ViewSonic PJ-WPD-200 Bedienungsanleitung

ViewSonic Videostrahl PJ-WPD-200

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für ViewSonic PJ-WPD-200 (27 Seiten) in der Kategorie Videostrahl. Dieser Bedienungsanleitung war für 26 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/27

PJ-WPD-200

Wireless Presentation Gateway

User Guide

Model No. VS15989

IMPORTANT: Please read this User Guide to obtain important information on installing

and using your product in a safe manner, as well as registering your product for future

service. Warranty information contained in this User Guide will describe your limited

coverage from ViewSonic Corporation, which is also found on our web site at http://

www.viewsonic.com in English, or in specic languages using the Regional selection

box in the upper right corner of our website. “Antes de operar su equipo lea cu

idadosamente las instrucciones en este manual”

Compliance Information

Please read before proceeding

• Use only the batteries and power adapter provided by the manufacturer. The use

of unauthorized accessories may void your warranty.

• Do not store your device in temperatures higher than 50°C (122°F).

• The operating temperature for this device is from 0°C (32°F) to 35°C (95°F).

FCC Compliance Statement

The following statement applies to all products that have received FCC approval.

Applicable products bear the FCC logo, and/or an FCC ID in the format FCC ID:

GSS-VS15989 on the product label.This device complies with part 15 of the FCC

Rules. Operation is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) This device must accept any interference

received, including interference that may cause undesired operation. This

mobiledevice has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequencyenergy

and, if not installed and used in accordance with the instructions, may cause

harmful interferenceto radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modications not expressly approved by the party responsible for

compliance could void theuser’s authority to operate the equipment.The antenna(s)

used for this transmitter must not be colocated or operating in conjunction with any

otherantenna or transmitter.

The device was tested and complies to measurement standards and procedures

specied in FCC OET Bulletin 65, Supplement C

FCC SAR Information

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. End users must follow the specic operating instructions

for satisfying RF exposure compliance.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter. This equipment should be installed and operated with a

minimum distance of 20 centimeters between the radiator and your body.

The users manual or instruction manual for an intentional or unintentional radiator

shall caution the user that changes or modications not expressly approved by

the party responsible for compliance could void the user's authority to operate the

equipment.

CE Conformity for European Countries

The device complies with the EMC Directive 2004/108/EC and Low Voltage

Directive 2006/95/EC.

Following information is only for EU-member states:

The mark shown to the right is in compliance with the Waste Electrical and

Electronic Equipment Directive 2002/96/EC (WEEE).

The mark indicates the requirement NOT to dispose the equipment as

unsorted municipal waste, but use the return and collection systems

according to local law.

If the batteries, accumulators and button cells included with this equipment,

display the chemical symbol Hg, Cd, or Pb, then it means that the battery has

a heavy metal content of more than 0.0005% Mercury, or more than 0.002%

Cadmium, or more than 0.004% Lead.

European Union Regulatory Conformance

The equipment complies with the RF Exposure Requirement 1999/519/EC, Council

Recommendation of 12 July 1999 on the limitation of exposure of the general

public to electromagnetic elds (0-300 GHz). This equipment meets the following

conformance standards: EN301489-1, EN301489-17, EN60950-1, EN300328.

We, hereby, declare that this Wi-Fi radio is in compliance with the essential

requirements and other relevant provisions of Directive 1999/5/EC.

Produktspezifikationen

Marke:	ViewSonic
Kategorie:	Videostrahl
Modell:	PJ-WPD-200
Breite:	29 mm
Tiefe:	16 mm
Gewicht:	3.7 g
Produkttyp:	WLAN USB-Adapter
Produktfarbe:	Schwarz
Höhe:	7 mm
Verpackungsbreite:	130 mm
Verpackungstiefe:	150 mm
Verpackungshöhe:	25 mm
Paketgewicht:	77.2 g
Unterstützte Sicherheitsalgorithmen:	128-bit WEP,64-bit WEP,TKIP,WPA,WPA2
Warentarifnummer (HS):	85299097
Unterstützt Windows-Betriebssysteme:	Ja
USB-Stecker:	USB Typ-A
Kompatibilität:	PJD7333, PJD7533w, PJD8333s, PJD8633ws, PLED-W800
Markenkompatibilität:	Viewsonic