Coleman Ciqala Bedienungsanleitung

Coleman Zelt Ciqala

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Coleman Ciqala (2 Seiten) in der Kategorie Zelt. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
5. Insert metal tip on gray ridge pole into metal
grommet located at front of tent. (Fig. 2)
6. Insert one end of front and center black poles
into pins in front corner and side of tent.
(Fig. 3 & 3A)
7. Go to opposite end of each pole and gradually
apply pressure to the poles forming arches.
Insert the pin into the pole end at the front
corner and side of tent. (Fig. 3)
8. Go to back of tent and gradually apply pressure on
the gray ridge pole forming an arch; then insert metal
tip of pole into metal grommet om web strap at
back of tent. (Fig. 3)
9. Stretch corners and sides of tent until floor is
taut then hammer stakes through loops to secure.
(Fig. 3B)
STITCH LINE
CIQALATM TENT 12’ X 10’
MODEL 2000001109
Before you begin
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface
with the door facing the desired direction.
2. Assemble the interlocking shock-corded poles (two
black main tent poles and the gray ridge pole).
3. Insert both, long, black poles through sleeves in
top front and center locations on tent as shown.
(Fig. 1)
4. Insert the gray ridge pole through sleeve on top
of tent that runs from front to back. (Fig. 1)
Fig. 3
Parts and Components
Description Part Number
Main Poles, Long, Black (2) 5010000386
Ridge Pole, Gray (1) 5010000387
Back Awning Pole w/Metal Tips, Black (1) 5010000388
Front Awning Pole, Long, Black (1) 5010000389
Rainfly 5010000400
To Attach Rainfly
1. Assemble long, thin, black interlocking shock-corded front awning pole.
2. Unfold rainfly. Locate the sleeve, along front edge, and the hook & loop fasteners on the underside of rainfly.
3. Drape rainfly over tent. Make sure the sleeve is centered over the door and the hook & loop fasteners, on the underside of the rain-
fly, are positioned over the black main poles and gray pole. (Fig. 4)
4. Slide front awning pole through sleeve at front of the rainfly. (Fig. 4)
5. Insert one end of front awning pole into pin in front corner of tent. (Fig. 5A)
6. Go to opposite end of front awning pole and gradually apply pressure until pole forms an arch. Insert the pin into
the pole end at the front corner of tent (Fig. 5 & 5B). Drive stakes through straps on vestibule flap. (Fig. 5C)
(continued on other side)
Fig. 1
Door (Front of Tent)
Fig. 4
Front Awning
Pole
Sleeve on Front
of Rainfly
Long, Black,
Shock-corded
Main Poles
3B
Gray, Shock-corded Ridge Pole
3A
Gray Ridge Pole in Front &
Back Metal Grommets
Door
Fig. 5
5A
5B
Vestibule Flap
5C
Fig. 2
STITCH LINE
To Attach Rainfly continued
To Store
1. All metal poles and stakes must to be placed in the storage
bag to prevent damage to the fabric items placed in the
carry case.
2. Make sure tent is clean and dry before placing in carry case.
3. Remove rainfly, spread out on floor of tent, then unzip
door & vents before taking tent down for storage.
4. Neatly fold tent to width of pole storage bag, place on tent,
roll tightly, and place in carry case.
5. Store in a clean, dry area.
12/07
7. Assemble the interlocking, shock-cord-
ed back awning pole, with metal
tips on the angled end pieces.
8. Insert back awning pole through
sleeve in rainfly awning at back of tent
as shown. (Fig. 6)
9. Insert metal tip, on back awning pole,
into metal grommet in upper corner.
(Fig. 6 & 6A)
10. Go to opposite end of back awning
pole and gradually apply pressure to the
pole to form an arch. Insert the metal
tip on the awning pole into the metal
grommet. (Fig. 6)
11. Locate all hook & loop fasteners on
seams on underside of rainflay and
wrap around black main poles to
secure. (Fig. 7A)
12. Tie guylines through loops on web
straps on the rainfly. (Fig. 7 & 7B)
13. Stretch guylines until taut, then
secure with stakes. (Fig. 7C)
Things You Should Know:
•Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by
water vapor from your breath, perspiration, or any wet clothing inside
the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized
by removing wet clothing from your tent and by providing good ventila-
tion through the tent.
•Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT TO REMOVE STAKE.
•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
•Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Electrical Cord Access
1. Unzip access panel in the lower
left corner of tent and bring in
electrical cord. Use only UL approved
cords that are rated for outdoor
usage. (Fig. 10)
Fig. 10
Fig. 7
Cooler Access
The smaller zippered opening at the
rear of the tent is designed for added
ventilation and easy access to your
beverage cooler.
1. To use as a vent, unzip flap to
expose screen. (Fig.8)
2. To use as a cooler access, unzip
other flap to make an avenue to
bring beverages into the tent.
(Fig.9)
Fig. 8
Fig. 9
7A
Black
Main
Pole
7B
Back Window
Back Window
Vent of Tent
Vent of Tent
6A
Front Door &
Vestibule of Tent
Back Awning &
Window Vent
of Tent
Side View of Tent
Grommet
Back
Awning Pole
Sleeve in Rainfly
Awning
Back Awning
Pole
7B
Fig. 6
Underside
of Rainfly 7C
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
Sunbeam Corporation (Canada) Limited
DBA Jarden Consumer Solutions
20B Hereford Street • Brampton, ON L6Y 0M1
1 800 387-6161 • www.colemancanada.ca
FABRIQUÉE EN CHINE • IMPRIMÉ EN CHINE
© 2007 The Coleman Company, Inc.
Coleman®et sont des marques déposées de The Coleman Company, Inc.


Produktspezifikationen

Marke: Coleman
Kategorie: Zelt
Modell: Ciqala

Brauchst du Hilfe?

Wenn Sie Hilfe mit Coleman Ciqala benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Zelt Coleman

Bedienungsanleitung Zelt

Neueste Bedienungsanleitung für -Kategorien-