Alpha Carbon X Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Alpha Carbon X (21 Seiten) in der Kategorie Rolle. Dieser Bedienungsanleitung war für 18 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/21
Please note that there must be forward momentum for the motor to activate
Carbon Fiber Electric Scooter
Carbon
Appearance may vary slightly
User Manual
[Revision 20238 .0 May ]
READ THIS MANUAL CAREFULLY BEFORE USE FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY –
DAMAGE AND MAY VOID WARRANTY. • . • Products covered by KEEP THIS MANUAL FOR FUTURE REFERENCE
this manual may vary in appearance, assembly, inclusions, specifications, description, and packaging.
Carbon Fiber Electric Scooter Carbon X-
E&OE © 2 2023 Alpha Scooters
Safety
Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or
equipment or property damage if not understood or followed. Safety messages have the following symbols:
You WILL be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be INJURED if you do
not follow instructions or equipment
damage may occur.
It is vital that you read and understand this
user manual before using the product,
including safety warnings, and any assembly
and operating instructions. Keep the manual
for future reference.
Safety precautions and recommendations
detailed here must be fully understood and
followed to reduce the risk of injury, fire,
explosion, electrical hazard, and/or property
damage.
Safety information presented here is generic
in nature – some advice may not be
applicable to every product. The term
"equipment" refers to the product, be it
electrical mains powered, battery powered or
combustion engine powered.
• - If you are not familiar with the Before Use
safe operation/handling of the equipment or
are in any way unsure of any aspect of
suitability or correct use for your
application, you should complete training
conducted by a person or organization
qualified in safe use and operation of this
equipment, including fuel/electrical handling
and safety.
• Do NOT operate the equipment in
flammable or explosive environments, such
as in the presence of flammable liquids,
gases or dust. The equipment may create
sparks or heat that may ignite flammable
substances.
• Keep clear of moving parts.
• Equipment may be a potential source of
electric shock or injury if misused.
• Do NOT operate the equipment if it is
damaged, malfunctioning or is in an
excessively worn state.
• Do NOT allow others to use the equipment
unless they have read this manual and are
adequately trained.
• Keep packaging away from children - risk
of suffocation! Operators must use the
equipment correctly. When using the
equipment, consider conditions and pay
due care to persons and property.
General Work Area Safety
• Work areas should be clean and well it.
• Do not operate the equipment if
bystanders, animals etc are within
operating range of the equipment or the
general work area.
• If devices are provided for connecting dust
extraction / collection facilities, ensure
these are connected and used properly.
Dust collection can reduce dust-related
hazards.
General Personal Safety
• Wear appropriate protective equipment
when operating, servicing, or when in the
operating area of the equipment to help
protect from eye and ear injury, poisoning,
burns, cutting and crush injuries. Protective
equipment such as safety goggles,
respirators, non-slip safety footwear, hard
hat, hearing protection etc should be used
for appropriate equipment / conditions.
Other people nearby should also wear
appropriate personal protective equipment.
Do not wear loose clothing or jewellery,
which can be caught in moving parts. Keep
hair and clothing away from the equipment.
• Stay alert and use common sense when
operating the equipment. Do not over-
reach. Always maintain secure footing and
balance.
• Do not use the equipment if tired or under
the influence of drugs, alcohol or
medication.
• This equipment is not intended for use by
persons with reduced physical, sensory or
mental capabilities.
General Fuel Safety
• Petrol/fuel/gasoline is extremely flammable
– keep clear of naked flames or other
ignition sources.
• Do not spill fuel. If you spill fuel, wipe it off
the equipment immediately – if fuel gets on
your clothing, change clothing.
• Do NOT smoke near fuel or when
refuelling.
• Always shut off the engine before
refuelling.
• Do NOT refuel a hot engine.
• Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly.
• Always refuel in well ventilated areas.
• Always check for fuel leakage. If fuel
leakage is found, do not start or run the
engine until all leaks are fixed.
General Carbon-Monoxide Safety
• Using a combustion engine indoors CAN
KILL IN MINUTES. Engine exhaust
contains carbon-monoxide – a poison you
cannot smell or see.
• Use combustion engines OUTSIDE only,
and far away from windows, doors and
vents.
General Equipment Use and Care
• The equipment is designed for domestic
use only.
