Tripp Lite PDU3XMV6G32 Bedienungsanleitung
Tripp Lite
Steckdosenleiste
PDU3XMV6G32
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Tripp Lite PDU3XMV6G32 (56 Seiten) in der Kategorie Steckdosenleiste. Dieser Bedienungsanleitung war für 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/56
1
Owner’s Manual
3-Phase Metered 0U
Power Distribution Unit
(Phase and Bank Measurements)
PDU3XMV6G32
(Series Number: AG-00BD)
Important Safety Instructions 2
Installation 3
Digital Display 5
Using the Digital Display 6
Features 12
Service 13
Warranty and 14
Product Registration
Español 15
Français 29
Русский 43
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2014 Tripp Lite. All rights reserved.
14-08-206-93338E.indb 1 10/9/2014 11:31:48 AM
2
Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during
the installation, operation, and storage of this product. Failure to heed these
instructions and warnings may affect the product warranty.
• The PDU provides the convenience of multiple outlets, but DOES NOT provide surge or line
noise protection for connected equipment.
• The PDU is designed for indoor use only, in a controlled environment, away from excess
moisture, temperature extremes, conductive contaminants, dust or direct sunlight.
• Keep indoor ambient temperature between 32°F and 122°F (0°C and 50°C).
• The PDU must be installed by a qualified technician only.
• Do not attempt to mount the PDU to an insecure or unstable surface.
• Install in accordance with National Electrical Code standards. Be sure to use the proper
overcurrent protection for the installation, in accordance with the plug/equipment rating.
• Connect the PDU to an outlet that is in accordance with your local building codes and that is
adequately protected against excess currents, short circuits and earth faults.
• The electrical outlets supplying power to the equipment should be installed near the equipment
and easily accessible.
• Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that
eliminate the connection to ground.
• Be sure to provide a local disconnect device on any models that are permanently installed
without a plug that is easily accessible.
• Never attempt to install electrical equipment during a thunderstorm.
• Individual equipment connected to the PDU should not draw more current than the individual
PDU’s outlet’s rating.
• The total load connected to the PDU must not exceed the maximum load rating for the PDU.
• Do not attempt to modify the PDU, input plugs or power cables.
• Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable
parts inside.
• Do not attempt to use the PDU if any part of it becomes damaged.
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
14-08-206-93338E.indb 2 10/9/2014 11:31:48 AM
1-5
1-1
1-6
A
B
1-5
1-2 1-3 1-4
3
Installation
Mounting the PDU
Note: The illustrations may differ somewhat from your PDU model. Regardless of configuration, the user must
determine the fitness of hardware and procedures before mounting. The PDU and included hardware are designed
for common rack and rack enclosure types and may not be appropriate for all applications. Exact mounting
configurations may vary. Screws for attaching the mounting brackets to the PDU are included. Use only the screws
supplied by the manufacturer or their exact equivalent.
Note: Mounting buttons come preinstalled to the PDU for toolless mounting.
1-1 To mount the PDU using the pre-installed
mounting buttons, position the PDU as
desired in the rack enclosure, align the
buttons with the rack mounting slots,
and slide the PDU into position.
1-2 To attach the mounting brackets to the
PDU, remove the mounting buttons.
1-3 Attach the mounting brackets to the
PDU with the included screws.
1-4 Attach the PDU to a vertical rail in
your rack or rack enclosure. (Use the
mounting hardware that came with your
rack or rack enclosure to attach the
mounting brackets to the rail.)
1-5 To reinstall the mounting buttons for
toolless mounting, remove the mounting
brackets then install the mounting
buttons onto the PDU.
Note: Be sure to insert the 2 buttons into either
the upper hole at of the PDU or into each end
the lower hole at of the PDU.each end
1-6 To install the PDU with its outlets facing
the rear of the rack, use the included
PDUMVROTATEBRKT accessory. First,
attach the mounting button A to the
V-shaped bracket B using the included
screw and washer. Then, use the
button-mount slot to attach the bracket
to the PDU and the mounting button to
attach the PDU to the rack. The bracket
effectively repositions the mounting
brackets allowing for the PDU outlets to
face the rear of the rack.
14-08-206-93338E.indb 3 10/9/2014 11:31:50 AM
Produktspezifikationen
| Marke: | Tripp Lite |
| Kategorie: | Steckdosenleiste |
| Modell: | PDU3XMV6G32 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Tripp Lite PDU3XMV6G32 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Steckdosenleiste Tripp Lite
22 September 2024
15 September 2024
31 August 2024
15 August 2024
11 August 2024
10 August 2024
9 August 2024
9 August 2024
8 August 2024
4 August 2024
Bedienungsanleitung Steckdosenleiste
- Steckdosenleiste Gembird
- Steckdosenleiste Hama
- Steckdosenleiste Nedis
- Steckdosenleiste Brennenstuhl
- Steckdosenleiste Eminent
- Steckdosenleiste König
- Steckdosenleiste Caliber
- Steckdosenleiste GoGEN
- Steckdosenleiste Ewent
- Steckdosenleiste Ufesa
- Steckdosenleiste Yato
- Steckdosenleiste Bachmann
- Steckdosenleiste Kopp
- Steckdosenleiste Eglo
- Steckdosenleiste HQ
- Steckdosenleiste DataVideo
- Steckdosenleiste APC
- Steckdosenleiste CyberPower
- Steckdosenleiste Ubiquiti Networks
- Steckdosenleiste Intellinet
- Steckdosenleiste Eaton
- Steckdosenleiste Sven
- Steckdosenleiste EnerGenie
- Steckdosenleiste Oregon Scientific
- Steckdosenleiste Furman
- Steckdosenleiste Steren
- Steckdosenleiste Bauhn
- Steckdosenleiste StarTech.com
- Steckdosenleiste Panduit
- Steckdosenleiste Legrand
- Steckdosenleiste ATen
- Steckdosenleiste Middle Atlantic
- Steckdosenleiste Geist
- Steckdosenleiste V7
- Steckdosenleiste Anton/Bauer
- Steckdosenleiste Salicru
- Steckdosenleiste Adam Hall
- Steckdosenleiste Panamax
- Steckdosenleiste Altronix
- Steckdosenleiste Kondator
- Steckdosenleiste Tecnoware
Neueste Bedienungsanleitung für -Kategorien-
15 Oktober 2024
15 Oktober 2024
1 Oktober 2024
29 September 2024
26 September 2024
22 September 2024
22 September 2024
20 September 2024
19 September 2024
18 September 2024