Chief SSB058 Bedienungsanleitung

Chief Projektorzubehör SSB058

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Chief SSB058 (1 Seiten) in der Kategorie Projektorzubehör. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/1

I N S T A L L A T I O N I N S T R U C T I O N S

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use

of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or

implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

8850-000050 Rev01

a Duchossois Group Company

05/09

SSB-058, SSM-058, SLB-058 and SLM-058 Interface Brackets

SSB-058, SSM-058, SLB-058 and SLM-058 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific installation

instructions provided with the mount for additional installation information. Unpack carton and verify kit contents. If any listed parts are missing,

immediately contact a Chief Customer Service representative.

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE

TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!

Installation Instructions

WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE

TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.

NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.

1. Screw thumb screws onto the 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.

2. Turn projector upside down on a flat surface.

3. Place the nylon spacers over the threaded inserts in the bottom of the projector (i.e., position them so the short one is on the raised surface and

the other two are on the lower surface to keep the bracket level).

4. Place the interface bracket onto the nylon spacers on the bottom of the projector and align the mounting holes in the bracket with the nylon spacers.