• Handle the equipment safely and carefully.
• Before use, inspect the equipment for
misalignment or binding of moving parts,
loose components, damage or any other
condition that may affect its operation. If
damaged, have the equipment repaired by
an authorised service centre or technician
before use.
• Prevent unintentional starting of the
equipment - ensure equipment and power
switches are in the OFF position before
connecting or moving equipment. Do not
carry equipment with hands or fingers
touching any controls. Remove any tools or
other items that are not a part of the
equipment from it before starting or
switching on.
• Do not force the equipment. Use the
correct equipment for your application.
Equipment will perform better and be safer
when used within its design and usage
parameters.
• Use the equipment and accessories etc. in
accordance with these instructions,
considering working conditions and the
work to be performed. Using the equipment
for operations different from those intended
could result in hazardous situations.
• Always keep equipment components
(engines, hoses, handles, controls, frames,
housings, guards etc) and accessories
(cutting tools, nozzles, bits etc) properly
maintained. Keep the equipment clean and,
where applicable, properly lubricated.
• Store the equipment out of reach of
children or untrained persons. To avoid
burns or fire hazards, let the equipment
cool completely before transporting or
storing. Never place or store the equipment
near flammable materials, combustible
gases or liquids etc.
• The equipment is not weather-proof, and
should not be stored in direct sunlight, at
high ambient temperatures or locations that
are damp or humid.
• Do not clean equipment with solvents,
flammable liquids or harsh abrasives.
• For specific equipment safety use and care,
see Equipment Safety.
Carbon Fiber Electric Scooter Carbon X-
E&OE © 3 2023 Alpha Scooters
General Electrical Safety
• Inspect electrical equipment, extension
cords, power bars, and electrical fittings for
damage or wear before each use. Repair or
replace damaged equipment immediately.
• Ensure all power sources conform to
equipment voltage requirements and are
disconnected before connecting or
disconnecting equipment.
• When wiring electrically powered
equipment, follow all electrical and safety
codes.
• Wherever possible, use a residual current
device (RCD).
• High voltage / high current power lines may
be present. Use extreme caution to avoid
contact or interference with power lines.
Electrical shock can be fatal.
General Electrical Safety
• Electrically grounded equipment must have
an approved cord and plug and be
connected to a grounded electrical outlet.
• Do NOT bypass the ON/OFF switch and
operate equipment by connecting and
disconnecting the electrical cord.
• Do NOT use equipment that has exposed
wiring, damaged switches, covers or
guards.
• Do NOT use electrical equipment in wet
conditions or in damp locations.
• Do NOT use electrical cords to lift, move or
carry equipment.
• Do NOT coil or knot electrical cords, and
ensure electrical cords are not trip hazards.
General Service Information
• The equipment must be serviced or
repaired at authorised service centres by
qualified personnel only.
• Replacement parts must be original
equipment manufacturer (OEM) to ensure
equipment safety is maintained.
• Do NOT attempt any maintenance or repair
work not described in this manual.
• After use, the equipment and components
may still be hot – allow the equipment to
cool and disconnect spark plugs and/or
electrical power sources and/or batteries
from it before adjusting, changing
accessories or performing repair or
maintenance.
• Do NOT adjust while the equipment is
running.
• Perform service related activities in suitable
conditions, such as a workshop.
• Replace worn, damaged or missing
warning/safety labels immediately.
Electric Scooter Safety
WARNING! Riding can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. The product
can and is intended to move, and it is therefore possible to lose control, fall-off and/or get into dangerous situations that no amount of care,
instruction or expertise can eliminate. If such things occur, you can be seriously injured or die, even when using safety equipment and other
precautions. RIDE AT YOUR OWN RISK AND USE COMMON SENSE.
APPROPRIATE RIDER USE AND PARENTAL SUPERVISION
• The recommended minimum rider age of 8 years is an estimate only, and can be affected by the rider’s size, weight or skills. Any rider unable to
adequately understand the controls or techniques required to ride the product should not attempt to ride it. A parent’s decision to allow his or her
child to ride this product should be based on the child’s maturity, skill and ability to follow rules.
