Bellman BE1443 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Bellman BE1443 (16 Seiten) in der Kategorie Sicherheit. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/16
N3583
US IPNMO01BERXT2 IC 66P3A-BERXT2
Flash Receiver
Model BE1442
input 7.5V 1500mA
For indoor use only
Made in the PRC
Flash Receiver
BE1442/1443
C
M
Y
CM
MY
CY
CMY
K
front-fold-5.pdf 1 10/29/2012 3:03:54 PM
1
Flash Receiver
BE1441
1
2
4 5 6
7
8
9
10
16
12
3
17
C
M
Y
CM
MY
CY
CMY
K
front-fold-6.pdf 1 2013/11/27 11:41:46
2
Appendix - Further information
Settings
No adjustments are required for normal use. The relevant descriptions are provided below,
if you wish to change a setting for some reason.
Radio key
In order to use several Bellman Visit Systems close to one another without interference,
dierent Radio Keys can be set on the dierent systems. All Bellman Visit System units are
supplied from the factory tuned to the same Radio Key, channel 0. This means that all Radio
Key Switches on the transmitters are set to the OFF position.
A Bellman Visit transmitter is also required to alter the radio key on the Bellman Visit Flash
Receiver. Proceed as follows to change the Radio Key:
ï‚¢ Set a Bellman Visit Transmitter to the desired Radio Key by altering its Radio Key
Switch to the desired Radio Key. See the transmitter user manual for further information.
ï‚¢ Hold down the Test Button (9) on the Bellman Visit Flash Receiver until the green
and yellow LEDs blink alternately. The Bellman Visit Flash Receiver will now be in
programming mode for about 30 seconds.
 Press the Bellman Visit transmitter’s test button.
 The LEDs will now blink ve times in quick succession to indicate a
successful change of radio key.
ï‚¢ After changing the radio key, the Bellman Visit Flash Receiver will automatically return
to normal mode.
Please note: all Bellman Visit products within a system must be tuned to the same Radio
Key in order to operate as a group.
Signal pattern
A Signal Pattern is the name for the way in which a receiver in the Bellman Visit System indi-
cates activation. Changing the transmitters’ Signal Switch changes the Signal Pattern which
the receivers display when the transmitter is activated.
The following signal patterns are available for the Bellman Visit System: (Please note that
the Flash Receiver does not emit any sound):
3
GB


Produktspezifikationen

Marke: Bellman
Kategorie: Sicherheit
Modell: BE1443

Brauchst du Hilfe?

Wenn Sie Hilfe mit Bellman BE1443 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Sicherheit Bellman

Bedienungsanleitung Sicherheit

Neueste Bedienungsanleitung für -Kategorien-