Adastra RMS605 Bedienungsanleitung

Adastra Empfänger RMS605

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Adastra RMS605 (4 Seiten) in der Kategorie Empfänger. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/4

RMS605

1U 5-ZONE MIXER- PLIFIER 5 x 60W AM

Item ref: 2 953.15 UK

User Manual

Version 1 1.

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

953.152 User Manual UK

Introduction

Thank you for choosing an Adastra RMS605 5-zone mixer-amp as part of your sound system.

This 5-zone 100V power amplifier has the advantage of selectable obal or individual inputs and a paging microphone input. gl

Please read this manual to gain the best results from your product and avoid damage through misuse.

SAFETY SYMBOL AND MESSAGE CONVENTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS

RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR

This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this

unit

This symbol indicates that there are important operating and maintenance instructions in the

literature accompanying this unit.

SAFETY NOTICE

1. Prior to use, read through this manual

2. Keep the manual in good condition

3. Pay attention to safety warnings

4. Observe all operating requirements

5. Do not use the device near water or wet areas

6. For cleaning, only use a lint-free, dry cloth

7. Install according to the specifications

8. Place away from heat sources or heating appliances

9. Use mains lead provided and avoid damage to cable or connectors

10. Unplug power from mains during stormy weather or if unused for long periods

11. In case of malfunction, water ingress or other damage, consult qualified service personnel

12. Do not place in damp areas or near liquids or moisture. Do not spill liquids on the housing

13. Please pay attention to warning symbols during transit and placement

14. Terminals marked with the symbol are HAZARDOUS LIVE and should only be connected by qualified personnel

15. Ensure that the apparatus is connected to a mains socket with a protective EARTH connection

16. Ensure correct operation of the mains switch

Warning

To prevent the risk of fire or electric shock, do not expose any components to rain or moisture.

If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified personnel before

further use.

Avoid impact, extreme pressure or heavy vibration to the case

No user serviceable parts inside Do not open the case refer all servicing to qualified service personnel. – –

Safety

• Check for correct mains voltage and condition of IEC lead before connecting to power outlet

Placement

• This unit can be used free-standing or fixed into a 19” rack

• Ensure adequate support and access to controls and connectors when rack-mounting

Cleaning

• Use a soft cloth with a neutral detergent to clean the housing as required

• Do not use strong solvents for cleaning the unit

953.152 User Manual UK

Front panel

Rear panel

Connection

Ensure the wer ( ) is switched off until all input and output connections are in place. Po 11

Turn all output rotary level controls (9 fully down (anti-clockwise) to avoid loud noises when switching on. )

Set the BASS and TREBLE Tone controls (1, 2, 4, 5 to the vertical position (zero) )

Loudspeakers should be connected to the RMS605 via screw terminals on one of 2 removable modular connectors.

If the speaker(s) being connected is not 100V type, use the terminal block marked 4 for this channel (14). “ Ω”

Connect + and wires to each speaker as indicat–ed, ensuring that there is no chance of strands shorting across terminals.

Important: Ensure that the load is no lower than 4 for each output. This can be Ω …

1 x 4 1 x 16 Ω speaker Ω speaker

1 x 8 2 x 16 speakers wired in parallel (8 ) Ω speakers Ω Ω

2 x 8 (4 ) 3 x 16 speakers wired in parallel (5.3 ) Ω speakers wired in parallel Ω Ω Ω

4 x 16 speakers wired in parallel (4 ) Ω Ω

Ensure that the connected speakers can handle W from each output. 60

If the speaker(s) being connected to an output channel

are 100V type, use the terminal block marked for “100V”

this output channel. When connecting multiple 100V

speakers to this output, connect all speakers in parallel

and ensure that the total load is below 54W.

The wattage of each speaker can sometimes be

adjusted via tappings on the speaker (check the

speaker s documentation if unsure) ’

DO NOT co ect to both 4 and 100V terminals for any individual output channel nn Ω

DO NOT mix 4 and 100V speakers on any single output. Ω

THERE SHOULD BE NO CONNECTION MADE VERTICALLY ABOVE OR BELOW AN OTHER Y

BASS EQ Paging Mic input –

Power on indicator

TREBLE Paging Mic input EQ –

GAIN control Paging Mic input –

Signal indicator Paging Mic input –

LEVEL control Output channels –

BASS EQ Output channels –

10.

Status indicators Outpu–t channels

TREBLE Output channels EQ –

11.

Power on/off switch

AUX/Individual channel input switch

12.

IEC mains inlet and fuse holder

17.

Paging mic VOX sensitivity control

13.

100V speaker output terminals

18.

Paging mic balanced XLR input

14.

4 speaker output terminals Ω

19.

24V emergency mute termina ls

15.

Line level individual channel RCA inputs

20.

Line level individual channel terminal inputs

16.

Line level AUX RCA inputs

21.

Phantom power and Vox DIP switches

Produktspezifikationen

Marke:	Adastra
Kategorie:	Empfänger
Modell:	RMS605
Breite:	482 mm
Tiefe:	330 mm
Gewicht:	8170 g
Produktfarbe:	Schwarz
Übertragungstechnik:	Kabelgebunden
Höhe:	42 mm
RMS-Leistung:	60 W
AC Eingangsspannung:	100-240 V
AC Eingangsfrequenz:	50 - 60 Hz
Lautstärkeregler:	Drehregler
Audio Kanäle:	5.0 Kanäle
THD, totalklirren:	- %
Audioeingang (L, R):	5
Rauschverhältnis (SNR):	- dB
Ein-/Ausschalter:	Ja
Mikrofon-Eingang:	Ja
Verstärkerklasse:	D
XLR-Eingang:	Ja
Bass-Justage:	Ja
Lautsprecher-Konnektivitätstyp:	RCA
Leistungshöhepunkt pro Kanal:	60 W
Gewinnanpassung:	Drehregler
Line-Eingänge (RCA):	5
Sicherungsbewertung:	T2AL