Vimar 01985.120 Bedienungsanleitung

Vimar Dimmer 01985.120

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Vimar 01985.120 (1 Seiten) in der Kategorie Dimmer. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/1

Viale Vicenza, 14 - 36063 Marostica VI Italy

Tel. +39 0424 488 600 - Fax (Italia) +39 0424 488 188 - Fax (Export) +39 0424 488 709

www.vimar.com

MASTER dimmer 120 V~ 60 Hz for incandescent lamps 40-500 W electronic

transformers 40-300 VA, CFL lamps 10-200 W, LED lamps 3-200 W, for LED

electronic power supplies, protection fuse, installation on DIN rails (60715

TH35), occupies 4 modules size 17.5 mm. For nautical scope.

ON/OFF switch and adjustment with two built-in buttons. MOSFET+TRIAC microprocessor

technology, works in both LE (Leading Edge) and TE (Trailing Edge) modes. MASTER function,

protection fuse. The device receives commands directly from the Busbar and is able to control

the load directly. It can also control up to 3 SLAVE dimmers for DIN rails 01986.120.

IMPORTANT: Lamps controllable from a single master or slave dimmer must all be the

same. All controllable loads must be declared DIMMERABLE by the manufacturer. Check

the type of compatible dimmering on the lamp package: LE (Leading Edge) or TE (Trailing

Edge). If it is not specified, the lamp can operate in both modes (chosen at the discretion

of the installer).

CHARACTERISTICS.

• RatedsupplyvoltageTPBusbar:29V

• Ratedsupplyvoltagemains:120V~,60Hz

• AbsorptionfromTPBusbar:15mA

• Dissipatedpower:7.8W

• Terminals:N neutral, load, phase, L Ssynchronization,TPBusbar

• ProtectionfusetypeF5AH250V

• Functionsthatcanbeaccomplishedwiththedimmer:

- Switching on, off and dimmering

- Changing absolute brightness

- Actuating/saving scenarios

- Enabling "Flash Start" mode for CFL lamps

- "Ramp" operation

- Switch-off delay and warning function

-Phasecutting:LE/TE

• Localcontrols:

Pressingthe button enables using the local buttons. All messages from the busbar are

ignored.

- Briefly pressing the button :ONcontrol

- Briefly pressing the button :OFFcontrol

-Pressingandholdingdownthebutton :Increasebrightness

-Pressingandholdingdownthebutton :Decreasebrightness

In normal operation (that is when the commands are sent over the bus) pressing the buttons

for the outputs is ignored.

• Protectionagainstshort-circuitingwhenturningonwithflashingblow-outindicator.

• Thermalprotectionwithflashingblow-outindicator.

• MASTER-SLAVE function: paying attention not to exceed maximum power controllable by

each dimmer. A MASTER device can have up to 3 SLAVE dimmers (art. 01986.120) for a

maximumtotalload of2000W(VA)correspondingto500W/VAmax connectedtoeachof

the 4 devices.

• InstallationonDINrails(60715TH35),occupies4modulesof17.5mm.

CONFIGURATION.

FOR THE OPERATIONS OF INSTALLATION AND CONFIGURATION, SEE THE BY-ME

SYSTEM INSTRUCTIONS MANUAL ATTACHED TO THE CONTROL PANEL.

•Functionalunits:1;theunitcanbelongtoatmost4differentgroups.

• Selecting the functional unit (configuration): during group creation, when the control panel

requirespressingthedevicebutton:

-ItisrecommendedtoconfigurethedevicewiththeloadOFF;

-PresstheCONFbutton,theredLEDwilllightup;

- With the red LED on, the control panel will configure the functional unit; at the end of this

operation the red LED will go out.

Controllable loads LE TE

40 to 500 W 40 to 300 W

10 to 100 W 10 to 200 W(Max5lamps) (Max 10 lamps)

3 to 100 W 3 to 200 W(Max5lamps) (Max 10 lamps)

Electronic transformers

for halogen lamps

40 to 300 W

(Max 3 transformers type

)

40 to 300 W

(Max5transformerstype

)

Dimmering with Leading Edge mode Dimmering with Trailing Edge mode

INSTALLATION RULES.

