Tripp Lite PDUMV15-24 Bedienungsanleitung
Tripp Lite
Steckdosenleiste
PDUMV15-24
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Tripp Lite PDUMV15-24 (16 Seiten) in der Kategorie Steckdosenleiste. Dieser Bedienungsanleitung war für 29 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/16
Owner’s Manual
1
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Metered Rack PDU
PDUMV15-24, PDUMV15-36
(Series Number: AG-00E1)
PDUMV20-24, PDUMV20-36, PDUMV20-72
(Series Number: AG-00DD)
© 2014 Tripp Lite. All rights reserved.
Important Safety Instructions 2
Installation 3
Features 4
Warranty & Product Registration 5
Español 6
Français 11
PROTECT YOUR INVESTMENT!
Register your product for quicker service
and ultimate peace of mind.
You could also win an
ISOBAR6ULTRA surge protector—
a $50 value!
www.tripplite.com/warranty
14-08-092-933381.indb 1 8/21/2014 10:27:52 AM
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed
during the installation, operation and storage of this product. Failure to
heed these instructions and warnings may affect the product warranty.
2
Important Safety Instructions
• The PDU provides the convenience of multiple outlets, but DOES NOT provide surge or line
noise protection for connected equipment.
• The PDU is designed for indoor use only, in a controlled environment, away from excess
moisture, temperature extremes, conductive contaminants, dust or direct sunlight.
• Keep indoor ambient temperature between 32°F and 122°F (0°C and 50°C).
• The PDU must be installed by a qualified technician only.
• Do not attempt to mount the PDU to an insecure or unstable surface.
• Install in accordance with National Electrical Code standards. Be sure to use the proper
overcurrent protection for the installation, in accordance with the plug/equipment rating.
• Connect the PDU to an outlet that is in accordance with your local building codes and that is
adequately protected against excess currents, short circuits and earth faults.
• The electrical outlets supplying power to the equipment should be installed near the equipment
and easily accessible.
• Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that
eliminate the connection to ground.
• Be sure to provide a local disconnect device on any models that are permanently installed
without a plug that is easily accessible.
• Never attempt to install electrical equipment during a thunderstorm.
• Individual equipment connected to the PDU should not draw more current than the individual
PDU’s outlet’s rating.
• The total load connected to the PDU must not exceed the maximum load rating for the PDU.
• Do not attempt to modify the PDU, input plugs or power cables.
• Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable
parts inside.
• Do not attempt to use the PDU if any part of it becomes damaged.
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
14-08-092-933381.indb 2 8/21/2014 10:27:52 AM
2
1B
1A
3
4
5
PDUMV15-24
and PDUMV15-36
PDUMV20-24, PDUMV20-36
and PDUMV20-72
PDUMV20-24, PDUMV20-36
and PDUMV20-72
1C
3
3
Installation
1A
Zero U Rack Configuration. Attach the two mounting
clips supplied with the PDU to the rack enclosure using
the included hardware. The mounting clips should be
attached along a vertical plane at equidistant points which
roughly correspond to the center and ends of the PDU.
The exact mounting configuration may vary depending on
the rack and enclosure. If possible, use pre-existing
mounting points within the enclosure.
1B
Wall or Under-Counter Configuration. Attach the two
mounting clips supplied with the PDU to a wall or similar
flat, secure surface using the included hardware. The
mounting clips should be attached along a vertical or
horizontal plane at equidistant points which roughly
correspond to the center and ends of the PDU. If
possible, use pre-existing mounting points. WARNING: Do
not attempt to mount the PDU with the outlets facing
downward; the mounting clips are not designed to
support the weight of the PDU in that manner.
1C
Zero U Rack Configuration. For toolless mounting:
Position the PDU as desired in the rack enclosure, align
the buttons with the rack mounting slots and slide the
PDU into position.
Note: Mounting buttons come preinstalled with select
models.
Note: Regardless of configuration, the user must
determine the fitness of hardware and procedures before
mounting. The PDU and included hardware are designed
for common rack and rack enclosure types and may not
be appropriate for all applications.
2
Attach the PDU to the mounting clips. Using an
assistant, place a rear corner of the PDU on the inside
edge of the mounting clips, pivot the PDU toward the
alternate inside edge and snap into place.
3
Attach the input plug of the PDU to a grounded
outlet. Insert the plug directly into a grounded outlet that
does not share a circuit with a heavy electrical load (such
as an air conditioner or refrigerator).
4
Attach equipment to the PDU. Do not exceed the load
rating of the PDU. The total electrical current used by the
PDU will be displayed on the digital meter in amperes.
5
Optional Installation (Models PDUMV20-24,
PDUMV20-36 and PDUMV20-72). The PDU includes an
adapter that converts the L5-20P input plug to a 5-20P
input plug. The adapter is optional; the PDU will work
properly without connecting the adapter.
14-08-092-933381.indb 3 8/21/2014 10:27:54 AM
Produktspezifikationen
| Marke: | Tripp Lite |
| Kategorie: | Steckdosenleiste |
| Modell: | PDUMV15-24 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Tripp Lite PDUMV15-24 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Steckdosenleiste Tripp Lite
22 September 2024
15 September 2024
31 August 2024
15 August 2024
11 August 2024
10 August 2024
9 August 2024
9 August 2024
8 August 2024
4 August 2024
Bedienungsanleitung Steckdosenleiste
- Steckdosenleiste Gembird
- Steckdosenleiste Hama
- Steckdosenleiste Nedis
- Steckdosenleiste Brennenstuhl
- Steckdosenleiste Eminent
- Steckdosenleiste König
- Steckdosenleiste Caliber
- Steckdosenleiste GoGEN
- Steckdosenleiste Ewent
- Steckdosenleiste Ufesa
- Steckdosenleiste Yato
- Steckdosenleiste Bachmann
- Steckdosenleiste Kopp
- Steckdosenleiste Eglo
- Steckdosenleiste HQ
- Steckdosenleiste DataVideo
- Steckdosenleiste APC
- Steckdosenleiste CyberPower
- Steckdosenleiste Ubiquiti Networks
- Steckdosenleiste Intellinet
- Steckdosenleiste Eaton
- Steckdosenleiste Sven
- Steckdosenleiste EnerGenie
- Steckdosenleiste Oregon Scientific
- Steckdosenleiste Furman
- Steckdosenleiste Steren
- Steckdosenleiste Bauhn
- Steckdosenleiste StarTech.com
- Steckdosenleiste Panduit
- Steckdosenleiste Legrand
- Steckdosenleiste ATen
- Steckdosenleiste Middle Atlantic
- Steckdosenleiste Geist
- Steckdosenleiste V7
- Steckdosenleiste Anton/Bauer
- Steckdosenleiste Salicru
- Steckdosenleiste Adam Hall
- Steckdosenleiste Panamax
- Steckdosenleiste Altronix
- Steckdosenleiste Kondator
- Steckdosenleiste Tecnoware
Neueste Bedienungsanleitung für -Kategorien-
15 Oktober 2024
15 Oktober 2024
1 Oktober 2024
29 September 2024
26 September 2024
22 September 2024
22 September 2024
20 September 2024
19 September 2024
18 September 2024