Camec IWH-1.5 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Camec IWH-1.5 (12 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/12
1
IWH-1.5 Instantaneous Gas Water Heater
Installation and Operating Instructions
2
IWH-1.5 Instantaneous Gas Water Heater
Installation and Operating Instructions Version 11.5
Part Numbers: 043993 (Black Door); 042793 (White Door)
The IWH-1.5 instantaneous water heater designed according the Australian Standards for is
installation in recreational vehicles. This water heater is not for use in space heating or
marine application.
WARNING: If the information in these instructions is not followed exactly,
a re or explosion may result causing property damage, personal injury or loss of life.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Evacuate all persons from the caravan or RV.
Shut o the gas supply at the gas container or source.
Do not touch any electrical switch, or use any phone or radio in the vehicle.
Do not start the vehicle’s engine or electric generator.
Contact the nearest gas supplier or qualied service technician for repairs.
If you cannot reach a gas supplier or qualied service technician, contact the
nearest re station or emergency services.
Do not turn on the gas supply until the gas leak(s) has been repaired.
Installation and service must be performed by a qualied installer, service agency, OEM
or the gas supplier.
To avoid scalding, water supplied to the shower and hand basin should pass
through a tempering valve to restrict the water temperature to 50 degrees C.
We recommend the John Guest tempering valve 12mm code 042586.
WARNING: Installation of this product must comply with the requirements of
AS/NZS 3500.4
WARNING: Do not block any pressure relief valves if tted when installing
this Hot Water System.
3
Critical Installation Warnings
The pressure test screw must be properly tightened and the unit leak tested, prior to
starting or commissioning the unit.
Install in recreation vehicles only. RV’s are recreation vehicles designed as temporary
living quarters for recreation, camping, or travel use having their own power or towed by
another vehicle.
All combustion air must be supplied from outside the RV, and all products of combustion
must be vented to outside the RV.
DO NOT vent water heater with venting system serving another appliance.
DO NOT vent water heater to an outside enclosed porch area.
Protect building materials from ue gas exhaust.
Install water heater on an exterior wall, with access door opening to outdoors.
DO NOT modify water heater in any way.
DO NOT alter water heater for a positive grounding system.
DO NOT HI-POT water heater unless electronic ignition system (circuit board) has been
disconnected.
DO NOT use battery charger to supply power to water heater even when testing.
Do not install close to opening door or under room slide-out where the vent or inlet louvers
can be obstructed.
This appliance shall be installed by authorised persons only and in accordance with these
installation instructions, AS5601.2, local gas tting regulations, municipal building codes,
electrical wiring regulations, local water supply regulations and any other statutory
regulations.
● Remove every packaging and transit protection in- and outside of the water heater
This appliance shall be installed by authorised persons only and in accordance with these
installation instructions, AS5601.2, local gas tting regulations, municipal building codes,
electrical wiring regulations, local water supply regulations and any other statutory
regulations.
Installation Instructions for the IWH-1.5 Water Heater
The IWH-1.5 water heater is designed to be installable and removable from the exterior of
the vehicle. The mounting instructions are for the PrecisionTemp surface mount door. No
other door should be used. Doing so will void the warranty and cause the heater to
malfunction and could cause damage or injury.
Please read these instructions before making any modications to the construction of your
caravan or RV.
Selecting Installation Location
Review the following guidelines carefully before choosing the location for the water heater
and ensure the location complies with the requirements of the current edition of AS5601.2
before installation. The water heater must not be installed in an area where the vent can be
covered when any door or access panel on the coach is opened. The water heater should be
located in an area where leakage will not result in damage to other items of, or in the
structure. If such an area cannot be avoided, it is recommended that a suitable pan and drain
be installed under the heater.
Install the heater as close to the gas supply as practical to minimize length of the gas line.
There must be a minimum of 250 mm of clearance between the vent cover and any other
surface. Do not install the unit where the vent is within 0 mm any window or opening 40 of
into the caravan or recreational vehicle (RV). Do not block or restrict the door louvers, this
will damage the IWH-1.5.


Produktspezifikationen

Marke: Camec
Kategorie: Nicht kategorisiert
Modell: IWH-1.5

Brauchst du Hilfe?

Wenn Sie Hilfe mit Camec IWH-1.5 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Camec

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-