Tripp Lite Protect It! TLP410DMUSB Bedienungsanleitung

Tripp Lite Nicht kategorisiert Protect It! TLP410DMUSB

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Tripp Lite Protect It! TLP410DMUSB (4 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 22 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
1
Owner’s Manual
Protect It!ÂŽ
Desktop Grommet
Surge Protector with
USB Charging
3-Outlet Model: TLP310DMUSB
4-Outlet Model: TLP410DMUSB
PROTECT YOUR INVESTMENT!
Register your product for quicker service
and ultimate peace of mind.
You could also win an
ISOBAR6ULTRA surge protector—
a $100 value!
www.tripplite.com/warranty
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright Š 2016 Tripp Lite. All rights reserved. Protect It!
ÂŽ is a registered trademark of Tripp Lite.
Important Safety Instructions 2
Installation 2
Product Registration 4
Lifetime Limited Warranty 4
Ultimate Lifetime 4
Insurance Policy
16-09-096-933648-EN.indd 1 9/21/2016 5:09:21 PM
2
Important Safety Instructions
Installation
SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords
or adapters. This surge protector is designed for indoor use only. Install the surge protector away
from heat-emitting appliances such as radiators or heat registers. Do not install where excessive
moisture is present. Do not plug extension cords into it. Never install electrical, telephone,
network or coaxial wiring during a lightning storm. Do not drill into any part of the housing or
open the housing for any reason. There are no user-serviceable parts inside.
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to signicantly affect its safety
or effectiveness is not recommended. Do not use this equipment in the presence of a flammable
anesthetic mixture with air, oxygen or nitrous oxide.
1 Determine/drill the desktop hole size.
For desktops with pre-installed grommet holes, measure the hole diameter. Drill a larger hole,
if necessary. For desktops without pre-installed grommet holes, drill the appropriately sized
hole for the model.
2 Install clips.
Snap in the included clips into the two slots located on the sides of the surge protector
grommet.
2 ½” (64 mm) 2 ” (60 mm)
38
TLP310DMUSB (3-Outlet Model) TLP410DMUSB (4-Outlet Model)
16-09-096-933648-EN.indd 2 9/21/2016 5:09:23 PM
3
Installation
3 Insert the surge protector into the desktop’s grommet hole.
TLP410DMUSB model shown in illustration.
Product appearance will vary by model.
TLP310DMUSB TLP410DMUSB (3-Outlet Model) (4-Outlet Model)
4 Plug the surge protector’s power cord into a standard, 3-wire grounded 120V
AC outlet.
5 Pull the unit out of the grommet completely A, then fold the surge protector
down onto the desktop B.
A
A
B
B
6 Connect equipment to the surge protector’s AC outlets, USB charging ports
and RJ45 Ethernet port (TLP310DMUSB only).
7 When not in use, disconnect equipment, pull the surge protector up to a
straight, vertical position, then push the surge protector into the grommet
for unobstructed storage.
16-09-096-933648-EN.indd 3 9/21/2016 5:09:25 PM


Produktspezifikationen

Marke: Tripp Lite
Kategorie: Nicht kategorisiert
Modell: Protect It! TLP410DMUSB

Brauchst du Hilfe?

Wenn Sie Hilfe mit Tripp Lite Protect It! TLP410DMUSB benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Tripp Lite

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂźr -Kategorien-