Vicks V200 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Vicks V200 (18 Seiten) in der Kategorie Luftreiniger. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/18
IMPORTANT! For the most effective and safe use of your vaporizer, please READ
AND SAVE THESE INSTRUCTIONS ... especially those regarding the addition of salt
to the water. In “soft water” areas, salt must be added to water to generate steam.
In “hard water” areas, the vaporizer may operate without the addition of salt.
WARNING: KEEP OUT OF REACH OF CHILDREN
We recognize that many of our customers use vaporizers in homes with young
children. Carefully supervise your children when using a vaporizer, especially
crawling infants and toddlers. Please be sure to take the time to instruct them
that a vaporizer is not a toy....it is a serious medical device that produces hot
steam and could cause severe burns and injuries if they do not stay away from it.
Vaporizer should always be placed on a firm, flat, waterproof surface at least four feet
away from bedside and out of reach of patient and children. Be sure the vaporizer is
in a stable position and power cord is out of the way to prevent vaporizer from being
upset or tipped over. Protect floor, rug or furniture by placing the vaporizer on a
non-metallic, waterproof, heat-resistant surface.
ADDING SALT FOR STEAM FLOW: Steam output depends directly
on the mineral content of the water and the amount of salt you
add. For the vaporizer to operate in areas of low or moderate
mineral-content water, 4 TO 5 PINCHES OF SALT (1/8 teaspoon)
MUST BE ADDED TO THE WATER AND MIXED THOROUGHLY.
If an adequate steam flow is not obtained after ten minutes, add
another PINCH or two as needed, mix thoroughly. CAUTION:
Add salt only by the PINCH, since too much salt can cause
excessive boiling, a blown fuse or
tripped circuit breaker.
If you live in a “ ”hard-water area, the
vaporizer may operate well without
salt additive. The salt and other miner-
als in your water remain inside the
vaporizer and do not affect the purity
of the steam.
USE FINGER GRIPS when handling
steam unit, grasping from the rear of
outer cap. See Figure C on next page.
Do not move vaporizer while in use.
If you have any questions about
the operation of your vaporizer, call our
toll-free Consumer Service Line:
1-800-477-0457.
®
k®
Manufacturing Quality Healthcare Products for Over 75 Years
FINGER GRIPS
STEAM OUTLET
OUTER CAP
NIGHT LIGHT LENS
SAFETY VENTS
MEDICATION CUP
PROTECTIVE
HOUSING
OWNER’S MANUAL
1. UNRAVEL CORD BEFORE USE. Failure to do so could
cause overheating and possible fire hazard.
Always unplug cord from electrical outlet before
removing steam unit or when not in use. Allow
vaporizer to cool before handling.
2. FILL WATER CONTAINER. Remove steam unit.
Fill container with tap water to WATER LEVEL
MARKING on bowl. DO NOT OVERFILL. (Figure A)
Model V200 Vicks Vaporizer may also be filled
upright in large sink or bathtub. (Figure B)
3. ADD SALT. For tap water of low or moderate mineral
content, ADD 4 TO 5 PINCHES (1/8 teaspoon) of
ordinary table salt to the water and mix thoroughly.
Salt has no effect on the purity of the steam or
medication.
CAUTION: Too much salt can cause excessive
boiling or blown fuse.
4. REPLACE STEAM UNIT. Hold down steam unit for ten
seconds to allow water to enter the housing and
seat it properly in water container. If steam unit
floats, container is overfilled. (Figure C)
5. PLACE VAPORIZER IN A SAFE POSITION. Vaporizer
should always be placed on a firm, flat surface at
least four feet away from bedside and out of the
reach of patient and children. Be sure the vaporizer
is in a stable position and power cord is out of the
way to prevent vaporizer from being upset or tipped
over.
Protect floor, rug or furniture by placing the
vaporizer on a non-metallic, waterproof,
heat-resistant surface.
CAUTION: Do not direct steam flow directly at
patient, walls or furniture. You will still obtain desired