Installation should be carried out in compliance with the current regulations regarding the instal-

lation of electrical systems in the country where the products are installed.

• Itshouldbeusedinplacesatatemperatureofbetween-5°Cand+45°C.

• Thelampsconnectedtothemasterorslavemustallbethesame.

• Notsuitableforcontrollingmotors(e.g.fans,ventilators).

•Theratedpowerlevelshouldneverbeexceeded.

• Overloading, power surges and short-circuits may irreparably damage dimmers. Before

installation check the circuit carefully and eliminate any of the above causes.

• The dimmer does not have a mechanical circuit breaker in the main circuit and so is not

galvanically separated. The circuit load should be considered always powered.

For further instructions see the manual enclosed with the control panel.

CONFORMITY TO STANDARDS.

For MARINE use,thisdevicehasbeensubmittedtothefollowingtests:

IEC60068-2-52-TestKb:Saltmist,cyclic(sodium,chloridesolution),

IEC60068-2-6-TestFc:Vibration(sinusoidal)

Thisdevicecomplieswithpart15oftheFCC Rules (with the limits for a Class B digital device).

Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference

that may cause undesidered operation.

FRONT VIEW

CONNECTIONS

MaximumlengthofcablesconnectinguniversalMASTERdimmeranduniversalSLAVEdimmer:100m

Connect at least the minimum load required to the universal master dimmer.

A:IndicatorLED

B:Switchingonandincreasingbrightness

C:Switchingoffanddecreasingbrightness

D:LEDandconfigurationbutton

CHANGING FUSE

OFF

01985.120

MASTER DIMMER

120V~

60Hz

40-50 0W LE

40-300W T E

CONF.

NLS

By-me

NLS

BUS

NLS

01986.12001985.120 01986.120

N L S

TE Flash

Soft

01986.120

SLAVE

DIMMER

40-500W LE

40-300W TE

120 V~ 60 Hz

N L S

TE Flash

Soft

01986.120

SLAVE

DIMMER

40-500W LE

40-300W TE

120 V~ 60 Hz

N L S

01985.120

MASTER DIMMER

120 V~ 60 Hz

40-500W LE

40-300W TE

Bus

MASTER SLAVE SLAVE

BUS TP

N L S

01985.120

MASTER DIMMER

120 V~ 60 Hz

40-500W LE

40-300W TE

01985.120

49400502A0011309

VIMAR - Marostica - Italy

Produktspezifikationen

Marke:	Vimar
Kategorie:	Dimmer
Modell:	01985.120

Brauchst du Hilfe?

Wenn Sie Hilfe mit Vimar 01985.120 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Ihren Namen*

Deine E-Mail*

Schreiben Sie hier Ihre Frage

Bedienungsanleitung Dimmer Vimar

Vimar 14147.SL Bedienungsanleitung

20 August 2024

Vimar 09153.CM Bedienungsanleitung

18 August 2024

Vimar 14099 Bedienungsanleitung

18 August 2024

Vimar 14135.1 Bedienungsanleitung

17 August 2024

Vimar 09135.1.120.CM Bedienungsanleitung

16 August 2024

Vimar 20139.120.B Bedienungsanleitung

16 August 2024

Vimar 14153.SL Bedienungsanleitung

16 August 2024

Vimar 09135.1 Bedienungsanleitung

15 August 2024

Vimar 14137.SL Bedienungsanleitung

15 August 2024

Vimar 20138.120 Bedienungsanleitung

15 August 2024

Bedienungsanleitung Dimmer

Neueste Bedienungsanleitung für -Kategorien-

American DJ DP-415R Bedienungsanleitung

30 September 2024

Elro HE805S Bedienungsanleitung

22 September 2024

ABB 2210UJ-214 Bedienungsanleitung

15 September 2024

DIO 54767 Bedienungsanleitung

12 September 2024

Ltech CHLSC52 Bedienungsanleitung

5 September 2024

Ltech CHLSC39TX Bedienungsanleitung

5 September 2024

Ltech CHLSC41TX Bedienungsanleitung

5 September 2024

Ltech CHLSC20TX Bedienungsanleitung

5 September 2024

Ltech CHLSC50 Bedienungsanleitung

5 September 2024

Ltech CHLSC51 Bedienungsanleitung

5 September 2024