CyberPower CPS140BI Bedienungsanleitung
CyberPower
Akku
CPS140BI
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für CyberPower CPS140BI (2 Seiten) in der Kategorie Akku. Dieser Bedienungsanleitung war für 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/2
140î˜ Wattî˜ ACî˜ Mobile Powerî˜ Inverter
Userî˜ Guide
Figureî˜ 1.î˜ Productî˜ Feature
2004-5-075/front K
Output Power 140 Watts Continuous
Output Voltage 120 Volts +/- 10%
Output Frequency 60 Hz
Output Waveform Simulated Sine Wave
Input Voltage 10.8 to 15.8 volts
Low Voltage Shutdown 10.5 volt
Problem Possible Cause Suggested Solutions
No AC output power
(Power indicator is not
illuminated)
Poor contact with lighter socket
Automotive electrical systems
requires ignition to be on.
Car s lighter soc ket fuse blown
Over-heating
Vehicle s battery below 10.8
volts.
Ensure the inverter adapter is securely
plugged into vehicle s lighter socket.
Replace the lighter socket if necessary.
Turn the vehicle ignition key to the
Accessory position.
Check the vehicle fuse panel and replace
the damaged fuse.
Allow inverter to cool down. Ensure that
there is adequate ventilation around the
unit and load is no more than 140 watts for
continuous operation.
Unplug the inverter and charge the vehicle
battery.
Short/Long Beep Your vehicle s battery input
voltage is below than 10.8 volt.
Vehicle s battery input voltage
is higher than 15.8 volt.
Inverter is overload.
Check vehicle s battery and ensure its
capacity. Change vehicle s battery if
necessary.
Check for your vehicle s battery
manufacturer guideline.
Reduce load to 140 watts max to maintain
regulation.
Contactî˜ Screw
Spring
Contactî˜ Pin
Fuse
Decorativeî˜ Ring
Lighterî˜ Adapter
CPS140BI contains a fuse inside in the Lighter Adapter (see Figure 2) to protect the unit against
overloading. If the inverter draws more than 140 watts, the internal fuse may be blownto protect
the inverter, vehicle battery and the connected equipment. To replace the fuse, please follow the
instruction below:
1. Unplug the inverter from the power source.
2. Remove the Contact Screw from the Lighter Adapter.
3. Replace the 15 ampere fuse.
4. Reassemble the fuse, contact pin and contact screw carefully.
5. Ensure all pieces showed in Figure 2 are installed in the sequence shown.
*Note: For in-warranty units, the replacement fuse can be obtained from CyberPower
Technical Support. For out-of-warranty units, the replacement 15 ampere fuse can be obtained
from most electronic supply retailers.
WARRANTY RETURN
Cyber Power Systems, Inc.
5555 12th Avenue East, Suite 110, Shakopee, MN 55379, U.S.A.
TEL: (952) 403-9500 FAX: (952) 403-0009 Toll-Free: (877) 297-6937
E-mail: sales@cyberpowersystems.com Web: www.cyberpowersystems.com
Entire contents copyright îš©2004 Cyber Power Systems, Inc.
All rights reserved. Reproduction in whole or in part without permission is prohibited
K01-BT14000
C
2004-5-075/ Kback
Produktspezifikationen
| Marke: | CyberPower |
| Kategorie: | Akku |
| Modell: | CPS140BI |
Brauchst du Hilfe?
Wenn Sie Hilfe mit CyberPower CPS140BI benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Akku CyberPower
24 September 2024
24 September 2024
24 September 2024
24 September 2024
24 September 2024
21 September 2024
21 September 2024
21 September 2024
21 September 2024
7 September 2024
Bedienungsanleitung Akku
- Akku Hama
- Akku Kensington
- Akku Nedis
- Akku Trust
- Akku Watson
- Akku Panasonic
- Akku LG
- Akku Bosch
- Akku Vonroc
- Akku Canon
- Akku Conrad
- Akku Cocraft
- Akku Ryobi
- Akku Skil
- Akku Carat
- Akku Hilti
- Akku DeWalt
- Akku Einhell
- Akku Worx
- Akku Fuxtec
- Akku Kress
- Akku Varta
- Akku Biltema
- Akku Epson
- Akku TOA
- Akku Tripp Lite
- Akku Ansmann
- Akku Petzl
- Akku Husqvarna
- Akku Scosche
- Akku Stihl
- Akku Genaray
- Akku Fujifilm
- Akku Nikon
- Akku DJI
- Akku Stiga
- Akku Leica
- Akku Greenworks
- Akku PNY
- Akku Xtorm
- Akku Techly
- Akku Vetus
- Akku Monacor
- Akku Milwaukee
- Akku Toolcraft
- Akku Victron Energy
- Akku Fein
- Akku EGO
- Akku Gardena
- Akku HQ
- Akku Cobra
- Akku Powerplus
- Akku Digitus
- Akku APC
- Akku McCulloch
- Akku Ozito
- Akku Deltaco
- Akku Speed-Link
- Akku Fluke
- Akku Hikvision
- Akku EnerGenie
- Akku Hähnel
- Akku Ultron
- Akku Cortina
- Akku Berg
- Akku Energizer
- Akku Neewer
- Akku Stinger
- Akku Sungrow
- Akku Growatt
- Akku Aluratek
- Akku Inovonics
- Akku SolarEdge
- Akku Arris
- Akku Duracell
- Akku Arctic Cooling
- Akku Wentronic
- Akku SOUNDBOKS
- Akku PowerBass
- Akku BlackVue
- Akku E-flite
- Akku For_Q
- Akku Bolt
- Akku Anton/Bauer
- Akku Anova
- Akku Lenmar
- Akku Verico
- Akku APSystems
- Akku Enphase
- Akku A-solar
- Akku Valcom
- Akku Impact
- Akku Team Orion
- Akku Red Power
- Akku Whistler
- Akku PowerDrive
- Akku Fxlion
- Akku TCW Technologies
- Akku Tecnoware
- Akku Ventev
Neueste Bedienungsanleitung für -Kategorien-
8 Oktober 2024
6 Oktober 2024
Arris SURFboard Touchstone Battery BPB022S Bedienungsanleitung
29 September 2024
16 September 2024
15 September 2024
14 September 2024
8 September 2024
6 September 2024
6 September 2024
6 September 2024