Vemer Akuos 230 Bedienungsanleitung

Vemer Luftbefeuchter Akuos 230

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Vemer Akuos 230 (2 Seiten) in der Kategorie Luftbefeuchter. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/2
1User Manual
ELECTRONIC TOUCH SCREEN HUMIDISTATS
Read all instructions carefully
DIMENSIONS
2
4LEGEND
① “Environment humidity” Field
② “Off” Field
③ “Load activation” Field
④ Key “▼” decreases the selected field
⑤ Key “▲” increases the selected field
Attention: the keys are active only if the instrument is installed on wall-mounted base.
3WIRING DIAGRAMS
COM
NA NC
NL
230V~
Akuos 230
Akuos
COM
NA NC
COM
NA NC
Serie of wall mounting touch screen humidistats for humidity control which
perform actions of type 1B and are intended for operating in environments
Pollution Degree 2 and Overvoltage Category III (EN60730-1).
Code Model Descriptin Power supply
VE476800 Akuos 230 Bianco Wall-mounting Touch screen electronic humidistats 230 Vac
VE477600 Akuos 230 Nero Wall-mounting Touch screen electronic humidistats 230 Vac
VE791200 Akuos Bianco Wall-mounting Touch screen electronic humidistats Batteries
VE791300 Akuos Nero Wall-mounting Touch screen electronic humidistats Batteries
SAFETY WARNINGS
During product installation and operation it is necessary to observe the
following instructions:
1) The instrument must be installed by a qualified person, in strict compliance
with the connection diagrams.
2) Do not power or connect the instrument if any part of it is damaged.
3) After installation, inaccessibility to the connection terminals without appropriate
tools must be guaranteed.
4) The instrument must be installed and activated in compliance with current
electric systems standards.
5) Before accessing the connection terminals, verify that the leads are not live.
6) In the electrical system of the building where the instrument must be installed,
a switch and a protection device from the overcurrents must be present.
TECHNICAL SPECIFICATIONS
• Power supply Akuos 230:
– 230Vac (-15% - +10%) 50/60Hz
– Max absorption: 6VA/230Vac
• Power supply Akuos Batteria:
– 2 alkaline battery 1.5V (AAA type)
– Battery life: 1 year
– Battery charge level indication
• Wall mounting or to coverage three-module in built box
• Terminals Akuos 230:
– 3 terminals for 1.5 mm2 cable section for bistable output relay 5A/250Vac
– 2 terminals for 1.5 mm2 cable section for power supply
• Terminals Akuos Batteria:
– 3 terminals for 1.5 mm2 cable section for bistable output relay 5A/250Vac
• Regulation type:
– On/Off with fixed differential ±2.5% RH
–
Possibility of compensation +/- 10% RH through settable parameter
• Display of measured humidity: 10% – 90% RH
• Accuracy Measure humidity: +/- 5% RH
• Resolution Measure humidity: 1% RH
• Setable setpoint range: 30% – 90% RH
• Password protected lock keypad
• Operating temperature: 0°C – 50°C
• Storage temperature: -10°C – +65°C
• Operating humidity: 20 – 90% not condensing
• Degree og protection: IP40
• Isulation: reinforced among accessible parts (frontal) and all other terminals
V3IS00743-011
Vemer S.p.A.
I - 32032 Feltre (BL) • Via Camp Lonc, 16
e-mail: info@vemer.it - web site: www.vemer.it
Mod. AKUOS 5INSTALLATION
• Akuos series humidistats are designed for wall mounting installation. Alternatively, they can be installed to cover the three-module in built box.
• Install the humidistats at a height of about 1.5 m above the floor, away from direct sunlight, away from doors, windows, heat sources, locations with excess or total lack of
ventilation.
① Connect the wires to the terminal block
on back of the base, as shown in the
“wiring diagrams”.
② Fix the base on the wall using the
screws supplied.
③ For battery power supply model only: insert the
batteries into the battery compartment on the back
of the , respecting the indicated polarity.humidistat
④ Attach the to the base, humidistat
at first mating teeth on the higher
side.
1
1
2
information to users pursuant to art. 14 of the directive
2012/19 / EU of the european parliament and of the council
of 4 july 2012 on waste electrical and electronic equipment (WEEE)
If the crossed-out bin symbol appears on the equipment or packaging,
this means the product must not be included with other general waste
at the end of its working life.
The user must take the worn product to a sorted waste center,
or return it to the retailer when purchasing a new one.
Products for disposal can be consigned free of charge (without any new purchase obligation)
to retailers with a sales area of at least 400 m
2, if they measure less than 25 cm.
An efficient sorted waste collection for the environmentally friendly disposal of the used device, or its
subsequent recycling, helps avoid the potential negative effects on the environment and people’s health,
and encourages the re-use and/or recycling of the construction materials.
6OPERATION
Backlighting management
During normal operation the display is on and backlit with blue light (only 230V
model). If not desired the backlighting function can be disabled (for example
in bedrooms). Then the humidistat continues its standard operation and the
backlight is enabled entering menu: setpoint modification, advanced programming,
pin enter.
In battery-powered models, the blue backlighting is activated when the
programming menus are entered or if any key is pressed. In normal operating
conditions, the backlight is off (behavior cannot be changed).
3 sec.
3 sec.
Akuos
Akuos
Switch off
Note: In OFF mode it’s not possible to access the setpoint modification.
Akuos
3 sec.
3 sec.
Akuos
Error messages
Occurs in case of probe failure.
Occurs for the following values of measured humidity:
humidity < 10% RH
humidity > 90% RH
Akuos
Akuos
Reset
Unhook and re-hook the thermostat from the base (battery models) or remove
and restore power (230V models). Press simultaneously the keys during the
flashing until the display shows def
Default values
Setpoint 50% RH
Minimum settable setpoint - L0 30% RH
Maximum settable setpoint - Xi 90% RH
Password - - - (desabled)
3 sec.
Akuos Akuos
Akuos
Advanced programming
Minimum settable setpoint - L0
It’s the minimum value settable as setpoint.
Settable values: 30% RH ÷ KI
Maximum settable setpoint - KI
It’s the maximum value settable as setpoint.
Settable values: ÷ 90% RHL0
Correction of humidity measurement % RH
-
ADJ
Possibility to enter a humidity compensation value.
Available range from -10% RH to + 10% RH.
Resolution 1% RH
Password for keypad lock - PAS
Set a value between 001 and 999 to activate the
keypad lock. Set to disable the lock.“ ”---
If the keypad lock is active, pressing one key during
normal operation appears and the password is LoC
required. If it’s properly inserted the keyboard
is unlocked and stays until 30 seconds after the last
press of a key.
Possible operations:
• Limit the upper and lower settable range of the set point values
• Set a password to lock the keyboard (useful to prevent changes by unauthorized
persons)
Access to programming:
• Press and hold the and keys simultaneously until
appearsPR
• Display of the various menu items in automatic succession
after 3 seconds without any key pressure
• Use the and keys to modify the displayed parameter
values
• When programming is finished, the message , is displayed,END
the humidistat returns to normal operation, saving the changes
made
3 sec.
Akuos
Setpoint modification
Depleted batteries signal
Normal operations Modification of the desired temperature (setpoint),
to increase to decrease
Normal operation
load on ( ) Replace the batteries as soon as possible!
Dispose of the batteries in the
appropriate recycling containers.
or
19.8
19.9
... 3 sec.
3 sec.
Akuos
Akuos
3 sec.
Akuos
Akuos
3 sec.
3 sec.
Akuos
During the standard operation humidistat displays the detected humidity value and the relay status is identified by the symbol
switching on.
REFERENCE STANDARDS
Compliance with Community Directives
2014/35/EU (LVD) and 2014/30/EU (EMCD)
is declared with reference to the following harmonized standards:
• CEI EN 60730-2-13
05-2022