• Rider weight does not necessarily mean a person’s size is appropriate to fit or maintain DO NOT EXCEED THE WEIGHT LIMIT OF 10 .0KGS
control of the product, moreover the ability of the product to safely support the loads placed on it due to rider weight.
ACCEPTABLE RIDING PRACTICES AND CONDITIONS
• Always check and obey any local laws or regulations which may affect the locations where the product may be used. Ride defensively. Watch out
for potential obstacles that could catch the wheels or force you to swerve suddenly or lose control. Avoid pedestrians etc who may enter your
path and respect the rights and property of others.
• The product is meant to be used on private property and on closed courses and not on public streets or pavements. Do not ride in any areas
where pedestrian or vehicle traffic is present.
• Do not activate the product unless you are in a suitable environment for safe riding.
• The product is not for indoor use.
• This product was manufactured for performance and durability but are not impervious to damage. Stunts or other aggressive riding can over-
stress and damage the product, and the rider assumes all risks associated with how the product is looked after.
• Be careful and know your limitations. Risk of injury increases as the degree of riding difficulty increases. The rider assumes all risk associated
with aggressive riding activity.
• Maintain a hold on the handlebars at all times.
• Never carry passengers or allow more than one person at a time to ride the product.
• Never use near steps, drops or bodies of water, such as swimming pools.
• Keep your fingers and other body parts away from the wheels and all other moving components.
• Never use headphones or a phone when riding.
• Never hitch the product to another vehicle or person.
• Do not ride the product in rain or wet conditions and never immerse the product in water – electrical components may be damaged by water or
create other possible unsafe conditions.
• Bumpy, slippery, uneven or rough surfaces may increase risks.
• Do not touch the brakes or electric motor when in use and/or immediately after riding as they can become very hot.
• Do not ride at night or when visibility is limited.
PROPER RIDING ATTIRE
• Always wear proper protective equipment, such as an approved safety helmet (with chin strap securely buckled), elbow and knee pads. A helmet
may be legally required by local law or regulation in your area. A long-sleeved shirt, long pants and gloves are recommended. Always wear
closed shoes (preferably lace-up shoes with rubber soles), never ride barefoot or in sandals or thongs, and keep shoelaces tied and out of the
way of the wheels, motor and drive system.
Produktspezifikationen
| Marke: | Alpha |
| Kategorie: | Rolle |
| Modell: | Carbon X |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Alpha Carbon X benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Rolle Alpha
30 August 2023
5 Juli 2023
Bedienungsanleitung Rolle
- Rolle Yamaha
- Rolle XD Enjoy
- Rolle Denver
- Rolle Sharp
- Rolle Telestar
- Rolle Nilox
- Rolle Xiaomi
- Rolle Lamax
- Rolle Prixton
- Rolle Peugeot
- Rolle Sencor
- Rolle Saro
- Rolle Kymco
- Rolle Razer
- Rolle Vermeiren
- Rolle Honda
- Rolle Aprilia
- Rolle Ducati
- Rolle SXT
- Rolle Be Cool
- Rolle Lionelo
- Rolle Batavus
- Rolle Benelli
- Rolle Keeway
- Rolle Matador
- Rolle Niu
- Rolle Sachs
- Rolle SYM
- Rolle Vespa
- Rolle Hudora
- Rolle Puky
- Rolle Kaabo
- Rolle Gilera
- Rolle Segway
- Rolle Hero
- Rolle Joyor
- Rolle TGB
- Rolle Derbi
- Rolle EVO
- Rolle INCA
- Rolle Little Tikes
- Rolle Piaggio
- Rolle E-way
- Rolle Razor
- Rolle Hyosung
- Rolle EMG
- Rolle Genuine
- Rolle Valk
- Rolle Root Industries
- Rolle InMotion
- Rolle Bintelli
- Rolle Mash
- Rolle Rolektro
- Rolle Bullet
- Rolle Hover-1
- Rolle Kugoo
- Rolle BOHLT
- Rolle Baotian
- Rolle Motus
- Rolle VR46
- Rolle Urban Glide
Neueste Bedienungsanleitung für -Kategorien-
25 Juni 2024
23 Juni 2024
10 Juni 2024
9 Juni 2024
6 Juni 2024
6 Juni 2024
6 Juni 2024
1 Juni 2024
24 Mai 2024
24 Mai 2024