Wellis Serenis Bedienungsanleitung
Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Wellis Serenis (80 Seiten) in der Kategorie Wellness. Dieser Bedienungsanleitung war fĂĽr 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/80
WS00175, WS00176, WS00177
SAUNA
Igneus, Serenis, Calidus sauna
INSTALLATION MANUAL
Igneus, Serenis, Calidus szauna
SZERELÉSI ÚTMUTATÓ
Igneus, Serenis, Calidus sauna
INSTALLATION MANUAL
Saunas Igneus, Serenis, Calidus
MANUEL D’INSTALLATION
EN
HU
DE
FR
EN Installation Guide
Please read the following directions carefully.
This type of sauna use embedded latch locking system fixed together, the installation
requires 2~3 persons. Put on gloves and pay more attention not to hurt yourself during the
installation.
Minimum ceiling height required for the installation and operation of the sauna: 230 cm.
To assure the installation smoothly and use well in future, please install each step
carefully and make sure placement and connection of each panel balanced and tightly.
Electrical Requirements
Each sauna will require an exclusive circuit when plugged in an outlet. A exclusive
circuit requires that no other appliance to share the outlet/circuit with the sauna. Failure
to comply with this requirement may cause electrical interruption and diminished
performance. The electrical connection point is always located in the right front corner of
the sauna. (Figure 12)
Before installing the sauna, it is necessary to install a cable of suitable length (taking into
account the dimensions of the sauna).
Minimum cross-section of cables:
– for 1 phase: 3x4 mm2 (in the case of 4.5 kW heating)
– for 3 phases: 5x4 mm2 (in the case of 8 and 9 kW heating)
(For 4.5 kW heaters, we provide a 40A leakage protector; for 8 and 9 kW heaters we
provide a 63A leakage protector.)
Please make sure the sauna is properly grounded. Serious injury may result if proper
electrical requirements are not met.
We recommend that you seek the assistance of a qualified electrician to wire your sauna
properly, in order to avoid electrical risks, especially regarding high-power saunas.
The sauna stove must always be placed in the corner, to the right of the glass door. Make
sure that the minimum required distances are observed (see the sauna stove instructions
or sauna stove data plate.)
Package Information
Traditional saunas (with a front panel full glass) are packed in 6 cartons (Package 1 for
top and floor panel, benches and spare parts. Package 2 for back panel. Package 3 for
left and side panel. Package 4 for glass. The extra two package stove and stone)
Each sauna has a sole serial number which was shown on each package carton of sauna
cabin. Please make sure the cartons you get are with a same serial number, so that you
can assemble the unit well.
Please make sure that when you open the package cartons keep face up. Please be very
careful when opening boxes, due to fragile parts and glass.
Where to Start
Lay the cartons flat on the ground and open them carefully.
Open all the cartons, take the floor (bottom panel) from carton A firstly, start to install your
sauna pleasantly.
Tips: Before the start of installation, or at least before installation of the top panel, please
take out the accessories and screws etc.
Caution to Installation
1. No plumbing or plumbing fixtures should be placed in the sauna.
2. Use wooden bucket and scoop splashing water and not keep excess water splashed.
3. Install the sauna on a completely level surface and keep it near the pipeline, easy
drainage.
4. Flammable objects and corrosive chemical substances should be kept far away from
the sauna.
Should you have any questions, please do not hesitate to contact the supplier.
Installation Procedure
Connecting Methods of Panels (Walls)
Our sauna rooms through embedded latch locking system fixed together. Need two
people lift wood panel and keep each latching system well connect together.
Latch locking system
Tips: Refer to “Connecting Method of Panels (walls)” on how to assemble the panels
together for the following installation procedures.
Where to Start:
Lay the First carton flat on the ground and open them carefully. Take out accessories
(handle, stove wooded protector, screws, user manual and smaller parts) from the roof
dust cover and read to installation. See below photo.
Remove the Dust Cover to uncover accessories
Dust Cover
Produktspezifikationen
| Marke: | Wellis |
| Kategorie: | Wellness |
| Modell: | Serenis |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Wellis Serenis benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Wellness Wellis
25 August 2024
25 August 2024
24 August 2024
24 August 2024
24 August 2024
23 August 2024
23 August 2024
23 August 2024
22 August 2024
22 August 2024
Bedienungsanleitung Wellness
- Wellness Intex
- Wellness Exit Toys
- Wellness Fantasy
- Wellness Gecko
- Wellness MSpa
- Wellness Netspa
- Wellness Seniotec
- Wellness Sundance
- Wellness Venice
- Wellness Watkins
- Wellness Arctic Spas
- Wellness Avenli
- Wellness Balboa
- Wellness Canadian Spa Company
Neueste Bedienungsanleitung fĂĽr -Kategorien-
17 September 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024