Boss CAM22 Bedienungsanleitung

Boss Dashcam CAM22

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Boss CAM22 (2 Seiten) in der Kategorie Dashcam. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
Specifications
The above parameters can ba modified without separate notification
Images sensors: PC1030 MT9V136 PC3030
Power upply: DC9V - 15V
Lens Angle(Deg.): 170
TV System: PAL/NTSC
Video Output: 1.0vp-p,75ohm
S/N Ratio: 48dB
IP rating: IP68
Operating -30 ~ +70 RH95%MAX.
White Balance: Auto
Minimum illumination: 0.5Lux
AGC: Auto
Electronic shutter 1/60(NTSC) 1/50(PAL)
Effective pixels: 656*492
Resolution(TV Lines): 420 480
1/10,000second
Temperature(Deg.C):
User Manual
Mini Rear-view
Flush Mount Camera
Model : CAM22
Thank you for choosing Boss Audio.
DO NOT FULLY RELY ON THE REVERSE
CAMERA WHEN BACKING UP, know your
surroundings before backing.
142*100mm
Simple Troubleshooting Guide
Image Blurring
Please check if there is water stain or dust on
the camera.
.
Image Shaking Please adjust and fix-up
.
No Image.
Please check if the power cable is well connected.
.
Note:
If any of the problems persist after check list had been made, consult your nearest
service dealer. Never attempt to disassemble your unit by yourself.
The following checklist might help to solve the problems which you meet when using
the unit. Please double check and make sure if the connection and the procedure of
the operation is done properly before using the checklist .below
Problem Cause/Solution
Image Slanting Please adjust the bracket of camera
.
Please make sure good connection between the
video in and the monitor.
.
Please check if reverse gear is in place.
.
Please make sure correct setup of monitor.
.
Please make sure cleaness of the camera lens.
.
Red and black back lights 12V Line
DC 12V
DC 12V
AV
Power / video
Camera
Complete all of the required connections in the way that make all the lines
hided in the car.
Installation
1. Wire connection
2. Installation
The camera can be installed in the f ollowing way:
Flush-mount (see diagram 1)
Flush-mount: Install by drilling a hole on the rear bumper.
Attention: The camera switch is controlled by the reverse gear shift.
Car body
(diagram 1)


Produktspezifikationen

Marke: Boss
Kategorie: Dashcam
Modell: CAM22

Brauchst du Hilfe?

Wenn Sie Hilfe mit Boss CAM22 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Dashcam Boss

Bedienungsanleitung Dashcam

Neueste Bedienungsanleitung für -Kategorien-