packaging and (b) on a sheet of paper
enclosed in the box with the Inverter that is being returned.
4. You MUST prepay all shipping costs and you are responsible for packaging and shipment for the
return of the defective product.
Cyber Power Systems (USA), Inc.
5555 12th Avenue East, Suite 110, Shakopee, MN 55379, U.S.A.
TEL: (952) 403-9500 FAX: (952) 403-0009 Toll-Free: (877) 297-6937
E-mail: sales@cyberpowersystems.com Web: www.cyberpowersystems.com
Entire contents copyright C 2007 Cyber Power Systems, Inc.
All rights reserved. Reproduction in whole or in part without permission is prohibited.
1. 12 volt input socket
2. Cooling Fan
3. USB charger port
4. LED indicator light
5. 120 volt AC outlets
6. Ventilation slots
7. AC outlet protection cover
1. Remove the cigarette lighter from the automobile lighter socket and insert the CPS200SI
into your vehicle's lighter socket.
2. First, verify that the product draws 200w or less, then plug in the product.
3. Please make sure the unit is îrmly plugged into your vehicle's lighter socket for proper
operation. You may rotate the plug to make sure there is good contact.
4. An LED light indicates the CPS200SI is operational.
5. To avoid discharging the battery, always remove the CPS200SI plug from the lighter
socket in your vehicle when not in use.
Do not operate the CPS200SI near îammable materials, fumes, or gases.
Always use the inverter where there is adequate ventilation. Do not
obstruct the ventilation slots.
Never immerse the unit in water.
Proper cooling is essential when operating the inverter. Refrain from
placing the inverter near the vehicle's heat vent or in direct sunlight.
Always turn the inverter oî by removing it from the DC accessory socket
when not in use.
Check the warning labels on battery chargers or adapters before
connecting them to the inverter. Do not connect battery chargers or
adapters with warnings about using with inverters.
Please use Clamp Plug if the load is over 150W.
This package includes:
200 Watt AC Mobile Power Inverter
Warranty Registration Card
CPS200SI User Guide
Figure 1. Product Features
Storage Tips
Proper storage temperature range is 50
oF - 85oF (10oC - 28oC)
Please store and use the inverter in a cool and dry place.
Avoid exposing the inverter to heating elements, direct sunlight,
excessive humidity, or dampness.
Clamp Plug Tips
Please use Clamp Plug if the load
is over 150W. Please reference the
installation guide on the right. Installation Guide:
1. Connect the RED cable to the
POSITIVE terminal of the battery.
2. Connect the BLACK cable to the
NEGATIVE terminal of the battery.
Output Power Max 200 Watts
Output Voltage 120 Volts +/- 10%
Output Frequency 60 Hz
Output Waveform Simulated Sine Wave
Input Voltage 10.8 to 15.8 volts
Low Voltage Shutdown 10.5 volt
Problem
No AC output power
(Power indicator is not
illuminated)
Poor contact with lighter socket.
Automotive electrical system
requires ignition to be on.
Car's lighter socket fuse is blown.
Over-heating.
Vehicle's battery voltage is
below 10.8 volts.
Your vehicle's battery input
voltage is below 10.8 volt.
Vehicle's battery input voltage is
higher than 15.8 volt.
Inverter is overloaded.
Ensure the inverter adapter is securely
plugged into vehicle's lighter socket.
Replace the lighter socket if necessary.
Turn the vehicle ignition key to the
"Accessory" position.
Check the vehicle fuse panel and
replace the damaged fuse.
Allow inverter to cool down. Ensure
that there is adequate ventilation
around the unit. if the load is between
150 watts to 200 watts, use the clamp
plug. Do not use if the load is over 200
watts.
Unplug the inverter and start the
vehicle to charge the battery.
Check vehicle's battery and verify it is fully
charged. Change vehicle's battery if
necessary.
Check your vehicle's user guide for
troubleshooting.
Reduce the connected equipment to 200
watts or less.
Suggested SolutionsPossible Cause
Short/Long Beep
Figure 2. Fuse Replacement
K01-0000013-00
11
10
9
5
6
4
3
8
7
1 2 3
5
4
6
7
Battery
Red
Black
Produktspezifikationen
| Marke: | CyberPower |
| Kategorie: | Akku |
| Modell: | CPS200SI |
Brauchst du Hilfe?
Wenn Sie Hilfe mit CyberPower CPS200SI benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Akku CyberPower
24 September 2024
24 September 2024
24 September 2024
24 September 2024
24 September 2024
21 September 2024
21 September 2024
21 September 2024
21 September 2024
7 September 2024
Bedienungsanleitung Akku
- Akku Hama
- Akku Kensington
- Akku Nedis
- Akku Trust
- Akku Watson
- Akku Panasonic
- Akku LG
- Akku Bosch
- Akku Vonroc
- Akku Canon
- Akku Conrad
- Akku Cocraft
- Akku Ryobi
- Akku Skil
- Akku Carat
- Akku Hilti
- Akku DeWalt
- Akku Einhell
- Akku Worx
- Akku Fuxtec
- Akku Kress
- Akku Varta
- Akku Biltema
- Akku Epson
- Akku TOA
- Akku Tripp Lite
- Akku Ansmann
- Akku Petzl
- Akku Husqvarna
- Akku Scosche
- Akku Stihl
- Akku Genaray
- Akku Fujifilm
- Akku Nikon
- Akku DJI
- Akku Stiga
- Akku Leica
- Akku Greenworks
- Akku PNY
- Akku Xtorm
- Akku Techly
- Akku Vetus
- Akku Monacor
- Akku Milwaukee
- Akku Toolcraft
- Akku Victron Energy
- Akku Fein
- Akku EGO
- Akku Gardena
- Akku HQ
- Akku Cobra
- Akku Powerplus
- Akku Digitus
- Akku APC
- Akku McCulloch
- Akku Ozito
- Akku Deltaco
- Akku Speed-Link
- Akku Fluke
- Akku Hikvision
- Akku EnerGenie
- Akku HĂ€hnel
- Akku Ultron
- Akku Cortina
- Akku Berg
- Akku Energizer
- Akku Neewer
- Akku Stinger
- Akku Sungrow
- Akku Growatt
- Akku Aluratek
- Akku Inovonics
- Akku SolarEdge
- Akku Arris
- Akku Duracell
- Akku Arctic Cooling
- Akku Wentronic
- Akku SOUNDBOKS
- Akku PowerBass
- Akku BlackVue
- Akku E-flite
- Akku For_Q
- Akku Bolt
- Akku Anton/Bauer
- Akku Anova
- Akku Lenmar
- Akku Verico
- Akku APSystems
- Akku Enphase
- Akku A-solar
- Akku Valcom
- Akku Impact
- Akku Team Orion
- Akku Red Power
- Akku Whistler
- Akku PowerDrive
- Akku Fxlion
- Akku TCW Technologies
- Akku Tecnoware
- Akku Ventev
Neueste Bedienungsanleitung fĂŒr -Kategorien-
8 Oktober 2024
6 Oktober 2024
Arris SURFboard Touchstone Battery BPB022S Bedienungsanleitung
29 September 2024
16 September 2024
15 September 2024
14 September 2024
8 September 2024
6 September 2024
6 September 2024
6 September 2024