Command 17617B Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Command 17617B (1 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
WATER-RESISTANT STRIPS
IMPORTANT: FOLLOW instructions carefully!
SAVE INSTRUCTIONS for clean removal in the future or visit www.commandstrips.ca.
S
L
O
W
L
Y
Alcohol
Prep Pad
A
A
B
ABB
A
B
AB10
A B A B
A B
1
HOUR
24
HOURS
1
2
3
11
12 13
Separate & Apply Strips
Separate strips red liners. Remove .
Apply 2 strips to mounting base A
only side A. Remove black liners on
of the caddy.
Select Location
If possible, choose a location where
strips are not over grout lines.
Important: Allow space above
and below caddy for removal.
Apply Mounting Bases
Slide plastic mounting base onto back of
caddy from the bottom up until it snaps
into place for both sides A & B.
Slide & Press
Position of the caddy against side B
the wall so that is not touching the side A
other wall. Holding against the side B
wall, slide the caddy sideways into place
so that touches the wall and press side A
firmly against surface for 5 seconds.
To Attach Corner Caddy:
Prep:
Mount:
Wait:
Attach Caddy
While keeping away from the wall, side B
slide caddy back onto mounting base A
until it snaps into place.
Position & Press
Press against the surface for 5 seconds.
Important: Clean & Dry Surface
Thoroughly clean surface with isopropyl
rubbing alcohol to remove all soap,
shampoo and cleaner residue. Use a clean,
dry cloth to wipe surface completely dry.
DO NOT Keep use household cleaners.
alcohol pad out of reach of children and
avoid eye contact.
Remove Caddy
Slide caddy up to remove from
mounting bases.
Hold Base Lightly
To prevent base from snapping your
fingers, lightly hold mounting base –
DO NOT press base against wall.
To Remove:
Remove Strip
NEVER pull strip out at an angle.
Strip could break or damage surface.
SLOWLY slide tab STRAIGHT DOWN
AGAINST WALL stretching strip at least
15 inches (38 cm) until mounting base
releases from wall. Remove one strip at a
time. Repeat steps with additional strips.
Remove Caddy
Slide caddy up to remove from
mounting base.
Separate & Apply Strips
Separate strips red liners. Remove .
Apply 2 strips to mounting base B.
Remove black liners on side B
of the caddy.
Attach Caddy
Slide caddy back onto both mounting
bases until it snaps into place.
If mounting in a shower or tub area:
USE SHOWER AT LEAST ONCE
AND THEN WAIT OVERNIGHT to
allow adhesive to build strength before
attaching corner caddy.
If mounting outside of shower or tub
area: WAIT 1 HOUR to allow adhesive
to build strength before attaching
corner caddy.
Press Firmly
Use your palm to FIRMLY press
all 3 areas of both bases for
30 seconds each.
or
Remove Caddy
Slide caddy up to remove from
mounting bases.
CAUTI ON: Caddy must be removed for time
specified in step 12 to prevent adhesive failure.
17617B


Produktspezifikationen

Marke: Command
Kategorie: Nicht kategorisiert
Modell: 17617B

Brauchst du Hilfe?

Wenn Sie Hilfe mit Command 17617B benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Command

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-