level of humidity. KEEP OUT OF THE REACH OF
CHILDREN. STEAM CAN CAUSE BURNS.
6. VAPORIZER MEDICATIONS. For best results fill the
medication cup on the steam unit (located directly
below and in front of the steam outlet) with one
tablespoon of KAZ INHALANT. (Figure D)
If you use Vicks VapoSteam®follow directions
on the VapoSteam®package. Please pay
careful attention to the added cleaning
directions in the Daily Maintenance and
Care and Cleaning sections.
NOTE: Vicks VapoSteam®should be put
directly into the vaporizer water container
(see VapoSteam®package directions); it
should not be placed in the medication cup.
7. PLUG IN. Plug power cord into 110-120
Instructions
Figure A
Figure C
Figure B (V200 only)
Figure D
k®
Inhalant
VapoSteam
7. PLUG IN. Plug power cord into 110-120
Volts AC outlet in good condition fused for
at least 15 Amps. Do not use with exten-
sion cords.
This product has a polarized plug (one blade
is wider than the other) as a safety feature.
This plug will fit into a polarized outlet only
one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. DO
NOT ATTEMPT TO DEFEAT THIS SAFETY
FEATURE.
Vaporizer will produce a gentle flow of
steam within a few minutes. If steaming
does not start within ten minutes, you
may need to add salt. Please see the
Troubleshooting checklist. The vaporizer
will automatically stop producing steam
when water has reached minimum level
(about 3/4 inch from bottom of container).
The night-light will remain on, indicating
that the vaporizer is plugged in. ALWAYS
unplug steam unit and allow to cool before
removing from water container.
Under conditions of rapid boiling and
near the end of each operation, steam may
emerge from SAFETY VENTS (above and
on both sides of the steam vent). This
condition is normal, preventing overboiling
by relieving steam pressure. (Figure E)
Do not lift or move vaporizer while
it is in use.
8. USE FRESH WATER AND MEDICATION each
time vaporizer is used.
9. AFTER EACH USE. Empty any unused water
from the water container. Shake container
gently back and forth to remove any
remaining water. Rinse container thorough-
ly, drain and wipe with a dry, clean cloth.
NOTE: All medicinal ingredients of Kaz
Inhalant are released in use, leaving only
the mineral oil base in medication cup.
This should be emptied and cleaned with
a piece of cotton.
NOTE: If you are using Vicks VapoSteam®
be sure any residue in water container
is thoroughly cleaned. Refer to Care and
Cleaning section.
IMPORTANT: To maintain proper operation
of your vaporizer, be sure to follow Care
and Cleaning Instructions.
Troubleshooting: Wh
Figure E
A.
Special Notes
Discoloration/Black Particles
After use, the water residue in the bottom
of the container may contain black particles,
and, in some areas the water and the bottom
of container may discolor. These conditions
are normal and do not affect the purity of the
steam or medication. The container is easily
cleaned with soap and water. Rinse and dry
the container after cleaning.
Ventilation
When vaporizer is used in closed or small
rooms, check periodically for proper ventila-
tion, as excessive humidity can cause con-
densation stains on walls.
Warning
KEEP OUT OF REACH OF CHILDREN.
Carefully supervise children when the vapor-
izer is operating, especially infants and tod-
dlers. Vaporizers produce hot steam that
can cause serious burns.
Condition of Sale
As a condition of sale, the purchaser
assumes responsibility for the proper care
and use of this appliance in accordance with
our printed instructions. The purchaser or
user must judge for himself or herself when
to use it and length of use.


Produktspezifikationen

Marke: Vicks
Kategorie: Luftreiniger
Modell: V200

Brauchst du Hilfe?

Wenn Sie Hilfe mit Vicks V200 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Luftreiniger Vicks

Bedienungsanleitung Luftreiniger

Neueste Bedienungsanleitung für -Kategorien-