Produktspezifikationen

Marke: Vemer
Kategorie: Luftbefeuchter
Modell: Akuos 230

Brauchst du Hilfe?

Wenn Sie Hilfe mit Vemer Akuos 230 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Luftbefeuchter Vemer

Vemer

Vemer Akuos 230 Bedienungsanleitung

23 April 2024
Vemer

Vemer Hygros Bedienungsanleitung

19 Februar 2024
Vemer

Vemer Akuos Bedienungsanleitung

19 Februar 2024
Vemer

Vemer Humi Bedienungsanleitung

22 Oktober 2022

Bedienungsanleitung Luftbefeuchter

Neueste Bedienungsanleitung für -Kategorien-

Scarlett

Scarlett SC-985 Bedienungsanleitung

15 Oktober 2024
Steba

Steba LB 7 Bedienungsanleitung

14 Oktober 2024
Vornado

Vornado EVAP1 Bedienungsanleitung

13 Oktober 2024
Boneco

Boneco U300 Bedienungsanleitung

10 Oktober 2024
Master

Master DHA 250 Bedienungsanleitung

10 Oktober 2024
Philips

Philips HU1509 Bedienungsanleitung

8 Oktober 2024
Philips

Philips HU5710 Bedienungsanleitung

8 Oktober 2024
Adler

Adler AD 7951 Bedienungsanleitung

4 Oktober 2024
Panduit

Panduit ACF10 Bedienungsanleitung

3 Oktober 2024
Panduit

Panduit ACF11 Bedienungsanleitung

3 Oktober 2024