Vitek VTC-IRH30E-2810 Bedienungsanleitung

Vitek Nicht kategorisiert VTC-IRH30E-2810

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Vitek VTC-IRH30E-2810 (32 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/32
FEATURES:
• 1/3” Panasonic Progressive Scan CMOS Sensor
• 2.1 MegaPixel with Full 1080p/720p HD-SDI (SMPTE292M) EX-SDI Output
• 30 Dynamic Infrared LEDs at 850nm enable viewing in total darkness up to
100 feet
• Dynamic Intensity IR LEDs to reduce over saturation of IR illuminated video
without engaging the Image Signal Processor chip
• MegaPixel IR Corrected 2.8-10mm Varifocal Auto Iris Lens with External
Adjustments for Focus and Zoom
• True Day/Night by ICR - Dual Filter Switch
• Fully programmable True WDR (Dual Scan) at 30fps
• Smart Motion Zoom tracks motion, then intelligently zooms into that area of
the frame
• 3D-DNR Advanced Digital Noise Reduction
• Dual Glass Compartments to Eliminate IR Reflection
• Secondary Video Output & OSD Control Joystick are accessible inside a
gasket sealed removable side panel
• Advanced OSD Functions: Smart Motion Zoom, Focus Assist, Motion
Detection, Privacy Mask, Defog, D-Zoom(~8x), Sens-up(~x32), BLC/HLC,
Title Set, Pixel Defect Compensation, Lens Shade Compensation
• 100% Pure Digital Transmission of video data
• Up to 1000’ HD Transmission Range (Depending on cable characteristics and
integrity)
• 3-Axis mount with Simple One Turn Positioning Lock for Ease of Installation
• IP-67 Rated Water Resistance
• 12VDC / 24VAC Dual Voltage Operation
VTC-IRH30E2810
2.1MP HD-SDI / EX-SDI WDR
Bullet Camera with 30 IR LEDs
VITEK
VITEK
Safety Precaution
CAUTION: TO REDUCE THE RISK OF ELECTIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
To prevent electric shocks and risk of fire hazards, do NOT use other than
specific power source.
Warning :
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Caution :
Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Mains power quality should be that of a typical commercial environment. If the user
of the model requires continued operation during power mains interruptions, it is
recommended that the model be powered from an uninterruptible power supply
(UPS) or a battery.
The symbol is intended to alert the user to the presence of important
operating and maintenance(servicing) instructions in the literature
accompanying the unit.
The symbol is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
2
Safety Precaution
NOTICE
The image used in this instruction manual are processed to help comprehension
and may differ from actual video of the camera.
Avoid installing areas where has shock or vibration which results in the problems.
Pay attention to safety when laying the connection cable and observe that the cable
is not subjected to heavy loads, kinks or damage and no moisture can get in.
Never open the device such as boards or lens.
The warranty becomes void if repairs are undertaken by unauthorized persons.
Maintenance and repair have to be carried out only by authorized service centers.
Use only a mild detergent to clean the housing.
The camera should never be operated beyond the technical specifications.
This can lead to destruction.
The camera should never be operated in water.
3


Produktspezifikationen

Marke: Vitek
Kategorie: Nicht kategorisiert
Modell: VTC-IRH30E-2810

Brauchst du Hilfe?

Wenn Sie Hilfe mit Vitek VTC-IRH30E-2810 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Vitek

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-